So my Hermes (SPV M3100) died some time ago...
The phones battery was not complete dried out (around 10% of energy was left) but I tried charging it. As soon as I connected the charger the phone turned off immidiatly and I was unable to turn it back on - there is no reaction from it.
What could be the problem? My pops tried fixing it but nothing irregular could be found...
Do any of the leds light up when the charger is plugged in?
Mike
No, there is no reaction from the phone in any way.
Then there is a good probability it's the internal fuse that's blown. (Assuming the charger is working OK)
Hermes Fuse Location.pdf
Mike
Thanks I'll check it out.
Yesterday I had the same problem.
I was talking with my phone and suddenly it turned off, my battery was at 90%.
I try to have a reset but there is no reaction.
I plug in the charger but nothing happend.
What can I do?
Thank's
So I checked those and they're completely okey. Can there be anything else?
Related
My friend dropped my phone (Orange SPV C500) a few days ago on to a tiled floor. The phone didn't appear to be broken or faulty at all at the time. I even managed to use TomTom navigator to go to the airport, but for some reason when I looked at it before I went to sleep, the phone was off. I assumed the battery had gone (even though it should have lasted at least another day). I tried to plug in the mains charger, but the LED showed a red light. I left it plugged in while I slept, but it was the same in the morning. The phone won't power on at all. I've read that this normally happens on a flat battery, but I am pretty sure it still had juice for another day.
I brought a new battery, but to no avail, the phone still shows the red light when plugged into the mains. No light at all when plugged via USB to my computer. The phone won't power on at all.
It must have broke something when it was dropped. But I'm confused as to why it took a few hours to take any effect.
I also notice that even without the battery in the phone, the LED will still light up as red when plugged in to the mains.
I've tried whacking the phone now, but nothing. Anyone have any idea whether it can be fixed?
2 days ago i had my cingular 8125 plugged into a charger . when i woke up it was off and dead, still plugged in?
now when i plug it in (to the stock charger) the red light comes on, but if i take the battery out, it stays on. if the battery is in, it is on. but i cant turn it on. ive left it for 15 hours now, and still nothing
even tried another battery.
when i first put the other battery in it turned on, was booting, but then died. probably cuz the battery was dead. but i had it plugged in as soon as i turned it on.
now the same thing happens.
any ideas?
i also thought i smelled something burnt. like if you have ever had a laptop that had a bad a/c connector and would heat up a bit, or even smoke!
dont know if it was my imagination or what?
thanks in advance
dan
T mobile MDA shows RED LED
that is strange that you post this today, because I just received T-mobile MDA unit from 3bay that has a similar problem.
-The phone does not turn on when I press the power button.
-It does not respond to a soft reset or a hard reset.
-With the battery in, I connect the AC charger to the phone and for about 1-3 seconds the charging LED color is RED. THe LED turns off and I can not get the same result if I reconnect the AC charger.
The only visible sign of life this MDA unit has is:
-with the battery out and the AC charger connected, when the USB is removed to the point where it is not connected to the MDA, the charging LED light flashes red for a split second and the screen flashes white for a split second as well. [I hope this is a sign that there's still life in this MDA, but i'm thinking my unit is truly a brick..]
From all the websites I've searched, this does not seem to be an issue, although for me it is a scary one! Anybody that can help would be much appreciated because I want a working MDA not a dead one
EDIT: It turns out my non-booting MDA was due to a faulty vibrator and flashlight MDA part. After removing these two pieces that are connected to the back cover of the MDA housing, the MDA booted up with no problem.
danrw84 said:
2 days ago i had my cingular 8125 plugged into a charger . when i woke up it was off and dead, still plugged in?
Click to expand...
Click to collapse
I'm in exactly the same position - left phone on charge overnight two days ago and in the morning it was completely dead. I have managed to get it to power on for about 2-3 seconds on one or two occasions but now it won't do a thing
Not sure if this will help, but have you tried to push that soft reset button that you have to to push with your stylus when it is plugged in?
Sounds stupid, but my power button is completely dead and I thats how I have to start mine up. I also have to pop out the SD card to get the screen to come out of sleep mode!
I might not work, but hey...worth a try.
Well, I eventually got back up and running. Turns out the battery was completely dead. I used the 9v battery trick and then used my USB charger to get the battery fully charged and all is well.
This leads me to query how do I now charge my phone when I don't have access to a PC? I was using a standard AC wall charger and the phone showed that it was charging but due to the fact that the display stays lit whilst on external power, this eventually killed the battery as the charge indicator appeared to be false.
*as posted verbatim in another thread*
WHAT IS THIS 9 VOLT TRICK YOU SPEAK OF?!?
funny...i'm having the same problem with 2, what were perfectly fine, wizards.
which is what brought me to this forum post.
These two devices were turned off and sat in my desk for months as they were not needed. They were perfectly good, successfully unlocked and upgraded from the advice/steps/tools provided here (thanks!). They were my primary personal and work devices until i was given the option to try a few iPAQs.
