Database Users

Mogul Soft Reset loop

Ok I flashed to 20270 rom, and my phone was fine for a while i removed the sd card, and it started a soft reset loop, It will continue to soft reset randomly regardless of if the card is inserted or not does anyone else know why?

Possible the reset button stuck in the "in" position?

Nope the Reset button isn't stuck simply resets at the same place every time if I hard reset it, the loop begins when i reach the end of the align screen setup, It also doesn't soft reset while it's connected to my pc via usb cable

the newer roms require Olipro 2.4 Unlocker. Go to your boot screen (hold power + camera button and hit soft reset) and make sure it says Olipro 2.4. If not, you need to remain in bootloader and unlock it with Olipro 2.4. Good luck!

Major Problem..The device is unable to boot

Hello
I took my friends xperia to install some applications when it happens this:
After i installed AEK software Keyboard Mapper the system asked me to soft reset the device to apply some settings.(The device during this procedure was connected via usb with the pc)
I press "yes" and as usual at the start up appears the sony ericsson logo then the experia logo and finally the device is active.But in my case the phone when it comes to the experia logo freezes..The screen remains illuminated but blank and when iam touching the screen(which is blank) i can hear the sounds of clicking.In this state if i want to shut down the device the only method is to take off the battery.I tried to hard reset the device(when its closed) but unfortunately it wont allow me to do so(i tried with all the possible ways to hard reset the device).At first i thought that the device had hasnt too much battery.I fully charged it and i tried again getting the same results.Please, can anyone tell me what to do?
Edit: After several tries it came up this message "The device is unable to boot because either you have turned off the device incorrectly or tries to install an application from untrusted source.Press volume up to reset or press any other button to cancel etc" Iam pressing the volume up button but nothing happens.Please can you tell me how to hard reset the device?

Here is a link to soft/hard reset tutorial
Hi
I assume you have removed and reinserted the battery?, try this first, if that doesn't work go here.
http://www.xperiax1.net/forum/xperia-x1/546-tutorial-soft-hard-resets.html
P.S This took me 10 seconds to find on google
Ian

Might have to hard reset, if you didn't install a safe mode boot program.

Ianmrr said:
Hi
I assume you have removed and reinserted the battery?, try this first, if that doesn't work go here.
http://www.xperiax1.net/forum/xperia-x1/546-tutorial-soft-hard-resets.html
P.S This took me 10 seconds to find on google
Ian
Click to expand...
Click to collapse
Thanks Ian but apparently you didnt read all the lines i wrote.I said "i tried to hard reset the device with all the possible ways but didnt work" including this way you send me.Thanks anyway

Problem solved
Doing this:
without using the stylus is to switch off the phone,
hold down right and left button (under the screen)
while holding down switch on the phone
release the switch button while holding the two others
then a grey screen must appear saying to push "r" to hard reset or "x" to cancel
push "r" on the keyboard and you're done

Urgent plz

GOOD DAY I HAVE AN HTC BLACKSTON AND HAVE A STRANGE PROBLEM WHEN I FINISH A PHONE CALL THE PHONE FREEZ AND REFUSE TO WORK. AFTER EACH CALL I HAVE TO DO A SOFT RESET CAN YOU HELP PLZ WITH THIS PROBLEM 10XXXXXX

abiis said:
GOOD DAY I HAVE AN HTC BLACKSTON AND HAVE A STRANGE PROBLEM WHEN I FINISH A PHONE CALL THE PHONE FREEZ AND REFUSE TO WORK. AFTER EACH CALL I HAVE TO DO A SOFT RESET CAN YOU HELP PLZ WITH THIS PROBLEM 10XXXXXX
Click to expand...
Click to collapse
Could you provide us with the following info:
Which rom are you currently using?
Have you recently flashed a new rom? Problem may be with this rom in particular
What is your current SPL?
When did this first start happening?
Have you recently installed any apps?
Have you recently changed any registry settings/tweaks?
This may help us narrow down your issue
Ta
Rick

Fallen Spartan said:
Could you provide us with the following info:
Which rom are you currently using?
Have you recently flashed a new rom? Problem may be with this rom in particular
What is your current SPL?
When did this first start happening?
Have you recently installed any apps?
Have you recently changed any registry settings/tweaks?
This may help us narrow down your issue
Ta
Rick
Click to expand...
Click to collapse
good day
* i am using original rom 1.14.421.5 (25590) wwe
*no didnt flash any rom
*IT HAPPENS WITH ME SINCE 2 WEEK
*YES GPS SOFTWARES BUT AFTER the problem
*ONLY THE REGISTARY OF CAM TO SHOW THE EXTRAS AND NETFRAME FROM 3.5 TO 3.7 ALL THIS IS SINC TWO DAYS
NB= MY PROGRAM MEMORY IS USING 45% OF THE CPU IS THAT NORMAL WHEN I DO SOFT RESET IT RETURN TO 37%
thanks

any ideas plz

Hi there abiis,
You can try resetting your phone back to factory settings by performing a Hard Reset. Try to uninstall any programs that you may have recently installed first that may be causing a conflict. You can backup any data on your phone (such as Contacts, Messages, etc) using PIMBackup before you perform a Hard Reset.
To perform a Hard Reset, try the following:
1. With the device turned off, press and hold the VOLUME UP and VOLUME DOWN buttons, then briefly press the POWER button.
2. Continue pressing the VOLUME UP and VOLUME DOWN buttons until you see this message on the screen:
Warning! Your device will be set back to factory default settings. Please ensure any additional installed programs and/or user data have been backed up before a hard reset is performed.
3. Release the VOLUME UP and VOLUME DOWN buttons, press the VOLUME UP button to perform the hard reset, or press any other button to cancel the reset.

