Hi
About a week ago i watched your video tutorial which explained how to deassemplby my HTC hd2 mobile. I USED THIS VIDEO HERE :
pocketnow.com/hardware-1/official-htc-hd2-disassembly-assembly-training-videos-leaked
I only desmounted the back part, in order to change the chassis of the back of the phone which got worn with time.
Everything went smotthly it was simple enough HOWEVER as soon as i put the new chassis on its place and everything in order something bad happened:
my mobile stooped to ring, vibrate and the side button whcih regualates volume, doesn't work either.
Now it's not like i desconnected anything inside so i don't really understand what could have happened.
Can you help me here?
Which part of the motherboard would make those work?
Is there anything in particular i sould check? Maybe some connection got loose, but i dont' really know where i should look...
please give me a hand i'm really desperate
thank you very much
Related
Hi Guys!
My TyTn is acting strangely. In use, the display is first pixelating, getting lines (noise pixels as well), and then fading to completely white. When so it doesn't responde to anything anymore. So a soft reset is needed.....
Also the ringtone when called, is 'out of tune', like a old record player when you push your finger on the record.. LOL
Before I send it back to have it fixed by HTC, do you guys have any idea whats wrong, and maybe even a tip to help me fix this myself?
Tried numerous soft resets, hard reset, and a reinstall of the original WM6 rom (in Dutch).
Did not install any new programs lately, or did change anything on the unit...
Don't want to miss my TyTn... so hate to send it away... as many of you I am hooked badly to my beloved digital companion
Greetzz Antal
It acts like hardware incompatible.
How about flashing with WM6 English version.
I don't think it is software problem.
I agree, not likely to be software. It did not get dropped or take a knock did it?
The two issues of pixelation/white screen may, if you are lucky, just be a connector thats loose. The sound I think is unrelated but again sounds like a poor connection at the white rear speaker connector block - not uncommon.
Both of the above could be caused by a sharp knock. There have also been cases of poor battery connections causing problems.
If you have a warranty use it. If not you can follow the dismantling guides or service manual to dismantle - check connections and re-assemble. Be prepared though, that sending it in might still be required!!
Mike
Will send it in
Hi Guys, Thanks fr your replies.
I will take the unit back to the store today.
I am not aware that I bumped it, or neither it has dropped. May be a connection that was allready quite loose to begin with. Lets see what HTC and the store will tell me
Strange thing is, that without my sim in it, and not using it, it stays normal... Have put it aside, and used a very old phone instead, and it is still normal..
Antal said:
Strange thing is, that without my sim in it, and not using it, it stays normal... Have put it aside, and used a very old phone instead, and it is still normal..
Click to expand...
Click to collapse
Mmmm... that's important information and changes things a bit. Could be a sim card contact or something about the sim. Anyway it tends to suggest that other thoughts about hardware issues may not be correct!
Hope you find the answer at the store.
Mike
Hello all!
First, thanks for an awesome forum! It has both helped me tweak my Wizard, and also get help when I have needed it.
Well, I have no choice now but to ask here. Last autumn, my warranty was almost up, and a wierd problem presented itself. The mic and speaker suddenly just stopped working! The sidespeakers still work, I think, because the phone rings when someone calls me. But the caller can't hear me, and I can't hear the caller. And there isn't a hint of sound in it, no static or noise, there simply is nothing.
As there were only a few days before the 2 year warranty was up, I ran to my dealer and turned it in. A few weeks later, the phone returned, working again. But now that I come to think about it, I don't remember if I got a replacement or if they actually repaired it... It looked a little like they handled it rough though, maybe it was another phone... Well, that's not important right now.
The same thing has happened again! Summary:
1. Mic & phonespeaker dead
2. Stereo speakers work under certain conditions
3. Wired headset that came with the phone works, both for calling and media
So it seems like a hardware problem. Please note, although I downgraded the phone to original, official Swedish Qtek 9100 ROM, it has been thoroughly tweaked and upgraded to a number of different WM6 ROMs - but all that has been working beatifully!
Still, what are the odds for the mic&speaker dying twice in a row, on different phones (i think the present one is a replacement)?!?
Question: Does anyone recognize this? Is there a possibility that it is software related, and maybe fixable? I have searched both the web and these forums but haven't really found any information on it.
