Hi!
I recently upgraded my cell from stock gb2.3.6 to jb4.1.2 but...
I have two big problems:
My phone doesent ring at all, only vibrate.(i changed the ringer and it didnt help)
My phone can't make any phone.every time i pushing the send buttom, the call is beiing finished 00:00 time.
Does any one have any idea how to get over this problems?
Another small problem is that the RSD LITE doest recognise the phone. My PC writes to me MTP device fail.
My phone details:
CyanogenMod version
10-20120110-nighly-mb526
2.6.32.60-Jellybean
[email protected]#1
Related
Hi my friends. I hope you help me in my problem. I have a prophet. For a long time i had installed wm6 touch evolution rom. This afternoon i had the phone closed and when i turned iit on it didn't load windows but when the windows mobile screen appeared i heard a sound and the phone turned off. I restarted and restarted for many times but nothing... I did a hard reset but the same problem. The bootscreen appears and when the screen changes to windows mobile bootscreen i hear a sound and then the device stuck. I installed the same rom i already had but the same problem. Then i decided to install the original rom O2 Germany but for one time again i had the same and the same problem. What can i do? Can this problem be fixed?
Hi guys. I think that i have find what is going wrong. I reinstalled O2 Germany rom and when the installation finished the phone is restarting. That time i didn't discinnected from usb cable and the phone didn't restarted or stuck. Is it possible that the batterrie has problem? The phone is starting only if it is connected to current via usb or via electric charger. Is this possible? My batterrie didn't have problem since this afternoon. When the batterrie was fully charged its duration was 2-3 days. Please give me a reason
Good morning.
im a newbie at updating the HTC HD 2 Leo i have for T-Mobile (which is probably WHY i shouldnt have messed with it in the 1st place...).
i tried downloading the android gingerbread rom onto my phone last night and while downloading the software their was a partition error and my phone was stuck afterwards rebooting on the failed software dowload (would get stuck on a black screen only showing the HTC letters in green.)
i FURTHER screwed it up by trying to put it in bootloader mode and trying to install the Original software i found which i downloaded off a website for the factory version of my HTC HD 2 Leo.
NOW it only shows a black screen.. the computer cant sync my phone, the battery light is not showing and no signs of life...it wont even let me go into bootboader mode...all it says when i plug it in to my USB port on the computer is under hardware found " Qualcomm CDMA Technologies MSM"...
someone PLEASE help this lost noob... much appreciated
wow! erm.... have you tried a hard reset? recovery software might still be on there, with any hope.....
i tried , but the hd2 doesnt show ANYTHING on the screen, i tried holding both buttons and pushing the power on button but the factory screen wont pop up because the screen stays permenantly black
Sounds as though you flashed a T-MObile USA with a ROM with a .51 RADIO; if that is the case then the phone is bricked.
You could always telephone HTC and say you charged your phone overnight and it didn't respond the next day - with no mention of flashing the phone.
As you have found out flashing before reading can be fatal (for the phone) and expensive. I have flashed quite a few HTC WinMo phones, but for every different phone I read then reread the instructions.
thanx i appreciate it , it sux that i cant get it fixed.
Hi everyone, hope you can help me. I have flashed quite a few roms (nand) and all with the latest radio yet i have the same problem over and over again. Everything in the roms works,(well, except for the usual glitches) except that when i make a phone call the screen goes blank which is what i expect in call but it won't turn back on again after or if i have to use the dial pad.
Is it me doing something wrong??? Any help would be recieved with thanx
cheers....
edit.... the only way it seems i can recover is to either plug in a usb or pull the battery??
HELP!!
edit 2.. Just flashed wm6.5 back on to it and screen works as it should... flashed 2 different android nand roms and problem is back??
Does no one else have this issue?? i MUST be doing something wrong!
i had CM7.1 rc
i got into rom meneger it said i didnt hed a cwm recovery but i did (i had older one) so i instaled the new one 5
then downloaded the new cm7.1 stable withe gaps and marked V on wipe devlik and the phone rebooted to hboot
now since my power batten doesn't work i pulled the battery and since then the phone wont turn up withe the usual power plug
and doing 7 vibrates and nothing else not even showing its charging or nothing (no orange or green light)
i have no idea what to do please help me
Hi all.
This is not only one phone problem but evry phone this problem.and than repair to the one thing is hear accepted this is stabel it is really very well system for phone briked stabel.
Thanks.
i have solved the problem i just removed the SDCARD and the SIM it solved the problem
dominic21 said:
i have solved the problem i just removed the SDCARD and the SIM it solved the problem
Click to expand...
Click to collapse
The CWM 3 and above is known to corrupt the sd-ext. Use older version or Amon Ra
Hi,
I have been trying to update my HTC HD MINI (Photon) to the stock rom but without success.
I have downloaded the official .exe file from HTC, and followed the steps, but when it goes to start the update process, the HTC goes to the 3 color display, loses the active sync connection, and the program gives and error doe to the lost of communication. I have tried letting the 3 color screen and updating but without the active sync, it does not start.
What am i doing wrong?
Best regards
whats the error code number?
is your phone carrier locked?