Hello Everybody, i need some help :s
After i install Cm11 nightly 13012014 i try the new feauture that was ported to CM11, the 2 touch to zoom, ( don´t know the name) , is located in acessibility.
I try once, but then my phone stopped, and now the touch don´t work, the button works fine, i can receive sms/calls, everything, only the touch don´t work, i can even unlock the device and reinstall the phone. now what ? :s
I was hopping to let the battery end so then i install the ROM again, but i´m afraid that the touch don´t work on recovery too. ( my recovery is the touch one)
I was about to try with nexus toolkit, that is necessary have the phone in debug mode, thing i don´t have :s
Can someone know how to help me ?
HugoSilva said:
Hello Everybody, i need some help :s
After i install Cm11 nightly 13012014 i try the new feauture that was ported to CM11, the 2 touch to zoom, ( don´t know the name) , is located in acessibility.
I try once, but then my phone stopped, and now the touch don´t work, the button works fine, i can receive sms/calls, everything, only the touch don´t work, i can even unlock the device and reinstall the phone. now what ? :s
I was hopping to let the battery end so then i install the ROM again, but i´m afraid that the touch don´t work on recovery too. ( my recovery is the touch one)
I was about to try with nexus toolkit, that is necessary have the phone in debug mode, thing i don´t have :s
Can someone know how to help me ?
Click to expand...
Click to collapse
Forget guys, already fix it, if anybody have this problem, just hold the power button until the phone restarts
Related
Hello,
I have a problem right now ,I have a HTC p3450 .. I've updated the Rom !
Now the device does not work at all ( Power + Soft reset + Bootloader ) does not work and also i can not charge the battery and Activesync synchronization with your pc.
I wish the assistance of all
Best regards,
Eslam
plz help me quickly !
Which was that ROM you tried updating?, at the end of updating did it display that it was installed properly into your device?. Have you properly tried going through the Tri-colour screen?
i have the same problem.
i dis the ELF_USPL after finished i turned off my pfhone and now when i try to turn it on my the light of my screen turns on and the it goes off active sync can`t connect anymore to my phone can somebody help me please?
ivanmatz said:
Which was that ROM you tried updating?, at the end of updating did it display that it was installed properly into your device?. Have you properly tried going through the Tri-colour screen?
Click to expand...
Click to collapse
Rom : HardSpl_WM6
Yes bootloader ( colour screen ) appeared from the beginning and the update was successful, but now the device does not work at all.
Thanks,
vraj
I have a problem right now ,I have a HTC p3450 .. I've updated the Rom !
Now the device does not work at all ( Power + Soft reset + Bootloader ) does not work and also i can not charge the battery and Activesync synchronization with your pc.
Yeaa!!! Meee Toooo
Im Having the same problem, please sombody help us!!!!
I don't think you guys have CID unlocked you'r device.?
Hey guys ! I just have a big problem ... i have so many Hard-reseted my device that the Volume Down Button don't work anymore ...
I Flashed Blackstonehenge 4.4 (like always ^^), It worked fine, like always but this time 1 week after my htc is stuck at the boot screen i can't even get a way to boot it, i can't make a hard reset or even enter in Bootloader mode -_-
Please i really need your help
Sorry if i have a bad english -_-
Nobody really know a way to do the trick ?
Have you tried to dismantle the back-case? If you actually damaged the button inside the phone, I guess the only way is change the damaged part...
Hi
Plssssss Help me. i'm using HTC touch 3450 and i have upgraded my device with wm6.1
NOW THE PROBLEM IS...
1. MY DEVICE BUTTONS(HARD KEYS) NOT WORKING BUT I CAN MAKE THE DEVICE IN BOOTLOADER (TRICOLOR) MODE BY PRESSING CAMERA + POWER BUTTON.
2. AFTER INSTALLING A ROM WHENEVER MY DEVICE STARTS IT SHOWS THE HARD RESET SCREEN (BLACK SCREEN........... ALL THE DATA ...BLAH BLAB......)
I HAVE TO REMOVE THE BATTERY AND START THE DEVICE AFTER 30 MINS.) PLEASE NEED THE SOLUTION ......
