MTK Engineering-How to increase Speaker(handset) volume levels during a telephone conversation?
I have a problem with the volume during a call
I installed the MTK Engineering (Google Play) on my Goclever Quantum 4.
I was trying to increase the volume.Unfortunately, there are a lot of shortcuts that do not understand (sip, sph, etc.).
I tried to change the value of an intuitive way.
After either try and restart the phone I set a good level of the earpiece volume during a call.
Now I do not know how I did it?
Can someone explain to me step by step how to with program the MTK Engineering increase the volume level during a call on the handset (not the speaker or the headset).
How to increase only the level of the handset without adding other levels?
I will be grateful for your help.
Regards
Related
Hi Is there any registry hack or trick to increase the volume level of the Universal? Compratively with the wizard (I have both) is very low and when in a shopping center or other noisely environement I don't ear it ring.
Thanks
I used Antik and gained it in Wavelab. Now I can hear it ring pretty good. I attached the WAV.
Thank you for the wave file. it is realy more audible. But i'm looking for a sistem solution a more general solution. I have tomtom 6 installed and with the volume in maximum level the voices are so quiet...
Hi,
I have the latest original 6.1 rom, the incall volume is set at maximum, but I need to increase more the incall volume because in louder environments I have some troubles to ear the people from the other side of the call.
I found a file named Audiopara.cvs but is for other HTC devices, and some registry tweaks that didn't work for me.
Anyone know how to increase the incall volume?
Thanks!
Any help?
I tried hard-reset the phone but with no success. Also try other rom's but I have the same problem.
I agree volume is rubbish as my Trinity was far louder.
It would be nice to increase it if possible
I remember the boards on a mall when i get a call from someone. The upper floor had the body modifications shop named "Ear piercing" and the lower floor had a music shop named "Dolby music". It just happened that their boards were one above the other.
I am listening to some music on headphones, i get a call, answer it with the headset button, and YIKES!! the volume is maximum. even if the volume controller shows minimum, the sound is practically maximum.
it happens so that whenever i make a call, its at its maximum volume. even when not playing music.
over the past years i have used many android ROMs and have faced the same problem with many of them. few didnt.
and with years, comes wisdom (not blowing my own trumpet). I got a workaround for it on any ROM! if i change the volume level (increase or decrease) during a call, the phone then realises its mistake and goes down to the level in the volume controller.
my phone's in call volume is always set at its minimum. i get a call, pierce my ears, and turn the volume one step UP, and the volume level is acceptably low. (when the volume is minimum, lowering it doesnt work!)
i ask help to automate this workaround (a fix would be welcome, but i havent seen any coming around these past years)
could some tasker expert provide an xml or anything for this workaround to be performed automatically? (non tasker workarounds would be welcome as well)
the works to be done are:
1. when a phone call (incoming, or outgoing) is CONNECTED (not the ringing part on outgoing calls) turn the volume one step up. some milliseconds delay would ascertain that the volume goes up AFTER the call is actually connected, which is a must.
2. within the smallest fraction of time allowable (so that we dont notice it) turn the volume one step down.
results: the volume will not pierce our ears anymore, even if the volume level was minimum at call start, this trick would work.
Please throw some light, some expert.
bump!
Bump.
I have a similar problem with my vzw gnex running poweramp and etymotic headphones with microphone.
If I answer an incoming call it is at complete max volume, if I long press the button on the headphones to get to "voice command" the normally pleasant android voice lady comes in at a blaring max volume as well.
Now running Jellybean OTA strait from vzw.
This issue seems to be caused by the audio firmware in use. I found a firmware blob that defaults to an in-call volume about half-way through. It doesn't remember the last volume you set, but at least you won't go deaf if you forget to press Vol Up after initiating the call.
Grab the htcleo.zip file from this thread http://forum.xda-developers.com/showthread.php?t=860850 and either replace the htcleo.acdb file in your rom or delete the one in your rom and use the downloaded file to replace the default.acdb file (the files are located in /system/etc/firmware/). I'm currently using NexusHD2-JellyBean from this thread http://forum.xda-developers.com/showthread.php?t=1930240 and this trick seems to work.
I noticed the same firmware blob is used this rom http://forum.xda-developers.com/showthread.php?t=933951 which I used previously and didn't have this high in-call volume issue.
hello.
i'm pretty sure i saw somewhere a way of changing some system files in a rom to have a higher/lower volume sound (i'm talking about the real maximum level, not the volume like using volume buttons). i couldn't find anything about it. can anyone guide me? thatnks.
(what i want to do is to increase the maximum sound level)
I’m facing a strange and annoying problem on my Xperia X compact with LineageOS 14.1 / Android 7.1.1… During phone calls the volume is too loud even on minimum volume level. When I decrease the volume with the volumebuttons I see that it should lower the volume, but the volume remains the same. In other words, it doesn’t matter to adjust the volume level. It’s the case for both normal phone calls and also when I switch to speaker during a call.
It looks like the volumelevel for minimum and maximum are the same.
I’ve been searching in mixer_paths.xml (yes, I’ve rooted my phone), but there is too much info and I can’t find the right setting. Does anyone know what I should change, that there will be a difference between minimum and maximum volume level?
In build.prop I’ve added a command to add more steps to the volume slider. Now I’ve 14 steps in case of 6, but the minimum and maximum volume level are still the same so the steps doesn’t take any effect.
Other volume settings are ok btw.
Yes, right now it seems not to be possible to change the volume during phone calls which is very annoying. All you can currently do is setting the phone call volume in advance. Maybe one can have a look at OmniRom's settings (which have weekly builds but the terrible Google launcher and no built-in root) to work this out.