ANY input would be greatly appreciated!
Additional information:
Qtek 9100 (Swedish), G3 model, WM6 upgrade successful (unlocked)
EDIT: There are no system sounds, which is wierd, because the phone can still ring. I thought the system sounds came from the stereo speakers on the sides of the device?
Hello all!
It is a glorious day to be alive!!! Or to have a fully functional Wizard, at least!
Lol - my topic isn't very old, and i reply to it myself with a solution (?). I Googled after the Wizard service manual, and found it right here on Xda .
In all honesty, i didn't do all that much. I just followed the disassembly instructions of the wizard about half-way through, to the point where you get down to the back of the motherboard. I poked and fiddled enough to locate the mic assembly, only to discover that the mic is soldered to the mainboard of the phone. So, i figured i'd just leave it be, because if the mic is really broken the motherboard needs to be repleaced, or a replacement mic needs to be soldered on there.
After removing A LOT of dust in there (honestly, i think the service center that had my device last time wasn't very careful with anything, even a screw was missing! ), i reassembled it. The flat cable running to the keyboard was also a little skewed, but that may have been me, anyway i corrected it too. Same with the speakers.
Long story short, after successfully reassmbling the phone, i fired it up, called my home phone and voila! I works!
Not much of a fix, as i don't really know what i did exactly, but dust, dirt and some bad connections/soldering may have benn the culprit.
All in all, i'm very pleased with my afternoon here. Thanks for stopping by .
epatnor said:
Hello all!
It is a glorious day to be alive!!! Or to have a fully functional Wizard, at least!
Lol - my topic isn't very old, and i reply to it myself with a solution (?). I Googled after the Wizard service manual, and found it right here on Xda .
In all honesty, i didn't do all that much. I just followed the disassembly instructions of the wizard about half-way through, to the point where you get down to the back of the motherboard. I poked and fiddled enough to locate the mic assembly, only to discover that the mic is soldered to the mainboard of the phone. So, i figured i'd just leave it be, because if the mic is really broken the motherboard needs to be repleaced, or a replacement mic needs to be soldered on there.
After removing A LOT of dust in there (honestly, i think the service center that had my device last time wasn't very careful with anything, even a screw was missing! ), i reassembled it. The flat cable running to the keyboard was also a little skewed, but that may have been me, anyway i corrected it too. Same with the speakers.
Long story short, after successfully reassmbling the phone, i fired it up, called my home phone and voila! I works!
Not much of a fix, as i don't really know what i did exactly, but dust, dirt and some bad connections/soldering may have benn the culprit.
All in all, i'm very pleased with my afternoon here. Thanks for stopping by .
Click to expand...
Click to collapse
hi epatnor,
I think the problem with your phone was a stucked microswitch in the 2,5 mm connector for the headset. I read about it here in the forum. Sometimes the switch stays in the closed position and the phone still thinks the headset is connected. Thats why all the sound is sent to the not connected headset and therefor your phone seems to be not working (unless you connect the headset)...
But removing the dust is for sure not a bad thing...
For the next time: I think there was an easier solution for this problem than disassembling your phone...
regards
huibuh_1
Thanks huibuh_1,
Yes this was probably not the smoothest way of "fixing" it. That said, the stucked microswitch theory would actually fit my problem well - I can see now that the exact problem I was having would arise if such a switch was indeed stuck.
However, I think that the problem would be more intermittent since I actually use that port now and then - especially since it's the only way to talk (besides using a bluetooth headset that is). And since I connect the wired headset now and again the switch is used and moved, I suspect that this would result in the speaker/mic coming online again maybe..? Temporarily at least?
All the same, thanks for replying - this might happen again and with your information I'm better prepared for it!
hello i used wm 6.1 and suddenly the sound and speaker are not working
when i call some one i don't hear him and i don't hear any music.
i tried to downgrade to wm5 and to change the radio to 2.19.21
nothing....
what do i do?
thank u
Moran
Plz tell me how u even get wm 6 workin on your s200.. it seems impossible 4 me....
Im trieing now for 4 hours but it still doesnt works
Cann u add me on msn?? [email protected]
speaker
think your speaker is broken. can you play other sounds? like a mp3
Your problem isn't a software one, most likely it's a hardware issue.
