Hi all
Just picked up an Atoto A6 Pro for my 2014 CRV Touring.
Everything is wired correctly and I popped the unit in.
I am experiencing an issue where the device will not power cycle unless I press the power buttons on the unit itself.
No wake on ignition and it does not turn off with the key removed either.
I verified power is properly reaching the unit with a multimeter (checked ignition power and constant power).
And now I have tried reversing accessory/ignition power on the radio harness. Now the unit will turn on/off with ignition BUT it does not seem to receive any power when ignition is off. Causing it to lose stored time, and to slowly reboot each time the ignition is turned on.
Does anyone have any experience with this?
thanks
Related
Hi,
I'm testing the unit at the moment at home before I put it in the car.
I wanted to know what's the power consumption is when ACC is off. Joying says it's 11 mAmp.
The unit goes in a sort of sleep mode than, when I switch on ACC again after 30 min it takes about 3 seconds to wake up.
I have no CanBus.
I connected my multimeter between the Constant B+ wire to see how much power the unit takes when I should leave the car.
When I set the multimeter at 20 Milliamperes it displays 00.59 .
My question is, how many milliamperes is this ?
Thanks .
Hello
I recently purchased the PR78OLO-s and i love it. Thank you for such a beautiful product.
I have used it for a few days and i have run into a small issue.
Sometimes the unit will not start on power on. Even holding the power doesn't work.
>
I will have to unplug the iso cable and plug it again then it will work.
Why does it do that?
Xtron tells me to Cut the ACC cable from the canbus and use the ACC cable from the ISO instead, and connect that to the positive end on the cigarette plug.
But in my head i think that sound weird. It works fine for a day or two. Then all of a sudden it won't turn on at ignition. Have to unplug the ISO and plug again.
I've recently purchased a Ford specific xtrons head unit which can with all leads and canbus box! However the unit does not power on and off when the key is inserted and will randomly power off while driving! Also the lights on the head unit do not switch on when I turn on my lights and the screen also doesn't dim! Any help would be much appreciated thanks
My unit will not power up
My backup camera turns unit on and works
And my Bluetooth phone turns it on and works
But can’t adjust nothing no buttons work
Long story short, I just bought a 10.25" Android HU used for my BMW F20 but the owner didn't give me the power harness. Seller disappeared so I needed to figure out what unit it was in order to try source the harness.
I had read in BMW forum that the unit can be turned on with a 12V power supply connected to 2 pins on the back but when I did that, nothing happened. I could see a red led on the board turn on, stay on for about 10 sec, then turn off.
I had tried to hold the reset button when power on but it's still the same. I had noticed that when I pressed the reset button, the red led turn off, then turn back on.
Did I fried the screen or did I buy a brick? Thanks a lot!