I have an Audiovox SMT5600 and when ever I plug iit into the AC Power cord it will shut itself down after a minute or two.
What is going on. Should I reflash the ROM?
smt5600
or you can try a hard reset.
Related
after trying to upgrade my imate Pocket PC edition, from 2003 to 2003se,
my ppc is starting to act strangely. the symptoms are:
1) it will not power up without attached to cradle, it acts as if there is no battery in the machine at all.
2) when it powers up (when its in cradle) it boots up fine and i can even sync it and even reflash it (although i have to use a small piece of bent pin to press the reset button which is covered by cradle itself)
3) but when i detatch the device from cradle, it just dies and the light wont even flash and format, hard and soft reset would not work.
4) when i plug in the battery seperatly into cradle (second slot)
aux battery indicator on the cradle would not light up.
can any one give me any advise?? :-(((
x2pacx, did your ROM update complete successfully? It sounds like your battery isn't being recognized by the ROM or WM. Try updating the ROM again or try a hard reset.
well.. how do i tell if the battery is not recognized by the battery?
i tried updating to many different roms and hard reset.. :-(
still no luck..
any advise anyone?
I have an 02 XDA IIs on 2003 updated to most recent software for 2003 via o2 site etc
Ok so I took my PDA away for a few days over christmas and the batterry ran down, and I had forgot the charger so obviously it wouldnt turn on.
I got home and put it in the charger cradle, and it wanted to do a hard reset, so I went through with that and after a few seconds the screen goes black and it then goes ding and up comes hard reset again.
It does not hard reset at a certain point of setup as if you do the process quicker it will still hard reset say after, 10-20 seconds, usually the same every time I think.
Whilst off the cradle, you cannot even switch it on and no light shows or soft reset does not work.
In the cradle only the above which I described happens...
Any help is much appreciated
Sam England
hi.. seems to be a real trouble... anyway try to re-load the rom on it... use your wm2003 cdrom or dowload from p2p or forum wm2003 on your language, then try to flash the device following on screen infos...
hope this will help,
all the best,
storm
Have you checked your sync port?
Sounds to me like pins 20,21,22 may be damaged in your charger (sync) port, one may be touching the body of the port and causing a short, creating a hard reset. Also this might be the reason why it is not charging. IMHO regards
hi sam england
is your cradle plugged into the wall socket? usb does NOT provide enough energy for the device to 'survive' the reboot. i have this 'problem' almost every time i let i discharge to much.
so plug a good idea is to charge your device with the supplied separate charger.
hope it helps ....
regards ize|man
hardware button problam i think..............
i think that your both hardware buttons softrest and power swich are jam or lock thats why it doesn't work and because of them the phone get hardreset when ever you plugin charger or cradel
if you want any help about hardware of any htc products plz connect me on my e-mail id
if you have a cradle with the battery charger, take out your battery, charge it, and put it back in the unit
It should get through its start up routine
Hi All,
Got a problem with a Mini. The unit will not power on. It doesn't appear to charge either. When I remove the battery, and re-insert, I hear a "click" noise but nothing after that.
The LED does not light when power is connected.
It does not hard reset.
Any ideas?
Thanks
Sonny
Update
Ok, here's an update to the above post.
When the battery is inserted and the back cover is off, the LED on the top glows red. When the back cover is put on, the LED turns off.
The unit will not work from external power with or without the battery installed.
Does this help?
SF
Must be someone out there that can help?
got the same problem...
see if you can try another battery, mine does not power on without the battery in anymore. The back cover must be on before you can power it on and the red light means that it is charging but there is not enough charge to turn on.
same prob. here...
i am surfing on the net of my XDA when it shutdown i thought it was a battery problem so i try to charged it but i've noticed that it didn't opened for a couple of hours of charging. i tried to reset but it didn't work. so i decide to hard reset my phone but again it did'nt work, and now my XDA II mini WM 6.1 is totally dead.... i also tried to flash my phone but the activesync of my phone cant detect my PC, and even rebooting my phone also did'nt work.
i've also notice that everytime i charge and unplug the charger of my phone the redlight blink on the "led?"(correct me if i'm wrong) for a seconds...
Same here. My phone is dead when I'm trying to flash it. Now it's totally dead. Is there a way to fix this?
Hello! I've got the same problem, but somehow I did it a hard reset and my O2 just power up. I try to wake up my O2 without battery with USB charger/ with battery with USB charger/ without battery and back panel with charger/ with battery and back panel and somehow I do a hard reset. Best Regards
MoHuToP said:
Hello! I've got the same problem, but somehow I did it a hard reset and my O2 just power up. I try to wake up my O2 without battery with USB charger/ with battery with USB charger/ without battery and back panel with charger/ with battery and back panel and somehow I do a hard reset. Best Regards
Click to expand...
Click to collapse
you try a hard reset by pressing the camera button and soft reset power simultaneously
Can you help me please? I´m using HTC magician. Sometimes when I´m using for example 15 minutes after that magician is shut down. When I want to switch on, I can but after 15 minutes or I have to move with back cover after that I can sometimes switch on. I have the newest ROM version. Did you have the same problem anybody?
first of all please confirm whether it turn off automatically while in power (charging) mode. If not, then your battery is gone replace it !
tejen said:
first of all please confirm whether it turn off automatically while in power (charging) mode. If not, then your battery is gone replace it !
Click to expand...
Click to collapse
Thank you for your answer. I try to did it but I have still same problem. Magician is turn off also when the charging cable is plug in to the magician. After that the red light is shining. Do you have another help?
same problem with me..but i see it restarts wen i connect it to pc or charger
Do hard resetower+camera and reset and let ppc restart.
My name is carlos and im new in the forum.
This is my problem. I have an HTC Imagio. I tryied to update it but i fail because my phone wont turn on again. I dont know what can i do because I new in the htc world and I dont know how can I start.
Please heeeeeeelpppppp meeeeeeeeeeeeeeee
Please provide some more details: Does it power on at all? Is it stuck on a certain screen? Please describe what's going on.
Look, the phone doesnt turn on, it cant enter to the soft-reset or the hard-reset. When I pluged to the computer, I can heard an a disconected sound (like, when you disconect a usb). The computer recognize it as an a Damage Dispositive. I didnt try charge the battery in a universal charger yet, but thats it all the info that I can give you.
I hope you can have an a solution
So, have you tried to charge the phone yet?
When you plug it in, either to the wall charger or to a computer through a USB cable, does the little red light come on?
With the battery charged and turning the phone on, does it do ANYTHING?
If it truly will not do ANYTHING, you most likely DO have a dead phone - but this is not a common occurance.
when I had trying to charge the phone on the wall, the red light wont come on.
I think that I would like to try with a universal charger. Do you have any other method to fix my problem??
What did u flash? A Hspl or an rom/radio image? If u charge the batery with universal charger, and u pres volume down an power does the device enter in a tricolor screen?
Unbrick
Unbrick a phone just can be made with JTAG tools...
See jtagbox.com/riff-jtag-box-owners-unbrick-your-phone/shops-unbrick-bricked-phone-riff-box-owners-list
SolidCarlos said:
when I had trying to charge the phone on the wall, the red light wont come on.
I think that I would like to try with a universal charger. Do you have any other method to fix my problem??
Click to expand...
Click to collapse
Have you tried soft reset (red button next to the battery) and volume down? This should have take you directly to the ROM installation boot screen... or whatever they call it these days. If that does happen you can plug it into the computer and install the MR1 or MR2 update..
pcdphones.com/our-devices/products/56-xv6975