whenever i adjust my hd's touchscreen it takes at least 5-10 tries until it works. whatever i do and how exact i push on the adjustment-points with the stylus, after the last one it returns back to the beginning (the middle point) no matter if i do it after a hard-reset or from the system-configuration.
im asking if this is normal or i do have a buggy touch hd?
Related
my Hd2 recently broke, it had a lot of things wrong with it.. 7 in total if you interested you can read the faults bottom of the post, im interest to know if anyone else had the same problems as me.
i sent it off for repair. all is ok now but on the cover letter they sent back with the phone they said the fault was "program abnormal excecution/ termination (error message pop up or etc.."" repair was "Replace main board" however i know i had a scratch on the back of the phone that is no longer there (there is also no dust etc in the bottom buttons or the top speaker), does that mean they replaced the whole device?
thanks
1) Whilst texting- The keypad is generally glitchy.
- When pushing the delete button other buttons are triggered too such as the B & M keys.
- The directional arrows do not work.
- Even though XT9 predictive text is selected it doesn’t always work.
- it takes numerous taps on the screen to start the write reply feature.
I have tried calibrating the screen and aligning it, this was unsuccessful.
2) The home button below the screen has stopped working.
3) The camera has suddenly developed an intermittent red tint, sometimes the camera will be fine other times it is not.
4) When trying to launch the camera/ video camera it sometimes says error unable to to connect. I have to switch the device off to fix this, sometimes it takes 3 attempts.
5) The phone can only be set to vibrate.
6) When pressing the phone down key to get the lock screen to appear it sometimes takes up to 30 seconds to appear.
7) The battery life appears to be getting shorter after every charge, for eg. It finished fully charging at 1am, i then left the phone in standby mode (no programs running) and by 8am when i woke the battery was a 40%
http://forum.xda-developers.com/showthread.php?t=595655
my hd2 oso face the battery problem....
Since two days I have strange behavior of my Blackstone touchscreen.
Just after start (or reboot) it works correctly but after few minutes when I hit for example start button it actually point about 1,5cm upper. So all touches has offset and hits not in the correct place like this:
Hit spot
^
|
|
Touched place
If I mange to go setup->screen->Align screen it's fine for a while and again after few minutes it's happen again.
ROM is Energy.BLACKSTONE.23149.Sense2.5.Cookie.2.0.Dec.01
Do anyone have the same issue?
It's more software or hardware problem?
At least yours still works... I also got problems with touch offset and decided to change the digitizer... but broke the lcd screen during the operation...
My device was acting just like yours: after screen alignment it worked for couple minutes then just went crazy... unfortunately, it's a hardware problem (problems between the first and the 2nd layer of the digitizer).
To align the screen more convenient just do this at any moment (with the phone switched on):
Press VOL UP and VOL DOWN simultaneously and while keeping them pressed, lightly touch the screen. This will surprisingly initiate the screen alignment procedure.
Hard reset?
So I dropped my phone and completely destroyed the screen and also the touch input. Today I received my new Touch Screen and LCD (Whole package).
I replaced the screen and booted up the phone, the screen comes on fine but the touch input doesn't. It seems to work at random intervals of 5-20 seconds. Kinda like this: Touch screen doesn't work (anywhere on the screen) I keep pressing it with my finger and after 5 seconds it will pickup my touch input, I can now scroll true the home screens but as soon as I release my finger it won't register input anymore for 5-20 seconds. Some where in the 5-20 seconds it will register my touch input again but as soon as I release my finger it doesn't register anything for 5-20 seconds.
I'm afraid the motherboard or something else on the phone is broken or is there someone that had this same issues and found a easy fix?
EDIT:
Okay messed around with it this seems to happen.
The touch screen is just responding really really slow. I connected a bluetooth keyboard on the phone is blazing fast using the keyboard. How ever when I use the touch screen I have to hold my finger on (lets say) the browser and after 5 seconds I will register a touch input. The phone is kinda unusable now or I have to carry a keyboard everywhere I go. Does anyone know how this could have happened?
After I have opened the camera app with double click I am not sure what I click on as I am trying to handle to phone to take picture a blue line appears scanning the phone which starts form top to bottom and then bottom to top and the phone becomes totally unresponsive. You cant unlock the phone and you cant take any incoming calls etc.
Not sure what happens after 30 minutes or so when you double click the phone then it goes back into the camera app and after you take a photo it works. If you don't take a photo and click back button the blue line starts scanning again and phone will become unresponsive.
Ntt sure what this is.
Phone SM-G9287.
I found what is happening.I have lock pattern setup to unlock teh device.Now when i double tap the home button it goes into camera app and then suddenly the blue line appears whcih moves top to button and bottom to top as if it is scanning.The phone will become unresponsive as i mentioned above i.e touch screen wont work but u can still take photos using up and down volume button but not by touching on the screen.
To overcome this you have to press back button and then press the hoem key 3 times and the touch scren becomes active again and hence now if you draw the lock pattern the phone will recognize it and unlock the device and it works normally.
Not sure this is a bug or not but very confusing.Can anyone try teh same if you ahve SM-G9287 phone and confirm if you are also seeing the same.
phone freezes up when utilizing camera, Touchscreen becomes unresponsive.
I experiance the same but My phone is loked whith fingerprint sensor.
My 10 day old phone freezes up when utilizing camera (activatd with double touch of home button. Touchscreen becomes unresponsive.
Nothing can be done to get it working.
Tried every hardware button, which seem to work as designed.
the solution Vravik mentions does not work with me.
Only working option i can manage to do software reboot the phone with power button combined whith volume down key.
but after booting the screen is still unresponsive. see:
https://www.youtube.com/watch?v=Q-hbOHAuFhE
I was advised to do a factory reset and just after starting up the phone again and register myself the screen froze up again.
Does any one have a clue on this
I have noticed this issue as well
I have noticed this issue as well. But after doing a full reset and latest software update, I didn't notice this
vravik said:
After I have opened the camera app with double click I am not sure what I click on as I am trying to handle to phone to take picture a blue line appears scanning the phone which starts form top to bottom and then bottom to top and the phone becomes totally unresponsive. You cant unlock the phone and you cant take any incoming calls etc.
Not sure what happens after 30 minutes or so when you double click the phone then it goes back into the camera app and after you take a photo it works. If you don't take a photo and click back button the blue line starts scanning again and phone will become unresponsive.
Ntt sure what this is.
Phone SM-G9287.
Click to expand...
Click to collapse
Hello
i am not able to post in the Dev section where the other bug reports seem to be , as I am new, so I am posting here in case it helps. If there is some where else I should, please let me know.
Running 7.1.1 N4F26I on an oppo find 7 x9076,
When the screen is off, and i press the power button to wake it up, on some occassions, the screen is weird; the vertical left half and right half are interchanged. T
So the screen which should look like [AB] looks like B][A
I am able to bring up the reboot menu by pressing the power button and touching the reboot icon (which appears to the right of where it originally should. he only recourse is to reboot, to revert to normal.
This doesnt happen every single time that the screen is off, but I am not able to reliably reproduce. I'd reckon this happens 1 in 10 times.
Other than that, great ROM, and very snappy on the Find 7.