I am using GT S5360. I have installed reincarnation pre final and it didn't passed the screen where samsung galaxy Y GTs5360 comes.
I followed the whole procedure but not working. Any help ???
Did you flash kernel?
Mount system?
Remember that naturalizer or touchwiz rom isn't for galaxy y
after you flash percys cm#2 kernel you must reboot to recovery and wipe system data and cache before you flash the rom
the steps are as follows
go into cwm
mount system
flash percys #2 kernel
reboot to recovery
format system data cache
mount system data cache
flash rom zip
format data
restart
if the rom still doesnt boot after that take out your sim card
if the rom now boots you need to change your baseband by flashing a different stock rom firmware via odin
I flashed the jellybean version... I have restored the backup now and i followed all the steps... I flashed the zip file of kernel, rebooted recovery, formatted system, data, cache and then installed the rom... But it stucks on bootscreen... Dosen't even show the bootanimation...
Honey_singh said:
I flashed the jellybean version... I have restored the backup now and i followed all the steps... I flashed the zip file of kernel, rebooted recovery, formatted system, data, cache and then installed the rom... But it stucks on bootscreen... Dosen't even show the bootanimation...
Click to expand...
Click to collapse
Do this :
1.Go to CWM,mount all the partitions and flash the kernel.
2.Reboot the system and take out the battery and then put it again
3.Again boot into cwm and format system,data and cache
4.Go back and wipe data and cache
5.Again go to mounts and storage and mount all the partitions
6.Flash the rom and after that wipe data
7.Reboot
And burrrrrah!
Your new rom is ready!
Honey_singh said:
I flashed the jellybean version... I have restored the backup now and i followed all the steps... I flashed the zip file of kernel, rebooted recovery, formatted system, data, cache and then installed the rom... But it stucks on bootscreen... Dosen't even show the bootanimation...
Click to expand...
Click to collapse
go back into cwm and format data and restart
did you mount system data and cache before flashing the zip?
have you tried it without the sim card inserted?
aniket.lamba said:
Do this :
1.Go to CWM,mount all the partitions and flash the kernel.
2.Reboot the system and take out the battery and then put it again
3.Again boot into cwm and format system,data and cache
4.Go back and wipe data and cache
5.Again go to mounts and storage and mount all the partitions
6.Flash the rom and after that wipe data
7.Reboot
And burrrrrah!
Your new rom is ready!
Click to expand...
Click to collapse
Nthing happened
Still it stops at galaxy y gts5360 screen
marcussmith2626 said:
go back into cwm and format data and restart
did you mount system data and cache before flashing the zip?
have you tried it without the sim card inserted?
Click to expand...
Click to collapse
Yes, I mount the system and cache
Honey_singh said:
Nthing happened
Still it stops at galaxy y gts5360 screen
Yes, I mount the system and cache
Click to expand...
Click to collapse
have you removed the sim card and see if it booted - please do all the steps I mentioned
Related
I had a really hard time installing custom recovery... I finally thought I had it and
wiped data/factory reset
format data
format system
wiped cache partition
but I did not flash a ROM
when I tried to get back in the custom recovery it just keeps going back to the factory recovery.... so i am stuck...
what to do please help...
horatiob said:
I had a really hard time installing custom recovery... I finally thought I had it and
wiped data/factory reset
format data
format system
wiped cache partition
but I did not flash a ROM
when I tried to get back in the custom recovery it just keeps going back to the factory recovery.... so i am stuck...
what to do please help...
Click to expand...
Click to collapse
My suggestion is that your read through the forums here as there are several "beginner guides" that will get you started.
After you installed your first custom rom the process proves itself to be easy:
- Flash a stock ROM (2.2 nordic)
- Acquire root using SuperOneClick
- Instal Clockworkmod recovery/2ndInit (I prefer 2ndInit)
- Transfer the nandroid backup (.zip file) to the root of your SD card
- Reboot phone when led turns blue hit volume down
-Wipe data
-Wipe cache
-Wipe Dalvik (It's under advanced)
-Restore -> select update zip from sdcard
- Browse to the nandroid backup file you put on your sdcard in step 4
Done
So i installed CM10.1 versio 9 but it goes to bootloop i tried TWRP and CWM both im coming from latest aurora ics. It always reboots me back to recorvery after reboot.
