So, I've been using an Android ROM I found on the net on my vogue for some time now, but now I want to try out some other ROMs. However, the RUU requires a connection to ActiveSync, which isn't posible from Android. Anybody know how to do this?
All you have to do is hold the power button and take the pen and soft reset at the same time the phone should go into the hard SPL mode.. From there start up the romupdate you should be good to go
I tried that already, all it does is reboot my phone. No hard SPL mode
Hold the power and the camera buttons and reset to put it in bootloader mode
Ah yes that worked, thanks a lot .
Related
Hi,
Recently my pda(k-jam) fell from my pocket and it hanged. I did a soft reset but I get this error message "Press Send to restore factory defaults, Other keys to quit"
I tried all keys but in vain. I then did a hard reset by pressing the comm and the voice dial. (did a reset with my stylus). I still get the above error message.
Does anyone have any suggestion or idea how to reset my pda?
Thanks alot.....
Y dnt u flash it with a new Rom look around the forum for the new MOSKI ROM.
Thanks
Thank you for your suggestion, I will think of upgrading to molski.
But will it upgrade ? As a hard reset also doesnt seem to work and how do I get to reach the ROM if I am not able to see the other things?
Thanks
Please help...
Hi ,
I am a newbie and so would seek alot of help. Thanks in advance...
Couple of days back my pda fell and now after soft or hard reset the screen still shows this "press send to restore to factory defaults, other keys to quit"
I would like to upgrade to molski but they say I might have to downgrade my rom but I must first unlock the device. There are g3 or g4 device..how do I know what device my k-jam is...g3 or g4? How do I follow up or know?
Could anybody give me the link or solve my problem? As my k-jam just wont pass that screen..I tried looking into various topics but couldnt go about the first step I should be taking...
Please help!
Thanks
Hi,
Please help..after hard reset, it still does not happen to load into the factory defaults... I cant flash my ROM or anything ...as it wont progress further than that screen ... "Press Send to load factory defaults, or quit"
Anyone have any suggestion?
Hold down the camera button while resetting it. If you can get it to the bootloader (three color screen), you might be able to flash it with something and possibly rescue it. It does, however, sound like you might be screwed. Things break when you drop them, including plastic phones.
hi
Thanks but if I have to do a hard reset, I would already be holding the comm manager and the voice dial with the stylus to reset. Do I hold all the 3 buttons together while hard resetting ?
I have tried all the buttons after doing the hard reset but just doesnt get to the other screen.
Thanks for your help.
Hold down the camera button, Power Button and Pin in the hole. First relese the hole, then release the power button and keep holding the Camera button dis will bring the Tri-colour screen. There'll be some info. like IPL n SPL der
If IPL n SPL are like:
IPL 2.xx.xxxx or 1.xx.xxxx
SPL 2.xx.xxx or 1.xx.xxxx then ur device is G4.
if its like:
IPL 2.xx or 1.xx
SPL 2.xx or 1.xx then ur device is G3
if its G4 you need to CID Unlock that before upgrading it.
All the LUCK. Go Ahead.
Hi
Thanks,
I tried your steps but it still wouldnt work. But somehow I did the switch below the comm button and it showed me the screen to the somethign HTC innovation or like that.
I think I had to tinker with the switch below the button to get the screen working.Thanks for your help.
One fine day it refused to startup. No matter how many resets i do it always hangs up at the startup screen. "windows mobile" written on the top and HTC at the bottom. Tried soft resetting, hard resetting, nothing works. Am able to get into the bootloader mode though(by pressing ok button and power button then hitting reset, no clue what that mode is for.)
I have no clue what to do ? how to get it to work again. Could some one help please??
is this on a 6.1 rom?
if so
Get into bootloader mode (side ok and power buttons and reset)
Test for bad blocks via mtty and fix if need be.
Flash carrier rom (AT&T official rom reccomended)
Reflash 6.1 rom
however if it is just from official rom go to bootloader mode install hardspl and reflash your current rom
this is not a question,but sollution
i installed hard spl on x1,and the try to update with generic rom,and i stucked on 10%.when recovery was finish,nothing changed.10%again.i try with another rom,and it's installed to 100%,but x1 then keep on restarting.it's not even reach the main window,but stucked in 'sony ericsson'.if you have this issue,read tips below.
