My Orange SPV M700 keeps saying Searching... whenever I switch the phone on and after about 5 minutes it says no signal even though the signal is actually there. The current ROM I have installed is [ROM] nAr & icke WM6.5 P3600/i [21895.5.0.90][WWE][FRA][DEU][ONLINE] the English version, and the Radio Version is 1.56.70.11. The GPS works fine and so does the Bluetooth as well as the WiFi and WLAN it also synchronising to Activesync ok. I also have the Manila Version 1.2.1913.1350 if this helps, I seriously need the phone working otherwise I'm kind of stuck. I also used the Free HTC Trinity SIM & CID Unlocker from Pof located here http://forum.xda-developers.com/showthread.php?t=293957&highlight=CID/SIM which unlocked the SIM card as well as loading any ROM which successfully worked after 6 tries.
Related
Hi everyone...I'm a newbie. Been reading all the pages but can't find answer to my q.
I installed T-Mobile ROM 4.01.16 downloaded from ROM kitchen. Unfortunately, now I cannot use the phone on my xda. It simply can't find my phone network. I tried to go into phone options but the phone hang. Otherwise, the rest works fine except it hangs sometimes.
I've tried to install new ROM, one for O2 xda but the error message below surfaced:
ERROR:Get Connection type - An existing connection was forcibly closed by the remote host
error getting connection type.
Now I'm unable to install a new ROM. Even via SD card. Please help.
PS Have also tried using xdatools to unlock. I get the same error message ie the remote host forcibly closed connection
If it's a PW10A-Model that you have try entering Wallaby Bootloader and set GSM settings manually to 900/1800. Installing the 4.01.16 ROM sets the settings to 900/1900. Maybe this is your problem...
HTH
Stefan
Same problem over here
Hello,
I also installed the t-mobile on my o2 xda accidentally,
i already put it on european band frequency 900/1800 via the wallaby editor.
But still i'm not able to put back the o2 wme 2003 on it.
any solutions for this issue ?
thanks in advance,
thomas.
Flash your ROM via SD-Card....
Thanks so much Lumpi. Now my phone works but a different problem crops up. The device once turned off, will not turn on unless I soft reset it. Also, when it is off, the phone will not ring/vibrate when there's an incoming call. The green LED flashes as usual, indicating phone is working. Any idea how to fix this? Thanks inadvance.
another Q: can I use an MMC 256MB card to flash the rom or can i only use SD card?
fadzrina said:
Thanks so much Lumpi. Now my phone works but a different problem crops up. The device once turned off, will not turn on unless I soft reset it. Also, when it is off, the phone will not ring/vibrate when there's an incoming call. The green LED flashes as usual, indicating phone is working. Any idea how to fix this? Thanks inadvance.
another Q: can I use an MMC 256MB card to flash the rom or can i only use SD card?
Click to expand...
Click to collapse
Have you used KSE Truefax? I think that is the problem with not turning on the device....
I think you can also use a MMC Card. Never tried it myself, cause i only have SD-Cards...
Stefan
I've never use Truefax eventhough I have it on the device as I cooked it in the ROM. Any other ideas? Thanks
I had the same problem with 4.1.16 and KSE. It doesn't matter if you "use" it or not. Something about KSE being cooked intothe rom stops the device from operating correctly. To date you are the 5th person I know of to have that problem. Recook the same rom less KSE, reflash, and I can almost garauntee it will work.
thank you everyone....it is indeed the KSE Truefax that was the culprit. I've since invested in a card reader/writer and a 256MB MMC card and my phone works again!
PS special thx to lumpi
tm 2003
I installed T-Mobile ROM 4.01.16 downloaded from ROM kitchen. Unfortunately, now I cannot use the phone on my XDA. It simply can't find my phone network. I tried to go into phone options but the phone hang. Otherwise, the rest works fine except it hangs sometimes.
I've tried to install new ROM, one for O2 XDA but the error message below surfaced:
ERROR: Get Connection type - An existing connection was forcibly closed by the remote host
error getting connection type.
Now I'm unable to install a new ROM. Even via SD card. ROM sets the settings to 900/1900, and I can’t get into Bootloader via SD flashing nor power, soft reset, rocker/action…Any suggestions?
Hi there
I am new to this forum, I have purchased an SPV m600 on Orange from ebay, and I was woundering if I can upgrade the rom to T-mobile Vario. Has this been done before and will it work. If not please can soemone let me know where I can get other roms for this device. I am a t-mobile users, and the phone keeps on freezing when I enable push mail.
Cheers
The vario is the wizard while your device as you know is a prophet. Attempts to put wizard ROM on prophet "as is" were made with WM 6 but the results were unusable.
Chances are you will brick your device completely.
But note this: you push-mail problem shouldn't require a ROM change. All orange customization is in the ext ROM so try hard resetting your device, the soft resetting just after you finish all the calibration and stuff so the ext ROM wouldn't install. Then get the proper connection setting for T-mobile and see if it works.
Thanks for your help, are there any other Rom's I can install on that device ie, Imate or XDA. This way I will remove all the Orange setting of the device.
I have entered all the t-mobile gprs settings on the device, but it still frezzes every so often, but everything works still the web and email. I am not happy with the device fall asleep for 30 sec or so.