Miiku0 said:
So i installed CM10.1 versio 9 but it goes to bootloop i tried TWRP and CWM both im coming from latest aurora ics. It always reboots me back to recorvery after reboot.
Click to expand...
Click to collapse
Installation:
Copy package to SD card
Boot to recovery
Full wipe (data, cache, dalvik,)
Format /system, /data, /cache
Reboot recovery
Install pacakges
Reboot!
did you do all these steps and do you have repartitioned your internal partitions?
bdgraue said:
Installation:
Copy package to SD card
Boot to recovery
Full wipe (data, cache, dalvik,)
Format /system, /data, /cache
Reboot recovery
Install pacakges
Reboot!
did you do all these steps and do you have repartitioned your internal partitions?
Click to expand...
Click to collapse
I didnt do internal repartition. Can you give introductions for me to do that?
Next time search but since you're new here i give you credit :laugh:
http://forum.xda-developers.com/showpost.php?p=41060125&postcount=2
dark_vader said:
Next time search but since you're new here i give you credit :laugh:
http://forum.xda-developers.com/showpost.php?p=41060125&postcount=2
Click to expand...
Click to collapse
Thanks dude! it works now!
Hello everyone. I like CREED V4 and tried installing final build but every time I end up with bootloops. Is this rom fail, or I am doing something wrong?
I followed this tutorial:
1. Flash stock DDLK2 rom as Xicor Yagami said in his thread
2. Boot into CWM recovery
3. Wipe data
4. Wipe cache
5. Wipe dalvik cache (just in case)
6. Wipe battery stats (just in case)
7. Flash CREED V4 rom
8. Reboot
If I am doing something wrong, tell me the right tutorial for installing
After flashing stock DDLK2,follow the steps:
1.Boot into CWM.
2.Under mounts and storage,format system,data and cache.
3.Go back and wipe data and cache.
4.Again go to mounts and storage and mount all the partitions (All should show unmount)
5.Install zip from zip sd card and choose Creed V4 rom file.
6.When the installation is completed,go back and wipe data,cache and dalvik cache.
7.Once done with above steps,reboot the phone!
This tutorial works for every rom.
aniket.lamba said:
After flashing stock DDLK2,follow the steps:
1.Boot into CWM.
2.Under mounts and storage,format system,data and cache.
3.Go back and wipe data and cache.
4.Again go to mounts and storage and mount all the partitions (All should show unmount)
5.Install zip from zip sd card and choose Creed V4 rom file.
6.When the installation is completed,go back and wipe data,cache and dalvik cache.
7.Once done with above steps,reboot the phone!
This tutorial works for every rom.
Click to expand...
Click to collapse
Still no luck. Have you tried this rom by yourself?
creed v4 installation
i am newbie for this just tried installing creed v4 following the complete steps mentioned in the forum
but everytime i try to install, it enters into the bootloop.
using galaxy y gt-s5360
currrent rom 2.3.6 gingerbread DDMD1
even tried with deleting sd-card second partition
anujb said:
i am newbie for this just tried installing creed v4 following the complete steps mentioned in the forum
but everytime i try to install, it enters into the bootloop.
using galaxy y gt-s5360
currrent rom 2.3.6 gingerbread DDMD1
even tried with deleting sd-card second partition
Click to expand...
Click to collapse
Go into cwm
Format system data cache
Mount system data cache
Flash rom zip
Restart
Long as you are using stock or a stock based kernel this rom will boot
marcussmith2626 said:
Go into cwm
Format system data cache
Mount system data cache
Flash rom zip
Restart
Long as you are using stock or a stock based kernel this rom will boot
Click to expand...
Click to collapse
well thanks sir its now booted to the OS but its not showing any network
rest all other things are working fine tried with reinstalling the rom also same issue
what should i do now?
I have taken the backup of bml15
anujb said:
well thanks sir its now booted to the OS but its not showing any network
rest all other things are working fine tried with reinstalling the rom also same issue
what should i do now?
I have taken the backup of bml15
Click to expand...
Click to collapse
See ril thread - Link in signature
marcussmith2626 said:
See ril thread - Link in signature
Click to expand...
Click to collapse
I didn,t get you...
anujb said:
I didn,t get you...
Click to expand...
Click to collapse
Click the link in my signature to open up a list of my threads - find the ril thread & read it
marcussmith2626 said:
Click the link in my signature to open up a list of my threads - find the ril thread & read it[/QUOTE
after flashing the ril file for DDMD1 its working
thanks for support
Click to expand...