1. make x1 in bootloader mode (hold down volume down+power button)
2. hard reset your device
3. voila
xperia won't hard reset,if he won't be in bootloader mode first!!!and you need to instal at least one room to 100%.
rakec00 said:
this is not a question,but sollution
i installed hard spl on x1,and the try to update with generic rom,and i stucked on 10%.when recovery was finish,nothing changed.10%again.i try with another rom,and it's installed to 100%,but x1 then keep on restarting.it's not even reach the main window,but stucked in 'sony ericsson'.if you have this issue,read tips below.
1. make x1 in bootloader mode (hold down volume down+power button)
2. hard reset your device
3. voila
xperia won't hard reset,if he won't be in bootloader mode first!!!and you need to instal at least one room to 100%.
Click to expand...
Click to collapse
hi,
am having problem here. doing something wrong while flash rom & my x1 bricked. now bootloader shows no image. when turn on it stuck at sony logo.
how do i overcome this? please help.
me too..
just want to install the Energy Leo (this is my first time, n i've done the HARD-SPL before install the ROM)
did u mean that i should enter the bootloader mode n do the hard reset while in bootloader mode?
Thankyou very much!
sorry if my english is bad..
3rd party world..
fully bricked
Hi
After last power off Xperia X1 dont wake up at all
- no bootloader
- no hard reset
- no power up
- no any single spark of life
Is there some trick or JTAG to wake up the phone.
Thanks in advance.
charge the phone completely, enter bootloader using the camera button+power button, task29, then flash via RUU
task29 saved me after bricking my phone few days ago when my device disconnected during a rom installation... something i tried and hoped it worked then it did... RUU wont even install unless i task29 that heartbreaking moment
What is task29
Suhel28 said:
What is task29
Click to expand...
Click to collapse
its the miracle task
inheaven said:
its the miracle task
Click to expand...
Click to collapse
very funny can you please elaborate..
I would also like to know of this task of 29.
I'm screwing around allot on my phone and an accidental brick'ing would like to be un'bricked.
hi, i am in need of som serios help, im a total noob n i flashed my first ROM with Duttys_Leo_Sense_2.5_5.21905.5.0.93_2.13_Radio_2.10.50.26_HG_V3.4.exe
i then last night decided i wanted to switch over to Miri_Steve0007_Elegancia_V8.5
and now the phone will not reset and has a million crashes! iv been trying to go back to the Dutty ROM bt it dosnt let me. can som1 upload what it is that i need to get the dutty rom bak. thank u in advance
when you say crashing, can you give a bit more info? is it locking on a cirtain screen? or in a constant reboot?
you may want to also read through a few of the stickys as if you use the search you most likley will find the cause.
RE: HELP!
More info would be appreciated but I've had issues before and did this:
Performing a factory reset using phone buttons
If you cannot turn on your phone or access the phone settings, you can still perform a factory reset by using buttons on the phone.
With your phone powered off, press and hold the VOLUME UP and VOLUME DOWN buttons.
While holding the volume buttons, press the END/POWER button briefly and then release it.
When you see a warning message on screen, release the VOLUME UP and VOLUME DOWN buttons.
Press the VOLUME UP button to perform the reset, or press any other button to cancel the reset.
From that my phone turned on and I was able to create an activesync connection again to flash another ROM.
__________________
Blog: jonathanstowell.com
Rasheduddin said:
hi, i am in need of som serios help, im a total noob n i flashed my first ROM with Duttys_Leo_Sense_2.5_5.21905.5.0.93_2.13_Radio_2.10.50.26_HG_V3.4.exe
i then last night decided i wanted to switch over to Miri_Steve0007_Elegancia_V8.5
and now the phone will not reset and has a million crashes! iv been trying to go back to the Dutty ROM bt it dosnt let me. can som1 upload what it is that i need to get the dutty rom bak. thank u in advance
Click to expand...
Click to collapse
I flashed many roms and never experience like that as long as you do it as per instruction/ guide in the relevant ROM.
