dear all experts ...
I tried to update my Shadow by the new wm6.1 rom.. the first time it went to 100% and restart with an error 270 : the image is corrupt . After, when I boot loader, it go to 2% and restart every time ( many) :
I'm stucked at bootloader mode and tried many roms but no one sucsess ... all of them reach 2% and then stopped.
even I tried the original one (Shadow_Software_Update_1.11.531.5.exe) from t-mobile official site but also same result.
so can any one help me and give me any solution to try?
try to install this on your phone
http://forum.xda-developers.com/showthread.php?t=394478
after that try installing a cooked ROM
Dear sir;
thanks a lot for attention to my problem and ur kind reply.
I already tried to do this but...
* How can I upload sspl/uspl to my phone from bootloader because it's the only mode I can work my phone?
* when I tried to do USPL + RUU it go to 100% and then the phone restart and the RUU program says corrupted image...
then the phone stays in it's state (only can go to bootloader mode).
can I use MTTY program to flash sspl/uspl and USPL and then the new rom? if yes .. how I can do it?
Or what may I do my friend..
thnx a lot again
if you can only get to the bootloader then try flashing to the t mobile rom, then start over
Mee toooooo
I installed this ROM and it doesn't work!!
the screen is freeze with the Windows 6.5 Logo, and thats it!!!!
what can i do for do a hard reset?????? (i already do that thing, power it on, and then push the 2 soft buttons, and didn't work!),
HEEEEEEEEEEEEEELP!!!!
isfected said:
I installed this ROM and it doesn't work!!
the screen is freeze with the Windows 6.5 Logo, and thats it!!!!
what can i do for do a hard reset?????? (i already do that thing, power it on, and then push the 2 soft buttons, and didn't work!),
HEEEEEEEEEEEEEELP!!!!
Click to expand...
Click to collapse
Power off the phone
Press and hold the camera and voice keys
Insert the USB cable, Keep holding the camera and voice keys until you get the bootloader screen
Then flash an original ROM.
Hello there magicians.
My poor Artemis is in trouble.
After an upgrade to a new rom (Artemis touch 4.02) and when everything went perfecty well, I tried to put greek in it. After reseting the device starts but stucks in the screen before opening WM 6.1
HELP!!!
How to enter it in bootloader?
shut down ur phone by removing the battery then again put in the battery then press the record button and the power button together u will see the red blue screen this is boot loader mode flash it with official factory rom this is important and dont forget to remove ur sim and memory card before flashing
Thanxxxxxxxxxx
A lot
And now what I ll do about greek keyboard?
My htc gene is bricked.I have tried all the methods. I am unable to recover using Orefkov's method. When I try to press power key or soft reset button , onlr red and green light blinks. Nothing else happens. no charging indecator when i connect it to wall charger. I am even not getting the tri color screen.
please help me. to at least get into bootloader.
I have tried to connect using MTTY also but it is not detected using usb. help less now with no bootloader.
pravin.kamdi said:
My htc gene is bricked.I have tried all the methods. I am unable to recover using Orefkov's method. When I try to press power key or soft reset button , onlr red and green light blinks. Nothing else happens. no charging indecator when i connect it to wall charger. I am even not getting the tri color screen.
please help me. to at least get into bootloader.
I have tried to connect using MTTY also but it is not detected using usb. help less now with no bootloader.
Click to expand...
Click to collapse
don't panic
to enter boot loader just on device
press and hold camera button and press soft reset button .
deepv84 said:
don't panic
to enter boot loader just on device
press and hold camera button and press soft reset button .
Click to expand...
Click to collapse
No luck. I have tried to go to bootloader using press and hold camera button and press soft reset button
pravin.kamdi said:
No luck. I have tried to go to bootloader using press and hold camera button and press soft reset button
Click to expand...
Click to collapse
remove battery and then hold power button for 20 seconds (this will remove stored power from device )
then insert battery
press and hold camera button then press power to bootloader
hope this will work
Pravin,
What happened??