Cheers
Try the forum search for the Qtek 2.20 WWE ROM! This ROM is in english and have no Ext ROM from a provider such as T-Mobile or Orange! I think this would help you!
You must setup the connection data after finish installing manually but this isn't a big problem!
spv m600
Thanks for you help, if you come accross the link then let me know. I will do some searching over the weekend.
Cheers
Hi @all,
I just upgraded to WM6. Now I have 2 Problems:
1. I can't connet to WIFI Hotspot
2. After Softreset and entering the PIN it says "No service" (but not all the time)
3. I am using Voice Command 1.6 but I dont hear the announcements through my Headset
Can anyone help?
Greetings
Peter
1. Depends on hotspot encryption (you can do this trick: turn on wifi trough wlan manager start-settings-connections-wireless lan, it will turn on and turn off by itself, then turn on wireless trough comm manager, it will start but it will not connect to any network, so turn it off from comm manager and turn it on again and if the encryption is supported it will connect)
2. This never happened to me, try to clean your sim card contacts
3. I had this problem with WM5 also but i not remember the solution, try to search the forums for one
Hi xplode,
1. Solved. At home it works, but at work not. I'll try to find out the problem
2. It's only after a sofreset. When I go from the phone-application into Menu-Options-Network and klick the button "Find Network" then it finds my GSM-Network and everything is Ok
3. Problem not yet solved. Can't find any usable threads.
By the way. It doesn't show at the top of the screen that my headset is connected. I only see it in the phone-application. Any solution for this?
Thanks
Peter
linuxpete said:
Hi xplode,
1. Solved. At home it works, but at work not. I'll try to find out the problem
2. It's only after a sofreset. When I go from the phone-application into Menu-Options-Network and klick the button "Find Network" then it finds my GSM-Network and everything is Ok
3. Problem not yet solved. Can't find any usable threads.
By the way. It doesn't show at the top of the screen that my headset is connected. I only see it in the phone-application. Any solution for this?
Thanks
Peter
Click to expand...
Click to collapse
did you upgrade the radio firmware? I had some issue's with the radio after wm6, I upgraded to 1.15 and all the problems where fixed...
Hi Datake,
It's the original ROM from Helmi. Where do I find the Radio-Update? How do I install it?
Thanks
Peter
NO services gsm, after soft reset
I don´t have apply rom radio update in my qtek 9090 (blue angel)...
My radio rom version is 1.06...
If I apply a soft reset, I lost my signal gsm...
After 2 tries (2 soft reset), the signal come back...
I have a problem when I try apply rom radio upgrade to 1.15.
(connection failed, after activesync is closed in my pc).
(PS: using upgrade_noID)
How can I proceed in this case ?
Help me guys... please...
Rodrigo
Qtek 9090 (blue angel) - WM6 R0 - radio rom 1.06
MS Activesync 4.5
Brazil.
I seek other 9502 ultimate owners and experts advice on the below:
Upon trying to connect to the internet using the GPRS functionality, I always receive the following error message:
“Cannot connect for an unknown reason. To check your connection settings and change them if needed, tap settings. If the problem continues, reset your mobile device according to your manufacturer’s documentation and try again”
I have tried the following steps:
- Reviewed the connection settings picked up by the Imate configurator upon first boot, they were correct.
- Tried to remove the SIM card and use it on my JAMin, the device connected smoothly (with the above same connection settings).
- Hard reseted the device, still it didn’t connect.
- Checked the Operator settings of my provider on the internet, they are the same ones loaded by the Imate Configurator
- Tried another SIM card, same thing
- Went to the service provider and changed the SIM card and got a new one, same error
I shall appreciate any assistance.
UPDATE
Finally!!!!
After installing the new WM 6.1, the device connected smoothly
.
From a 9502 owner
Hi, I have read your post and looked at my Ultimate to find anything obvious and I cannot. I am on O2 in the UK and used the configurator settings which worked fine. If there are any settngs you would like me to verify for you, let me know.
Oh! did you check the phone settings as well as the network connection settings, it's possible that a default in there does not tally with your provider (Goto the Wireless Manager and Tap MENU|PHONE SETTINGS).
Cheers
Eden
GPRS - Ultimate 9502
Thx for your reply.
I have tried every possible combination of Network / Band selection from the phone settings but it didn't work.
Imate have responded that it may be a ROM issue and that they are working on an new updated ROM to be available soon that will probably solve the problem.
Meanwhile i am trying to figure out some registery tweak that could fix the problem (trial and error)
WM 6.1 Link please
Can you please post the link to the WM 6.1 ROM that resolved your problem.
Thanks
iMate 9502 WM 6.1 ROM
http://forum.xda-developers.com/showthread.php?t=407336&referrerid=676710
Hi there XDA ppl
I have a HTC P3600 Trinity, the problems that i have with it is that the bluetooth wont work properly. When i start it and try to connect to a pc, it finds the pc but it fails to connect to it, the same for other phones. I managed to send one file to a Nokia E71, but was not able to be found by that phone when it searched for me.
I configured the bluetooth to be visible, and i made sure that receive all incoming beams was selected.
I have Radio Version 1.56.70.11
ROM Version: WM 6.5 SSD Blue(8) 24001 by The.Decoy
I changed the radio ROM with 1.50 and it still didn`t work. Changed the ROM a couple of times... Same result.
Any chance someone could help me?