Mastoid said:
Hi there abiis,
You can try resetting your phone back to factory settings by performing a Hard Reset. Try to uninstall any programs that you may have recently installed first that may be causing a conflict. You can backup any data on your phone (such as Contacts, Messages, etc) using PIMBackup before you perform a Hard Reset.
To perform a Hard Reset, try the following:
1. With the device turned off, press and hold the VOLUME UP and VOLUME DOWN buttons, then briefly press the POWER button.
2. Continue pressing the VOLUME UP and VOLUME DOWN buttons until you see this message on the screen:
Warning! Your device will be set back to factory default settings. Please ensure any additional installed programs and/or user data have been backed up before a hard reset is performed.
3. Release the VOLUME UP and VOLUME DOWN buttons, press the VOLUME UP button to perform the hard reset, or press any other button to cancel the reset.
Click to expand...
Click to collapse
i know this option but i need a solution without having a hard reset thanks any way

can't you just backup before hardreset ?

To be honest, I think a Hard Reset would resolve your problem with the dropped calls... but if you are unwilling to perform a hard reset, then I would suggest that you try sending your phone back to HTC for repair assuming it is still under warranty?
Best Regards.

well this depends greatly
which end call button is he using. if it the red software one then its a software problem, and this would be remedied with a had reset
if its the one on the bottom of the phone with the 4 button (start call, home, back and end call) then this could indicate a hardware issue and in that case i recommend a return to vendor

help, please!

I installed this HTC Touch Keyboard + Keypad.cab on my mega and it won't boot anymore. It shows the carrier splash screen, but it won't boot up.

Did you try a hard reset?

i did
Am incercat . At that moment i managed to solve the problem. The device is unable to boot screen popped up in the end. and i just pressed vol -. Now i have the problem again. Worse. It won't get passed the carrier logo. What can I do?

Are you sure you performed a HARD reset? Hold the volume keys down when you turn it on then press volume up to reformat the phone, it should boot.

To do a hard reset follow the steps above:
1. Turn off the phone.
2. Press both the Volume Up and Volume Down
3. While keeping pressed volume Up/Down keys, press power button
4. You should see a RGB screen and then a message asking you to press volume up to do a hard reset. Do it.
5. Wait for the process to complete and you will have a clean phone.
If that won't work, you can try to flash the phone with the rom here:
http://htcpedia.com/ruu_mega_htc_europe/soft/mega-touch2-rom?page=2?page=2
Please do not forget to hard reset after flashing.
If even this will not work, you have a hardware problem and you should have your phone checked by a service.
Hope this helps.
Good luck!

it worked with hard reset
thanks. it worked with a hard reset.

Touch Screen Stopped Working

Hi guys,
My Mrs. Orange SanFran has all of a sudden decided it doesnt want it's screen touched anymore. All the hard buttons are working and can not see any other issues. Seems there are several people who have experienced it but it seems to resolved itselfon a restart but her's isn't, no matter how long I take the battery out or pressing the reset under the battery cover I can't use the screen making it useless.
Any ideas? I stuck a custom Rom of 2.2 on it when first got it but can't remeber which one, maybe modaco Kitchen R12 Rom.
Cheers

Reboot to recovery, Wipe both Dalvik and normal cache, and restart. If that doesn't help, do a factory reset / wipe data, and restart. If that doesn't help re-install the rom.

Thanks for the tip, but I tried to enter recovery by holding down volume key when powering up but a screen breifly loaded that had the small text "android" written upsidedown but then just goes on loop of the screen and the standard screen, can't do anything.
Holding up volume whilst powering on doesn;t do anything and because I can't use the touch screen I can't access any recovery apps through the phone OS.
It's weird cause I've used to recovery mode on phone boot before as first ROM didn't work, so I know the recovery module worked before, no idea why not now. :-s

Could be either bad flash/root or faulty hw. Google "de-bricking a ZTE Blade".

Thanks again. Came across a very thorough article on modaco but unfortunately the phone won't do anything than a normal startup when holding the up volume or up and menu, so can't try any of the suggestions.
The volume buttons do work though as moved the volume in the OS

Just to be sure: you did first press & hold the volume down button, and then press & hold the power button? You have to hold them both down until the recovery menu pops up. I can take even 10 seconds or more.

If everything fails, try TPT flash. It should solve if there is no hardware issue.