Broken LCD - Touch HD General

Hello all,
My Touch HD slipped from my hands and ended-up flat on the screen... the screen does not have a scratch, the digitizer still works perfect, but the LCD underneath is broken, so I get a black screen. I can still access the Touch HD via my PC thanks to MyMobilier, though (so why do I complain, huh?!!)!
I ordered a replacement LCD in Hong-Kong (thanks ebay!), got the HTC Service Guide, managed to remove the antenna cover (tough!) and dismantle the whole thing. But NOW I AM STUCK with the 'bezel', i.e. the cover, screen, digitizer, LCD, and metal plate with bolts all apparently glued together.
Anyone faced the same problem? Anyone knows how to separate the LCD from the screen and digitizer?
Cheers,
FroggyZ

Up
Anyone can help with this???

Related

touch screen problem

hi my wizard touch screen barely works now im hoping it is only the makeup my wife has gotten into the sides. I have it taken apart now and cleaned up but the is ablack spot on the cable for the digitizer I think that's what it is the screen ontop of the lcd. if the digitizer is bad is there any way to tell before I put it back together again. its just a small dot not near the copper part. any help would be appriciated. thanks!!!
anyone????

Difference between the lcd and digitizer????

I have sadly broke my screen but it looks fine, it's just the touch not working. Im new at this and I have no clue what the difference is between the lcd and the digitizer. I need to know what to replace on this. please help.
screen and digitizer
the screen is the actual lcd display while the digitizer "touch" part of tthe screen. now i havent replaced the screen on my wing yet but most units the screen and digitzar are one complete unit sometimes the digitizer can be seperated with a razor blade (not recomended) personaly i would replace the entire unit (lcd and digitizer)

Replacing LCD screen

My touch hd has a faulty LCD screen, and I've bought a new LCD screen spare part, just so I could replace it myself. I'm trying to change the LCD to the new one, but am having problem removing the old LCD from its front housing. Could anyone help me with this? I've removed all the screws, and tried to pick on the side to remove the LCD, but have failed to remove it.
Thanks in advance!

Repaired cracked screen...how do i glue it in?

I have an HTC HD2 which had a cracked screen. I repaired it with a new screen, but I don't know how to adhere the screen to the chassis. What is the proper way to do this?
I tested it, and everything works now...but the screen stands off the chassis too far. It's not sandwiched down enough, so the talk/end etc buttons don't have enough travel to activate the pcb below them.
Can someone give me some advice? Thanks.

[Q] I think I broke my Digitizer

Hi
Yesterday I Replaced my Speaker, when I opend my HD2 I accedently lifted up the Glas from the LCD. I think the Glas is the Digitizer too. So now when I use the Touchscreen it clicks Randomly or slides randomly. What could cause the Problem and can I repair it?
thx for your help
if im not mistaken the digitizer is attached to the lcd glass facing down. might need to replace
you can replace the digitizer without the lcd panel, but it isn't easy to replace it because you need to seperate the digitizer from the lcd and the lcd can breake. it is easier to replace the digitizer with the lcd panel in one peace.
unfortunately it is more expensive than only the digitizer.
if you replace the digitizer you have to stick it to the lcd panel and it must be in the right position(as before)
After a few tests I found out that not the Digitizer is broken. Its a little tape like thing on the side of the screen(digitizer). Is this possible?
Sent from my HTC HD2 using XDA App

Categories

Resources