Check this.
http://forum.xda-developers.com/showthread.php?t=297871&highlight=jack
Read it until the end and you'll understand a little better your audio problems and what is causing it...
Regards,
Keeper
jversloot said:
Plz tell me how u even get wm 6 workin on your s200.. it seems impossible 4 me....
Im trieing now for 4 hours but it still doesnt works
Cann u add me on msn?? [email protected]
Click to expand...
Click to collapse
Let me help you I had the same problem it was hardware not software but I fixed by applying pressure to the phone speakers uses a small peace of paper and leave the paper in to apply pressure it will trust me ok
Hi, same happened to me too, flashed a new rom and suddenly no sound, flashed another still nothing. It was the hardware problem described earlier, I cut a small peice of cloth to apply pressure to the speaker now works fine.
The rom flashing and sound stopping must have just been a coincidence.
guys,
the prophets speaker is very thin. whilst applying pressure will work short term (it did for me for a month or so) it will eventually fail.
Whislt it still works, search ebay and for about £5 or $8 you can buy a new one along with tools to remove the casing properly. It took me twenty minutes to do the whole thing... search google for how to remove the casing, you can find it easily.
The only thing you have to take care is when removing the back cover is to use tweezers to unplug the speak cable from the main board oryou may damage the socket.
But dont stress its quite easy and im no brain surgeon
Hey guys always love this forum and love my WIZARD!! That is why i am sorta concerned atm and need your guys help!!
I went on a hiking trip recently and got cought in a thunder cloud and was completely soaked and os was my wizard ;-( . Well now it is acting really wierd?! As soonm as i turn it on the green light (the one on the left at the top next to the earpiece) comes on and stays on for as long as the phone is on??!!and then it gets wierder sometimes when i put the phone on the screen does not respond to taps?? but other times the screen works fine but the buttons are unresponsive?! Please would someone help me i love my wizard and really really dont want to lose it?!
Amishra
.
if i were you i would disassembly the phone and with a toothbrush clean the circuit board(s),leave it like that (disassambled) for 2-3 hours , then reassembly it. as simple as it seems this kind of "repairing" worked for me a couple of times.
ps. there are manuals on the web on how to disassembly the phone.
thanks nesicondruct i will do just that!! after i have done it i will post back and hopefully that will be the last of that!!
Hello Everyone
I have an Acer S200 and I ended up cracking the digitizer and lost the use of the entire display. Not sure how. It was in my pocket.
I purchased a replacement on ebay and replaced it. The screen works just as new. How ever I seem to have done something to the earpiece and mic.
When making a call, the earpiece is silent and the no one can hear me. However if I turn the speaker phone on I can have a complete 2 way conversation.
I originally thought it was my ROM however I have tried a few and finally placed the official one on, no luck.
I have taken the phone apart and put it back together a couple times, making sure that all peices are tight.
I am at a loss
Any suggestions will be appreciated
Thanks
Solved
I was able to solve this issue. It was prevoiusly posted. I did search however I was entering the wrong perameters. Anyways...
The solution is here...
Was not able to post URL...
You can do a search for "Speaker problem"
Regards
Hi i have to change the digitalizer,is it hard?Do i have to unscrew the back screws?Can you give me a little of instruction?I have a good pratice to disassembly phones,but maybe you can give me some tips
ACsurge said:
Hello Everyone
I have an Acer S200 and I ended up cracking the digitizer and lost the use of the entire display. Not sure how. It was in my pocket.
I purchased a replacement on ebay and replaced it. The screen works just as new. How ever I seem to have done something to the earpiece and mic.
When making a call, the earpiece is silent and the no one can hear me. However if I turn the speaker phone on I can have a complete 2 way conversation.
I originally thought it was my ROM however I have tried a few and finally placed the official one on, no luck.
I have taken the phone apart and put it back together a couple times, making sure that all peices are tight.
I am at a loss
Any suggestions will be appreciated
Thanks
Click to expand...
Click to collapse
i got my s200's screen leaked by itself without no pound by anythingelse.
in hong kong there's a nickname of acer's phone - the king of cracked mon.
the agent had my phone's mon changed twice, and i really worry the coming of the third becasue the agent will charge me.