Sorry for my bad english
I try to change custom boot splash logo. but, after reboot recovery my phone does not appear the logo and can't boot or recovery mode and can to download mode only.
Product: SM-G900H
System status:Custom
Binary:Custom
Scure download:Enabled (blue color)
Knox wareanty Void:1
RP SWREV: A1
please help me
Related
Hi i have tried to recover i9505 which was stuck on samsung logo assumed its just like another samsung phone so i downloaded any 4.3 firmware from internet and updated it using odin. Now phone is stuck at samsung logo with a message on top left corner recovery booting... I have tried different firmwares on it some of the were 4.3 but it still stuck there. on some firmware it gives error on odin and doesn't go further
state of the phone
can't boot into recovery holding vol + home +power
phone can go in to download mode
knox kernel lock: 0x0
knox warranty void: 0x1
csb-config-lsb: 0x30
write protection enabled
emmc Burst mode enabled
please help thanks
faisal_sherry said:
Hi i have tried to recover i9505 which was stuck on samsung logo assumed its just like another samsung phone so i downloaded any 4.3 firmware from internet and updated it using odin. Now phone is stuck at samsung logo with a message on top left corner recovery booting... I have tried different firmwares on it some of the were 4.3 but it still stuck there. on some firmware it gives error on odin and doesn't go further
state of the phone
can't boot into recovery holding vol + home +power
phone can go in to download mode
knox kernel lock: 0x0
knox warranty void: 0x1
csb-config-lsb: 0x30
write protection enabled
emmc Burst mode enabled
please help thanks
Click to expand...
Click to collapse
Hi there,
First try getting into recovery again!
Turn device off completely and leave for a minute or so......
Hold Power + Volume Up (no need for home button)
Wait for Vibration and Samsung Logo to appear then the writing in the top left corner....
Release the Power button but keep Volume Up pressed
Wait for Vibration and Samsung logo and writing to appear then let go of the volume rocker
Hopefully will boot to recovery
Factory reset the device and reboot......
If above fails try below............
You need to flash the latest firmware for your device........Which must be 4.3 firmware due to the KNOX boot loader you have, which if you did not know you have void your KNOX warranty 0x1 ( you cannot use the knox application anymore and this is currently irreversible ). Check what the latest firmware is HERE and flash through odin........If your phone is in boot loop after flashing or stuck at the logo then boot into recovery (if possible) and factory reset the device and re-boot.
Flashing any old firmware won't work
Samsung S4 M919V
Rooted using Odin
CWM & Titanium Backup saved on MicroSD Card and External HD
Used cm-11-20140217-NIGHTLY-jfltecan.zip
Problem
Installed CyanogenMod
Phone is currently stuck in a boot loop
Regular Startup Sequence:
Cyanegen Mod boot logo appears
Android is upgrading
Optimizing/Starting apps
Unfortunately, the process has stopped working.
Restarts.
Recovery mode (Bottom Volume key, power button, home button
"Warning!!" page, Volume up: Continue.
Stuck at "Downloading... Do not turn off target!!
Top Left corner:
Odin Mode
Product Name: SGH-M919V
Current Binary: Custom
System Settings: Custom
Knox Kernel Lock: 0x0
Knox warranty void: 0x1
CSB-CONFIG-LSB: 0x30
Secure Download: Enabled
Write Protection: Enable
eMMC Burst Mode: Enable
Click to expand...
Click to collapse
Connected to laptop
Odin only recognizes phone with regular boot up.
I'd really appreciate any help or suggestions you guys have for me.
Thanks.
Hello please help me my Tab a SM T350 got stuck at "SAMSUNG" Logo.
RECOVERY BOOTING...
RECOVERY IS NOT SEANDROID ENFORCING
Set Warranty Bit: recovery
I've used Odin 3.10.7 to CF Auto Root this device. It says "PASS" on the program , but after the device stucks on the screen I mentioned above .It does not boot after that ; nothing loads too.
Please someone to save me from this .
DariEX said:
Hello please help me my Tab a SM T350 got stuck at "SAMSUNG" Logo.
RECOVERY BOOTING...
RECOVERY IS NOT SEANDROID ENFORCING
Set Warranty Bit: recovery
I've used Odin 3.10.7 to CF Auto Root this device. It says "PASS" on the program , but after the device stucks on the screen I mentioned above .It does not boot after that ; nothing loads too.
Please someone to save me from this .
Click to expand...
Click to collapse
Install twrp then the latest Supersu.
I was flashed TWRP Recovery in my A5 SM-500G and root my phone with Supersu2.82. when i power on my Phone it shows set warranty bit : kernel on top left on the bootscreen with yellow colored text and phone bootup normally but when i restart my phone to recovery mode and reboot phone from recovery mode to normal mode text changed ( Set warranty bit : kernel to Set warranty bit : Recovery ) and phone bootup in recovery mode everytim. And when i flash twrp with Odin then Phone bootup in normal mode. Why this happens everytime when i reboot into recovery mode ?
Hello guys, yesterday I found and old bricked GALAXY NOTE 4 model SM-N910F. Problem is when I try to turn it on it starts bootlooping with a blue "RECOVERY MODE" line on top left of the screen. So this is what I have now :
- I don't know the CSC;
- I can enter DOWNLOAD mode, BUT I CANNOT enter RECOVERY mode;
- I tried flashing the stock firmware through Odin, same thing happens;
- I tried flashing TWRP Recovery, but when I try to enter recovery mode i get the blue RECOVERY MODE line followed by SET WARRANTY BIT : RECOVERY (yellow line) and it starts bootlooping;
What else can I try?
Thanks in advance
Maybe you can try with Smart Switch emergency recovery, but you need download mode for that I think..
I tried both with Smart Switch and Kies, since i can enter download mode, but they dont recognize the phone
TriHarderino said:
Hello guys, yesterday I found and old bricked GALAXY NOTE 4 model SM-N910F. Problem is when I try to turn it on it starts bootlooping with a blue "RECOVERY MODE" line on top left of the screen. So this is what I have now :
- I don't know the CSC;
- I can enter DOWNLOAD mode, BUT I CANNOT enter RECOVERY mode;
- I tried flashing the stock firmware through Odin, same thing happens;
- I tried flashing TWRP Recovery, but when I try to enter recovery mode i get the blue RECOVERY MODE line followed by SET WARRANTY BIT : RECOVERY (yellow line) and it starts bootlooping;
What else can I try?
Thanks in advance
Click to expand...
Click to collapse
What does the AP SWREV line in download mode say
It says S1, T1, R1, A1, P1