i-mate kjam freez on startup screen after upgraded to wm6 - 8125, K-JAM, P4300, MDA Vario General

i-mate kjam freez on startup screen after upgraded to wm6
i instalem wm5 too but the problem is on startup.
the phon hung in start up and restart after fewe 3 min.
the screen on start up no change after install wm5.
my detail is

help me please.

try a hard reset.

Related

imate jasjar: locked after rom upgrade

hi.
i have imate jasjar with italian language.
i have downloaded new firmware from imate site, connected my jasjar to my pc and launched upgrade procedure.
The upgrade procedure will start and then after that my jasjar will reboot by the upgrade utility.
But my jasjar will not power on.
I have wait 15 minutes.
Than i have disconected from pc and reset, hard reset my jasjar.
I removed battery and reinserted...but mothing.
When i power on the jasjar it write on the screen: SERIAL....V. 1.00...
wHEN I do an hard reset, on the screen menu i try to type "x" to hard reset...but nothing.
What can i do ? Thanks at all.
The device is now in bootloader mode. Just reinstall the ROM all over again. Try on a different PC if it doesn't work on yours.

problem upgrade to 2003SE

Hi there,
I tried to upgrade my wallaby PW10A to WM2003SE everything goes right but when I soft reboot it freezes on the OZUP screen I tried to downgrade to PPC 2002 I have the same result,did someone have resolved this pb?help me please

Qtek S200 not respond after upgrad ROM finish

ISP : 2.09
SPL : 2.15.0000
GSM :02.19.21
OS : 2.9.7.29
after upgrade ROM finish. Wifi not respond when i turn on nothing to happen. How to do?
qtek s200 not starting
after i upgraded to wm 6.1 i maked a soft reset and the phone dont shoes the os
when start and the screen goes blank please help me :'-(
qtek s200 not starting
\]after i upgraded to wm 6.1 i maked a soft reset and the phone dont shoes the os
when start and the screen goes blank please help me

QTEK 9100 StartUp Problem..

Hi Folks
I've got a Qtek 9100 with IPL/SPL 2.21 /02.07.10 / 2.18.7.7 ROM
When I tried to install TT6 - Setup finished with Reboot. Now System
hangs /freezes at the Windows Mobile Start Logo..
Reset res. Hard-Reset won't work .,. system still hangs...
Any suggests to this prob?
Cheers
WTK

PROBLEM IN K-JAM " restarting in port loder"

Hi all
i have a k-jam .. the problem started when i decided to upgrade my k-jam
i was using wm5 official one
and then i upgraded to TNT.19213_Official_Wizard 6.1
i tried to install arabic fonts and then uninstalled it
and decided to go bac to windows mobile 5
when i try to upgrade my k-jam begin restarting in port loader with that screen RGB after message in window ERROE 302
when i take out the bettery and start it.. in RGB only.. and when i try to upgrad to WM5 or WM6.1 that window appears again and my k-jam will begin resrating in that screen
please help me in that ...
Thank you

Categories

Resources