Where can I download this,and can I install it without hard resetting my qtek.
Related
I've got a IMATE JAM with 1.03 Italian ROM
I would like to know if there is a 1.11 rom in italian.
Do you think 1.11 is really better than 1.03?
hi
I have a MDA Compact and I used for long time the same ROM (JAM) as yours, and then I decided to try out the Qtek one (with radio 1.06). That's what I think:
- the qtek rom leave me more free RAM even with full extended rom customization installed
- the jam rom has a fax software that is missing in qtek one, but qtek hase pdf and ppt viewers that are missing in qtek rom
- qtek rom has BIG problem with bluetooth. I mean that if you disable it (by switching on airplane mode or by bluetooth icon and/or by some software as PocketZenPhone) it is NOT sure that you'll be able to switch bluetooth on again, even after a soft reset. You'll need a very annoying hard reset.
About Italian ROM 1.11 I have not found it yet, but I did this:
I got Italian MA_DANG_ITA_10604_119_10500_Ship.EXE , I expanded it in a folder (if you have winrar installed, just right click on EXE file) and then I did the same for MA_Dangaard_WWE_11100_129_11100_Ship. Now take radio_.nbf from WWE_11100 folder and put it in ITA_10604 folder. Find MaUpgradeUt_noID.exe around in the forum, and use this file to upgrade your Magician from ITA_10604 folder. The first time you run it it will take your Magician to serial mode and give and error. Launch a second time and it will work.
Telling the truth, if you think you'll switch on/off bluetooth a lot of time, I don't recommend you this upgrade, also because I've NOT been able to come back to JAM ROM.
Regards,
RiCCiO
Do you think i can upgrade just the 1.11 radio stacks?
I mean to use 1.03 ITA (Imatejam) + 1.11 radio stacks (Qtek).
Is it Possible?
Hey boarders,
I tried to look for a solution but nothing came up from the SE.
Recently i have access to a Qtek 9090 but i expierence the following, when i activated Wifi after a hardreset i can perfectly connect to the Network. But when i disconnect and want to access the same network again it doesn't work. I have to hardreset the Pocket Pc and then it is working.
Did anyone have the same problem and found a solution for it. The Qtek 9090 is a proximus collection device supplied through brightpoint and has 1.22 Rom version.
Peter
just bought me a qtek 9100. first i tried to install was MS voice command, but it didn´t work. then i tried to insall spb pocket plus and it worked, but as soon i do a soft reset the qtek hang and only thing i can do then is a hard reset.. why??? It only hangs when I have pocket plus installed.....please help!
hi there
ms voice command DOES work on the 9100 (as well as on the other wizards). regarding plus: get the latest file from spb software and try re-installing. it works too.
cheers, lutz
dragon666 said:
just bought me a qtek 9100. first i tried to install was MS voice command, but it didn´t work. then i tried to insall spb pocket plus and it worked, but as soon i do a soft reset the qtek hang and only thing i can do then is a hard reset.. why??? It only hangs when I have pocket plus installed.....please help!
Click to expand...
Click to collapse
I had the same problem..
After installing Pocket Plus, clear the "Safe Mode" checkbox in the option settings!
thx so much.. now the "freezing" problem is gone.. but I still can´t install MS voice command.. after install it says installed failed, please reboot and try again.. have a S100 to, and that one workes just fine..
I would like it to work on my new 9100 too..
I was installing MS Voice Command to my s200 and at the s200 there was an error and installation was not successful. After this I can not see the softwares installed in my s200 at Settings/Remove Programs. Also activesync started to give an error and I can connect as Guest :?
What is the problem and the what can I do to repair? I wish there was something like system restore in WM5. I hope I wont have to hard reset.
Need help here :roll:
Hard reset does not always have to be so bad!
Look at it from the bright side:
You have a clean device again and installing your software via active sync (if you have installed it via this way before) isn't all that difficult either.
Cheer-up and make sure to buy sprite back up for when it happens again to you.
Robin
Ok that is fine. But anyone knows what may cause this and if I can solve without hard reset. :roll:
Seems no!?
Hi there
I am new to this forum, I have purchased an SPV m600 on Orange from ebay, and I was woundering if I can upgrade the rom to T-mobile Vario. Has this been done before and will it work. If not please can soemone let me know where I can get other roms for this device. I am a t-mobile users, and the phone keeps on freezing when I enable push mail.
Cheers
The vario is the wizard while your device as you know is a prophet. Attempts to put wizard ROM on prophet "as is" were made with WM 6 but the results were unusable.
Chances are you will brick your device completely.
But note this: you push-mail problem shouldn't require a ROM change. All orange customization is in the ext ROM so try hard resetting your device, the soft resetting just after you finish all the calibration and stuff so the ext ROM wouldn't install. Then get the proper connection setting for T-mobile and see if it works.
Thanks for your help, are there any other Rom's I can install on that device ie, Imate or XDA. This way I will remove all the Orange setting of the device.
I have entered all the t-mobile gprs settings on the device, but it still frezzes every so often, but everything works still the web and email. I am not happy with the device fall asleep for 30 sec or so.
Cheers
Try the forum search for the Qtek 2.20 WWE ROM! This ROM is in english and have no Ext ROM from a provider such as T-Mobile or Orange! I think this would help you!
You must setup the connection data after finish installing manually but this isn't a big problem!
spv m600
Thanks for you help, if you come accross the link then let me know. I will do some searching over the weekend.
Cheers