I just tried to flash my p3600i with a rom but it got a corrupted image and my device wont get past the boot screen with the htc icon. I cant get into bootloader since my power button is broken. I did some testing and the switch isn't at fault either.
EDIT:Fix it, here is how I did it for other people. My power button problem was because it got water in it so the main board swell up. I used a solderer and melt the swell part and then the power button work.
1: Boot into BL (camera + power + reset hole)
2: Download the GPS enabled ROM from HTC Support, NOT from a rapidshare/megaupload/4shared etc.. mirror.
3. Flash the ROM, but use the hardspl flasher.(For some reason, it doesn't go error 270 if I use this flasher).
4. Hard Reset again.
Related
Hi my tmobile wing that i bought off the craigslist is stuck on the main screen with tmobile and is not going beyond it
can some one please help me how can i make this phone work again
Try a hard reset
(hold down both soft keys and poke the stylus through the hole on the side of the phone under the volume slider)
If that doesn't work, you need to install this :
T-MOBILE STOCK RUU
In order to run this, you'll need to plug your phone to your PC via USB, then go into bootloader mode ... which means you need to hold down the camera button (and keep it down) while you soft reset (poke stylus through hole under volume slider)
When your phone is in bootloader mode, and plugged into USB, it should show "USB" in the corner... once that happens, run that file which will take the phone back to factory settings.
duprade said:
Try a hard reset
(hold down both soft keys and poke the stylus through the hole on the side of the phone under the volume slider)
If that doesn't work, you need to install this :
T-MOBILE STOCK RUU
In order to run this, you'll need to plug your phone to your PC via USB, then go into bootloader mode ... which means you need to hold down the camera button (and keep it down) while you soft reset (poke stylus through hole under volume slider)
When your phone is in bootloader mode, and plugged into USB, it should show "USB" in the corner... once that happens, run that file which will take the phone back to factory settings.
Click to expand...
Click to collapse
Thanks a million for the help now my wing is working again !!!!
duprade said:
Try a hard reset
(hold down both soft keys and poke the stylus through the hole on the side of the phone under the volume slider)
If that doesn't work, you need to install this :
T-MOBILE STOCK RUU
In order to run this, you'll need to plug your phone to your PC via USB, then go into bootloader mode ... which means you need to hold down the camera button (and keep it down) while you soft reset (poke stylus through hole under volume slider)
When your phone is in bootloader mode, and plugged into USB, it should show "USB" in the corner... once that happens, run that file which will take the phone back to factory settings.
Click to expand...
Click to collapse
Ahhh... it's not working, the utiltu says that it can't connect to my phone. What do i do. Is there some thing in settings or some hting that i need to change. PLease help. The stcuk screen is really getting me scared.
Wont Run Bootloader
I have tried holding the camera button and soft resetting multiple times, but it keeps getting stuck on the tmobile screen? What do i do??
After I flashed a ROM for the just clean oven, I had this same problem.
I fixed it (after many hours) by downloading this ROM:
http://www.mediafire.com/?clvw3cvyclo
Entering bootloader (hold in camera button and soft-reset.)
Running the tmobile rom.
It was very strange, it took 3 or 4 tries, but it eventually worked.
I don't understand why, since I did nothing differently, but try it afew times.
Hope you get it up and running soon!
BTW, what are your SLP numbers shown on the bootloader screen?
thx really worked
tryed like 4 times then it worked
PuffyTacos said:
After I flashed a ROM for the just clean oven, I had this same problem.
I fixed it (after many hours) by downloading this ROM:
http://www.mediafire.com/?clvw3cvyclo
Entering bootloader (hold in camera button and soft-reset.)
Running the tmobile rom.
Click to expand...
Click to collapse
...worked for me as well. Now, I'm too chicken to run the Hard SPL.
Hey guys,
So I've decided to flash my mates hd 2 with win 7.
i downloaded the rom from the forum which has the loader (i think).
i watched the video demo on youtube and followed the instructions there.
when I boot up the phone after rom updater, I can't get into the bootloader! all I can see is htc logo and nothing happens.
What do i do? Have I bricked the phone?
Please help!
emclondon said:
Hey guys,
So I've decided to flash my mates hd 2 with win 7.
i downloaded the rom from the forum which has the loader (i think).
i watched the video demo on youtube and followed the instructions there.
when I boot up the phone after rom updater, I can't get into the bootloader! all I can see is htc logo and nothing happens.
What do i do? Have I bricked the phone?
Please help!
Click to expand...
Click to collapse
With the phone turned off, hold the volume down button on the side of the phone and press the power button. Keep holding the volume down button until you see the tri-colored screen (this is bootloader).
at this point i would suggest you flash task29, enter tri-colored screen again (bootloader), then flash magldr v.1.12, then let the phone boot into magldr, choose option 5 and flash wp7.
Hi,
I cannot get into the tri-colored screen now! thats my problem. I updated HSPL to *.HSPL, and tried updating the rom and this happens!
I have tried the reset method by holding Vol + and - keys with Power button, but that doent help too
how do i used task29 when i cant get past the HTC logo on the phone?
emclondon said:
Hi,
I cannot get into the tri-colored screen now! thats my problem. I updated HSPL to *.HSPL, and tried updating the rom and this happens!