Click to collapse
I rooted the galaxy y, installed CWM, wiped cache and data..etc., installed a custom rom but the phone can't boot..stuck in bootscreen. I tried to change the kernel to CM kernel, and install a stable cm7, everything worked, but still no boot... what can I do?
what rom?
HnnnnnnnnmnHmmmmmmmmGpuuuuuuuuuuuuu
DeniablySam said:
what rom?
HnnnnnnnnmnHmmmmmmmmGpuuuuuuuuuuuuu
Click to expand...
Click to collapse
I've tried NukaRom V1.1.0 and CM7..happened the same..even with CM Kernel
Did you reboot to recovery after flashing kernel & mount system before flashing rom
Instructions to flash cm7
go to cwm
mount system
flash percy's cm #2 kernel
reboot to recovery
format system data cache
mount system data cache
flash cm7 zip
flash gapps (optional)
format data
restart
If you get bootloop remove sim card - if it boots change your stock rom firmware via odin
For stock based roms do as above but use a stock based kernel
marcussmith2626 said:
Did you reboot to recovery after flashing kernel & mount system before flashing rom
Instructions to flash cm7
go to cwm
mount system
flash percy's cm #2 kernel
reboot to recovery
format system data cache
mount system data cache
flash cm7 zip
flash gapps (optional)
format data
restart
If you get bootloop remove sim card - if it boots change your stock rom firmware via odin
For stock based roms do as above but use a stock based kernel
Click to expand...
Click to collapse
Thanks man! It works
Hi,
I have installed Ultra Gb revolutionary 1.6 Rom and have been using it for a while. I wanted to remove all content on phone..so i tried to wipe data and reinstall the rom again. Rom flashed correctly and i rebooted the phone..but user apps were not removed, they are still on the phone.
I tried changing kernel, flash another rom, flashed utra gb again, the apps are still there, why?
You can try to conenct your sdcard to your PC and delete .android_secure, it contains sd apps that don't get deleted with /data
If it doesn't work you can use Wipe data option in settings :good:
Killnolife said:
You can try to conenct your sdcard to your PC and delete .android_secure, it contains sd apps that don't get deleted with /data
If it doesn't work you can use Wipe data option in settings :good:
Click to expand...
Click to collapse
Thanks for your reply, i tried all of those, but its still there
marcusflint said:
Hi,
I have installed Ultra Gb revolutionary 1.6 Rom and have been using it for a while. I wanted to remove all content on phone..so i tried to wipe data and reinstall the rom again. Rom flashed correctly and i rebooted the phone..but user apps were not removed, they are still on the phone.
I tried changing kernel, flash another rom, flashed utra gb again, the apps are still there, why?
Click to expand...
Click to collapse
Well, that may be a kernel issue! Try to install stock kernel/ROM via odin and get it all clean!
lionelsuyog said:
Well, that may be a kernel issue! Try to install stock kernel/ROM via odin and get it all clean!
Click to expand...
Click to collapse
I think that's not the kernel, he said he tried to change it, i think he haves a problem because /data is not mounted,
OP use CWM and mount /data, then do wipe data & cache
Killnolife said:
I think that's not the kernel, he said he tried to change it, i think he haves a problem because /data is not mounted,
OP use CWM and mount /data, then do wipe data & cache
Click to expand...
Click to collapse
While selecting Factory reset on cwm, data & cache are automatically mounted and both data, cache and .andtoid_secure is wiped! I'm jst sharing my experience, it happened with me few times while using percy_g2 kernel! The best option for me was odin!
In CWM in general partition is mounted when wiped, I think switching kernel and try again
Flash another CM kernel and wipe data then return to your kernel, or do a factory reset from setting in phone
Try to use odin. Your userdata.img may be Corrupted
Press Thanks if Helped
Well a simple solution to the problem :
1.Go to CWM,mount all the partitions and flash percy's kernel (CyanogenMod #2)
2.Go back and then go to advanced > reboot recovery
3.Now you'll be in Percy's recovery and from there,under mounts and storage,format data and format cache.
4.Go back and then go to mounts and storage and mount all the partitions.
5.Flash back to bieltv.3's kernel and reboot.
Finally, i had to flash flash stock Rom via Odin and go back to ultra gb.. Thanks for all the help guys