I would suggest you to go into bootloader screen (turn of you phone, then press vol up and down together with the power on button).
Install HSPL (only if you havent installed it), perform task 29, flash the radio (check the radio version required by the ROM), and flash the ROM you want.
Everytime the process reach 100%, you press the vol down button to go into bootloader screen so you dont need to pull out the battery or the cable (but for the last process (flashing the rom), you should press vol down and up together (it will go to hard reset). And for better result, please make sure your battery above 50% and use win xp.
Hope you can solve it.
I desperately need an alternative way to hard reset my hd2. Holding the up down button and shortly pressing the on/off button just switches the phone on. No reset. btw I cant start up normally so the software approach doesn't wort either.
Peter65nl said:
I desperately need an alternative way to hard reset my hd2. Holding the up down button and shortly pressing the on/off button just switches the phone on. No reset. btw I cant start up normally so the software approach doesn't wort either.
Click to expand...
Click to collapse
Use the reset button on back whilst holding up/down buttons
a few people have commented on the difficulty of getting both up and down pressed correctly.
I find I get a much better press with the battery cover off, and I press one first, then the second.that way you can feel them connect individually.
Why don't you guys use the build in software to hard re-set the devise.
1] Press Star Icon
2] Press Setting Icon
3] Press System Icon
4] Press Clear Storage Icon
That should start a hard re-set on device and re-store everything back to original configuration.
maniep said:
Why don't you guys use the build in software to hard re-set the devise.
1] Press Star Icon
2] Press Setting Icon
3] Press System Icon
4] Press Clear Storage Icon
That should start a hard re-set on device and re-store everything back to original configuration.
Click to expand...
Click to collapse
why don't you read the opening first again?
the dude can't use the software approach because his windows won't start, remember?
what about using task 29 or the reflash original splash screen while its doing its thing you can use both hands to hold the vol buttons, other than anything else suggested i dont thinj there us another way to hard reset other than reinstalling your rom maybe fix the software wipe storage app.
That works!
11calcal said:
Use the reset button on back whilst holding up/down buttons
Click to expand...
Click to collapse
Thanks, finally got the thing going again.
I have the same exact problem. None of these methods are working for me. Is there anthing else I can do?
Same for me. Locked out of the phone completely. When it boots it only gets as far as the O2 start up screen and doesn't get any further. Hard and soft reset do nothing. Have tried all suggested here already.
When I get to the screen where I'm prompted to press Volume up to restore, it goes straight to 'restore completed' in a fraction of a second, then back to the start up screen when I press Volume up again.
Need help as I now have an HTC paperweight and no phone!
sonicuk said:
Same for me. Locked out of the phone completely. When it boots it only gets as far as the O2 start up screen and doesn't get any further. Hard and soft reset do nothing. Have tried all suggested here already.
When I get to the screen where I'm prompted to press Volume up to restore, it goes straight to 'restore completed' in a fraction of a second, then back to the start up screen when I press Volume up again.
Need help as I now have an HTC paperweight and no phone!
Click to expand...
Click to collapse
Been using magldr? Cos hard resetting with magldr installed just affects magldr, hence a very short reset time that does nothing.
samsamuel said:
Been using magldr? Cos hard resetting with magldr installed just affects magldr, hence a very short reset time that does nothing.
Click to expand...
Click to collapse
No, I don't even know what that is. I'm not very technical and all I had installed was Cookie's Home Tab Editor.
I have the same problem.
My HTC is blocked ( the WM "forgot" the password that I set - a common problem ), so I have to do a Hard Reset that doesn't start.
I can't reflash or do anything else ( as told here ) without instaling HSPL first. As this can only be installed by the Active Sync, and Active Sync doesn't connect to blocked phones, I can't do anything else...
Is there a way to do anything else with only a new ROM in the sd card ? Or I REALLY have to install HSPL first ?
Thanks,
Leo
leodino said:
Is there a way to do anything else with only a new ROM in the sd card ? Or I REALLY have to install HSPL first ?
Click to expand...
Click to collapse
It is possible to be stitched from a SD-card without reinsertion HSPL. It is desirable to stitch official ROM
It is desirable SD-card to format a feather an insertion.