I have tried the reset method by holding Vol + and - keys with Power button, but that doent help too
how do i used task29 when i cant get past the HTC logo on the phone?
Click to expand...
Click to collapse
try soft reset. remove the back cover then press a blunt pointed object such as a pen or stylus into the reset button to the bottom left of the SIM, near sd slot, and release. The phone will then reboot. try to get into bootloader as soon as it restarts
hi, i tried installing the rom again, and i get some cpp error?
dont know why.
i tried reverting back to stock rom, installed it successfully, and now when I unplugged the mobile, it turns off. when i plug it in it turns back on and it loops at HTC logo i mean, I turns itself off and turns itself on.
why do you think this happens?
Hi,
The problem is When I plug in my phone to USB, it boots up shows a HTC logo, with
R 2.06.51.07
G 15.30.50.07 U
D 1.66.76641
written in red on left corner and holds on for a few seconds and turns off, and turns on itself.
end note: the phone only starts when I plug it to USB, else its a brick
Hi, I was in the middle of Flashing my Acer Neotouch S200 when the usb got knocked out. I now cannot get back into bootloader mode at all. I try to do this by holding the camera, volume and power buttons while holding down the reset button.
I simply go into the clean boot screen where it is stuck. Please, please help! Is there anything that will let me flash it again?
One other thing, if an microSD card is inserted into the slot and I try to get it into bootloader mode, the blue led turns on then the red led flashes twice every 5 seconds. Is that normal because it did it before the flashing process was interrupted but when I took the microSD card out the PC would recognize it to be in bootloader mode.
I tried looking on other posts but nothing worked
Problem Solved!I managed to get it into bootloader mode by pressing volume down, camera and power buttons while holding down reset rather than having both volume buttons.
did you do backup?
please i need an English rom to install in my s200 neo touch acer. my acer s200 is stuck in clean boot, i was able to get to bootloader and my acer usb port was installed on my pc, now i need to flash and installed a new rom but i dont have a rom and dont know how to installed it. please helpppppppppppppp. my acer rom is s200_2.003.00_IT but i want an english rom as this one is in italy. Thanks
owltop420 said:
Hi, I was in the middle of Flashing my Acer Neotouch S200 when the usb got knocked out. I now cannot get back into bootloader mode at all. I try to do this by holding the camera, volume and power buttons while holding down the reset button.
I simply go into the clean boot screen where it is stuck. Please, please help! Is there anything that will let me flash it again?
One other thing, if an microSD card is inserted into the slot and I try to get it into bootloader mode, the blue led turns on then the red led flashes twice every 5 seconds. Is that normal because it did it before the flashing process was interrupted but when I took the microSD card out the PC would recognize it to be in bootloader mode.
I tried looking on other posts but nothing worked
Problem Solved!I managed to get it into bootloader mode by pressing volume down, camera and power buttons while holding down reset rather than having both volume buttons.
Click to expand...
Click to collapse
You Done Good Thing for Correct Bootloader Mode Instruction. . .
Thanks For Share Buddy!
Now You Can Search in google this >>> OS_ACER_2.003.00.EN_WM65_neoTouch
and Install ENGLISH ROM!
Good Luck!
Ok so, I was going to flash CM 9 v1 on my device, and when i was in clockworkmod recovery I noticed that the power button wasn't working at all.
I took out the battery and put it back and then it reboot itself and got stuck on the unlocked padlock screen.
Then i managed to boot it by pressing vol up and down at the same time and putting the battery in when plugged on the computer with the usb cable. This is the only way i can boot it. And after it runs a while it crashes and reboot into the unlocked padlock again. And this over and over.
Then I tried to go to recovery to reflash with the soft sensitive buttons and the fastboot screen doesn't do anything at all. If I press vol up or down to move around it gets stuck.
Got it to work a while and reverted back to stock rom with rom manager to see if fastboot worked again but nothing happened.
I need help to fix this.
I try to go to download mode but it doesn't work either. ADB works tho
Any suggestion??
(sorry fot the bad english)
i actually had the exact same issue a few weeks ago
it was an issue with the power button itself since i got everything back to stock and the power button still wasnt working properly
i had to send it to samsung repair center
they fixed it for free and it turns out the issue was indeed the power button
thank you for your answer!
i will send it to samsung!
after a lot of fail attempts on flashing different roms and a lot of research, i found no way to unbrick my phone. so here are the simtoms :
1. the phone does not boot or load anything when i put the battery and try to start it normaly(it only vibrates).
2. i have tried already V+/- buttons + Pwr on button for pink screen etc. but no response from the phone.
3. i plugged the usb cable without the battery and i pressed the same key combo but still nothing, it only just vibrates.
4. i used a FAT32 2GB sd card with the dloader and i pressed the V+/- + the PWR on button but the updater never showed...
so i am still a bit confused of how can i fix this kind of brick....
extra info :
1. used to have stock rom, froyo but i cant remember the version...
2. twrp 2.5 not sure about the version
3. the pc recognises the phone as: Ideos USB Device (info from USBDeview)
bump up
How you bricked it would help a bit to troubleshoot.