Hello all!
I need urgent help with my T-Mobile MDA Vario I (Wizard 200) G4 (2006):
I wanted to upgrade to WM6 and used Hard SPL to do that. Read all the tutorials.
After applying Hard SPL the boot screen read:
IPL: 2.21.0001
SPL: 2.21.Olip
GSM: 02.19.11
OS: 2.24.2.5
Then I flashed the ROM with "RUU_WM6_XB_FUSION" .....
Result: At reboot it hang in the old T-Mobile boot screen stating:
the above IPL and SPL but
GSM: 02.47.21
OS: 10.0.0.0
The only thing I can do now is:
go into boot loader mode by pressing camera and stylus
and reflash it with the same RUU: it still hangs....
Not possible to reconnect to Active Sync anymore so cannot remove Hard SPL to go back to original OS with Soft SPL....
SO WHAT NOW???? Please Help, I am at a loss, just bought it...
you need to install a non official windows mobile 5 rom that doesnt have spl / ipl built into them (ex: wizard love rom) google it.
Brought back to life!
Many thanks: I did what you suggested and it's back amongst the living!
Now I need a stable G4 proof WM6 RUU....any suggestions???
fhjmgb72
Related
Hi everybody,
I have upgrade my prophet to the last Original Shipped ROM Version (RUU_Prophet_220734_2207114_024721_NVID)
Before upgrading to this ROM everthing was perfect,and quick start. I had:
IPL/SPL 2.15.0001
Radio Rom 2.47.21
But now when I reestart the prophet it takes about 5 min to load the operating sistem.
and it stop at the splas screen and it appears:
IPL/SPL 2.20.0001
Radio Rom 2.69.21
What Can I do to fix it up?
Thank you so much
My problem is, my htc touch elfin? (mda touch elf0300) stuck in bootloader-mode. Is there any Solution to get it working ?.
IPL : 2.26.0002
SPL: 2.26.0000
ELF0300
After 2 % crashed the rom update. I can´t the uspl until again because, the device wont connects to active sync.
Need Help
Thank you
.
i have same problem too, but
IPL 1.16.0002 and SPL 1.16.0000
I also have this problem
IPL 1.16.0002
SPL 1.16.0000
Stuck on bootloader screen none of the usual reset options seem to work and doesn't show up when plugged in to usb port
Help
Thanks Si
Dear All,
Please urgent help required.
my HTC P3300 (Artemis) stuck up when i was trying to start it up. when i use to turn my cell on, i goes to the starting screen shows the following numbers and then stuck up.
IPL 3.07.0001
SPL 3.07.0000
GSM 02.69.90
OS 3.7.0.0
the screen does not move after that. i tried soft reset through the reset button but result is the same.
i also tried hard reset and when i puch the green phone button to proceed, a message come "FORMAT FAILED" and the phone stucks up.
i am quite a lot of problems since i have upgraded to WM6 from WM5 last week.
i am quite sucked with this problem. not been able to use my set since yesterday.
please also note that my HTC was not syncing with my PC since i have upgraded to WM6.
PLEASE HELP URGENTLY.
Nomi
You can tried to reload your last ROM (WM6), for this :
-Start in bootloader mode ("Voice Command" + "Power" + Reset with Stylus)
-Start a new upgrade Rom (With the last ROM)
It's works ?
If yes, you can upgrade Radio and SPL.
i did that but the flash process stopped at 3% (i think CID locking problem). i tried USPL but the process could not be done. i also dont have my previous ROM but i noted the previous numbers which are
IPL 1.14.0001
SPL 1.14.0000
GSM 2.67.90
OS 1.14.0.0
tell me what to do now??
i dont have my previous ROM. nor i know what were the factory provided ROM
please help
You can :
-Flash your original ROM (Operator and langage)
-USPL and 1.11.cmon (verify that your phone is USPL before another action)
-Upgrade your new ROM.
i dont have the original ROM.
the phone is stuck at boot page. USPL not working.
what to do now
You must to download a rom from the Same Operator and same location.
Devices
This is a patch for HTC Artemis devices (HTC P3300 / T-Mobile MDA compact III / O2 XDA Orbit / Dopod P800W / Dopod P800 / Dopod M700 / Orange SPV M650).
Definition
IPL: Initial Program Loader
SPL: Second Program Loader (System Programing Language does not make any sense)
IPL Trigger SPL and then SPL activate the OS
Disclaimer:
This is free to use but at your own risk, I take no responsibility for any conflict, fault, or damage caused to your phone by this patch/unlocking procedure. No warranties of any kind are given. Any commercial usage prohibited.
************************
Patch IPL (For phone already USPL) :
IPL for G3 or G4
Instructions :
1. Unzip
2. Connect your phone to computer, make sure activesync is enabled (green icon)
3. Use ROMUpdateUtility.exe
Why
Just have the on of the last IPL
************************
Patch IPL & SPL :
IPL for G3 or G4
SPL : 1.11.cmon
This means you can flash ANY ROM to your Artemis after flashing USPL on it, no need to pay for CID unlock anymore!
Instructions:
1. Unzip
2. Connect your phone to computer, make sure activesync is enabled (green icon)
3. Run start_uspl.exe on your computer and wait until process finishes
4. See USPL Thread for more information
Why
You can upgrade IPL and USPL your phone.
************************
Thanks to:
cmonex, Shady313 and pof
Thank for an update IPL.
Thanks very much!
as above, it has
IPL 2.26
SPL 2.26
GSM 02.25.11
OS 10.1.0.811
i tried soft resetting but still the same problem, is it bricked??
please help
Your phone is not bricked.
Try hard resetting the phone if that don’t work install the original ROM and start over.[FONT="][/FONT]