3. I AM TRAYING THIS FOR A MONTH BUT NOTHING HAPPENS
PLZ GUYS HELP MEEEEEEEEEEEE OTHERWISE I'LL BE CRAZY!!!!!
rupesh baviskar said:
Hi
Plssssss Help me. i'm using HTC touch 3450 and i have upgraded my device with wm6.1
NOW THE PROBLEM IS...
1. MY DEVICE BUTTONS(HARD KEYS) NOT WORKING BUT I CAN MAKE THE DEVICE IN BOOTLOADER (TRICOLOR) MODE BY PRESSING CAMERA + POWER BUTTON.
2. AFTER INSTALLING A ROM WHENEVER MY DEVICE STARTS IT SHOWS THE HARD RESET SCREEN (BLACK SCREEN........... ALL THE DATA ...BLAH BLAB......)
I HAVE TO REMOVE THE BATTERY AND START THE DEVICE AFTER 30 MINS.) PLEASE NEED THE SOLUTION ......
3. I AM TRAYING THIS FOR A MONTH BUT NOTHING HAPPENS
PLZ GUYS HELP MEEEEEEEEEEEE OTHERWISE I'LL BE CRAZY!!!!!
Click to expand...
Click to collapse
hi
if u can get ur tricolor screen then try this
connect the usb cable to pc and see if u get the USB words on the phone tricolor screen if so good try flashing any official ROM the same happened to my phone long back did the above got my phone back asuming u have done HSPL for ur phone if u have not done that then the only way is to take it to service
hope it helps good luck
thanks
hari
Wrong forum.. Touch P3450 is not a touch 3g , its the original touch (ELF version)
but i will try and help as i have owned both.
if your hardware buttons are not working it could be possible that your send and end keys are stuck down as this key combo brings up the hard reset you are talking about.
think you are going to have to open it as it sounds like a hardware fault, and if you cannot get into bootloader you cannot flash
if it was working alright before this is not the case, but either way you will have to fix your camera button and get into bootloader
Hey,
i have a problem with my htc Trinity.
I installed a fine ROM of Windows Mobile 6.5 a few month ago.
I was a bloody nooby, but somehow it works till now.
Now my PDA just gives me a blackscreen when starting it. The backlight of the LCD is on ...but nothing more.
I tried to do a hard reset and the display shows "Press SEND to restore factory default, press END to quit" ... so gerneraly the display should be fine...
But when i try to start the bootloader with camera and power button nothing happen
I cant connect via USB... widows doesnt find any devices.
Pleade help me.. i used the search but didnt find anything helpfull
Im just a newbie
Greetings Cominus
P.S : Sorry for my bad englisch
Hello all good people. My screen suddenly stoped working.. hardware buttons works fine but thats not enough on this phone.
I still have guaranty fortunately But with hardspl, CWM and a android nandrom installed i dont dear to send it in.. is there a way to remove everything? I mean so it will pass the most strickted serviceguy..
Hope anybody can help me and yes.. i've searched a lot for this solution with no luck :/
J.R.E said:
Hello all good people. My screen suddenly stoped working.. hardware buttons works fine but thats not enough on this phone.
I still have guaranty fortunately But with hardspl, CWM and a android nandrom installed i dont dear to send it in.. is there a way to remove everything? I mean so it will pass the most strickted serviceguy..
Hope anybody can help me and yes.. i've searched a lot for this solution with no luck :/
Click to expand...
Click to collapse
Download the stock Windows Mobile ROM for your particular device (TMOUS, Telestra, etc.) and rename the ruu_signed.nbh to LEO_IMG.nbh and put it on an sd card of 4gb or less. Put the sd card in your HD2 and power it on while holding the volume down (vol -) button the entire time it's starting until you enter into bootloader (tri-color screen). The leo_img.nbh should be detected shortly and then you will be prompted to press a certain button to flash the new ROM. Once it's done, you will have stock WM 6.5 and the stock bootloader back on your phone, ready to ship off for repairs.
Just make sure and find the correct stock ROM for your device, or you will be sorry. If you flash a EU ROM to a TMOUS HD2 for example, it will brick the device. Look in the HD2 Windows Mobile 6.5 stickies and you will surely find a link to stock ROMs to download.
Thank you Mr. huggs u made my night
No problem, glad I could help