Did it work?
no bro i have tried power cycling also nothing is working.
ok dude did it worked?
if not tell me i'll help you via team vewer to unbrick it
dont worry just dont panic i've unbricked mine too
what happen
hey bro ,,
what happen, r u able u restore u r set...... if not tell us ...
bye
My Gene also dead
Please help me,,
i try to update rom but it fail,
now when i start my gene it show color screen...
please help me what i do
my yahoo chat id [email protected]
added you on yahoo
hey amit ,,
can u explain more in detail what u do exactly with u r handset..
.......
When i try to update my rom, i don`t know what happan but now, my phone not start when i try to start only blue and red light flash. nothing.
when i press reset with camera button i saw three color screen.
Tell me what i do..............
hello gurusingh,
I was update my htc p3400i ROM, after completion. Phone turn off but not restart, if I try camera button and reset button only green and red right blink not any indication shown on screen,…please help me.
I shall very thankful, if you solve my problem
Sanmukh singh
MSL, Mumbai.
hi gurusinghbrar,
My Htc p3400, can not start......
i was updating this rom "RUU_Gene_hTC_Asia_India_1.17.720.1_4.1.13.34_02.79.90_Ship" after 100% complete it turns off , but not start only Green and red light flash during press reset button...
i was try all methods,#remove batery 20 sec and then start with camer button & both camera and voice button. but result is same...
#No indication during Charging.,no usb detected in PC.
please help how i can recover my device.....
sanmukh singh
[email protected]
HTC P3400i GENE100 Dead
I have a HTC P3400i GENE100. I successfully installed orefkov SPL and then upgraded my original ROM WM 6.0 to cooked wm 6.5. After installation my device was too slow than before hence I flashed it with RUU_Gene_hTC_Asia_India_1.17.720.1_4.1.13.34_02.79 .90_Ship.exe. After flashing it 100 % my New Gene restarted, but didnt boot to booting screen. Its not going into bootloader mode also. It shows blank screen i.e. black. I tried several combinations of keys (Camera + Power button or Camera + Reset or by pressing both "-" button + Reset) for going it to bootloader mode. But none of them working. When I plug in charger the green & red light blinks once and nothing else. Same if I press reset with stylus, the green & red light blinks once and nothing else happens. I know that I have bricked my New Gene, when I flashed the ROM, which was meant for Old Gene, which I came to know after reading the posts in this forum. I have to use JTAG Method for recovering my Gene. Hence I have read many posts about it in this forum. But can any one of the great masters here, help me with a proper guide that can help me recover my Gene 100%.
Thank you for spending your valuable time in reading this post.
Regards
Parag Gawali
prgawali said:
I have a HTC P3400i GENE100. I successfully installed orefkov SPL and then upgraded my original ROM WM 6.0 to cooked wm 6.5. After installation my device was too slow than before hence I flashed it with RUU_Gene_hTC_Asia_India_1.17.720.1_4.1.13.34_02.79 .90_Ship.exe. After flashing it 100 % my New Gene restarted, but didnt boot to booting screen. Its not going into bootloader mode also. It shows blank screen i.e. black. I tried several combinations of keys (Camera + Power button or Camera + Reset or by pressing both "-" button + Reset) for going it to bootloader mode. But none of them working. When I plug in charger the green & red light blinks once and nothing else. Same if I press reset with stylus, the green & red light blinks once and nothing else happens. I know that I have bricked my New Gene, when I flashed the ROM, which was meant for Old Gene, which I came to know after reading the posts in this forum. I have to use JTAG Method for recovering my Gene. Hence I have read many posts about it in this forum. But can any one of the great masters here, help me with a proper guide that can help me recover my Gene 100%.
Thank you for spending your valuable time in reading this post.
Regards
Parag Gawali
Click to expand...
Click to collapse
check ur mail
Gene back to life
Thanks to Sumeet...
I got my HTC P-3400i New Gene back to life. It works better too. Sumeet is the man, who has given life to my entirely dead gene. I thank to him and suggest needy to contact him in their cases.
Thanks to XDA-developers Forum too...
Regards
Parag Gawali
same problem i had pls help me
Fido/Sumeet, please help me my gene got bricked when i was downgrading my gene from 6.1 to stock rom. after successful rom update my gene doesnt got restarted i'm getting black blank screen.
pleaseeeeeeeeeeee guys help me.....
So a friend have a problem with a ROM, and i decides to flash rom radio and with an other ROM and when i'm flashing HD2 freezing and lock at 53%, i trying to flash with any others Roms and i have a big problem, hd2 no reboot,, and no reboot in bootloader mode too after :S
i trying the Hard Reset manual and nothing !!
Who can help me ???
Sorry for my bad english!
Friendship Kindly.
if you can't get into bootloader then it is probably dead.
So volume down while pressing the reset key doesn't do anything?
If you plug it into a charger does the red led come on?
What version hd2 is it?
Thank's for your answer so,
i can't make it in bootloader even if i press volum down button and press the end key, he does nothing :s but he return in bootloader mode one time / 50 ...
when he connect to a source i don't see the red led for charging batterie :s
and i don't know what is this model, it's an HD2
And the last time i boot it, it's written Software uptade fail, try again with a /!\
If its a US T-Mobile one (has T-Mobile at the top and green & red buttons at the bottom) then its most likely that the radio he has flashed to it is the wrong one.
If this is the case, then there is no fix.
Otherwise, its best to see if you can send it back for repair
Hi
Plssssss Help me. i'm using HTC touch 3450 and i have upgraded my device with wm6.1
NOW THE PROBLEM IS...
1. MY DEVICE BUTTONS(HARD KEYS) NOT WORKING BUT I CAN MAKE THE DEVICE IN BOOTLOADER (TRICOLOR) MODE BY PRESSING CAMERA + POWER BUTTON.
2. AFTER INSTALLING A ROM WHENEVER MY DEVICE STARTS IT SHOWS THE HARD RESET SCREEN (BLACK SCREEN........... ALL THE DATA ...BLAH BLAB......)
I HAVE TO REMOVE THE BATTERY AND START THE DEVICE AFTER 30 MINS.) PLEASE NEED THE SOLUTION ......
3. I AM TRAYING THIS FOR A MONTH BUT NOTHING HAPPENS
PLZ GUYS HELP MEEEEEEEEEEEE OTHERWISE I'LL BE CRAZY!!!!!
rupesh baviskar said:
Hi
Plssssss Help me. i'm using HTC touch 3450 and i have upgraded my device with wm6.1
NOW THE PROBLEM IS...
1. MY DEVICE BUTTONS(HARD KEYS) NOT WORKING BUT I CAN MAKE THE DEVICE IN BOOTLOADER (TRICOLOR) MODE BY PRESSING CAMERA + POWER BUTTON.
2. AFTER INSTALLING A ROM WHENEVER MY DEVICE STARTS IT SHOWS THE HARD RESET SCREEN (BLACK SCREEN........... ALL THE DATA ...BLAH BLAB......)
I HAVE TO REMOVE THE BATTERY AND START THE DEVICE AFTER 30 MINS.) PLEASE NEED THE SOLUTION ......
3. I AM TRAYING THIS FOR A MONTH BUT NOTHING HAPPENS
PLZ GUYS HELP MEEEEEEEEEEEE OTHERWISE I'LL BE CRAZY!!!!!
Click to expand...
Click to collapse
hi
if u can get ur tricolor screen then try this
connect the usb cable to pc and see if u get the USB words on the phone tricolor screen if so good try flashing any official ROM the same happened to my phone long back did the above got my phone back asuming u have done HSPL for ur phone if u have not done that then the only way is to take it to service
hope it helps good luck
thanks
hari
Wrong forum.. Touch P3450 is not a touch 3g , its the original touch (ELF version)
but i will try and help as i have owned both.
if your hardware buttons are not working it could be possible that your send and end keys are stuck down as this key combo brings up the hard reset you are talking about.
think you are going to have to open it as it sounds like a hardware fault, and if you cannot get into bootloader you cannot flash
if it was working alright before this is not the case, but either way you will have to fix your camera button and get into bootloader