Now that I want to go back NEITHER device will boot. On the original chargers (both wall and usb) both devices will display the red light as shown in the pic above, will not boot normally, or via the 2 or 3 button methods common for these devices. The batteries do not get warm, which tells me that they are not getting current...which makes NO sense if i'm using 4 different stock charging options (2 wall and 2 usb) in different locations. One expect some variable would work to eliminate some oddity, but nothing is working.
something odd is going here. how can 2 perfectly good devices and charges suddenly crapout? I could really believe it's the battery, but one is grand spankin new (only used for a month)! Both have the main board die? Both not recognizable on any computer?
Is it possible that the backup battery is causing this? Can it me charged same as the standard if its drained? I know i'm grasping at straws here, but this odd a coincidence.
FOUND FIX
okay..this was too simple.
for some reason the USB will not provide enough"juice" to pop these out of their sleep.
I have been using this great little charging system made by good old Radio Shack that is a single plug with different adapters for all different devices...i've been using it for my iPAQ's, Blackjacks, BB's, ect. SO as a last resort i went and got the CORRECT adapter (as there are many mini usb adapters available) and SHAZAM!!! they boot right up!
don't ask me why the stock wall chargers will not work, but these RS iGo systems are the trick!
i'm going to link to the other similar issue in hopes any other folks having the same issue can benefit from this.
hi! i have a dopod 838 pro. and it suddenly cant turn on. i was just texting then it went buggy (hanging up) then i did a soft reset then all of a sudden it didnt turn on. i was charging it at that time.
the phone never got wet, was never dropped. i installed the official wm 6.1 rom and it had been running for more than two weeks so i dont think the problem was the ROM. battery is good since i still get two days of battery.
i have tried hard resets, used the usb connector to power the phone up. havent tried another battery though. is there any way i can diagnose the problem before spending for diagnostics in the shop?
this was an observation: when i remove the battery and connect it to the charger, LED is red then it disappears when i replace the battery. no amber going. how do i test if the problem is in the battery? battery connector? power? or (please i pray not) the motherboard itself?
a little help please! more power to this forum. thanks!
gab
Would suspect the battery... Red LED WOULDN'T turn on if this was a hardware problem, broken battery connectors and such. However, if you install the battery when the red LED is visible (connected to charger without battery) & it doesn't turn amber (charging) then I'd suspect the battery has died.
Take in to a shop and ask to try a battery, easier if you know someone with the same phone.
Cheers...
i have it sent to the authorized htc center here in our area. the technician tried using another battery but still it didnt work. my phone will be left at the shop for about 4 to 5 days for diagnostics. the technician said that theres a possibility that this may be a motherboad problem like the board short circuited.
but how come? how can this happen?
can anyon confirm that this is a motherboard problem? awh! cant wait for the result of the diagnostics.
thanks!
So, this phone was working without any problems but then my wife turned it off and left it in the drawer for about 3 weeks when she went overseas. When she got back and tried to turn it on it wont turn on. We figured it might have drained the battery so we plugged it in but now its not charging either! When I unplugged and plugged in, the LED blinked orange once but now it wont even do that either, no power, no LED, not charging either. I have tired everything, left it disconnected, battery out for an hour, then put it together and tried to charge, still nothing.
Any ideas? It is already out of warranty so talking to T-Mobile is out of question.
Nothing has been done to it, it is physically fine, it was just off for a long period and not it just wont respond.
Edit: Fixed it! I don't know what, I was almost giving up, but I took the battery out and blew hard on the battery contacts in the phone and in the charging port then plugged everything in and put it back on charger, orange light started to blink and then went solid and now its charging. I just turned it on. This phone is dodgy, no other phone hard bricks like this if you leave it off.
Some phones don't function with completely discharged battery. Actually, most of newer phones. You need to leave the battery inside and the phone connected to charger for some time, till the charging light shows up. MT4G is very far from being "dodgy", doesn't differ from many other phones that behave the same, and you were nowhere near "hard brick".
Good luck in powering up Motorola Defy with completely discharged battery.
Recoverable problem
syl0n said:
So, this phone was working without any problems but then my wife turned it off and left it in the drawer for about 3 weeks when she went overseas. When she got back and tried to turn it on it wont turn on. We figured it might have drained the battery so we plugged it in but now its not charging either! When I unplugged and plugged in, the LED blinked orange once but now it wont even do that either, no power, no LED, not charging either. I have tired everything, left it disconnected, battery out for an hour, then put it together and tried to charge, still nothing.
Any ideas? It is already out of warranty so talking to T-Mobile is out of question.
Nothing has been done to it, it is physically fine, it was just off for a long period and not it just wont respond.
Edit: Fixed it! I don't know what, I was almost giving up, but I took the battery out and blew hard on the battery contacts in the phone and in the charging port then plugged everything in and put it back on charger, orange light started to blink and then went solid and now its charging. I just turned it on. This phone is dodgy, no other phone hard bricks like this if you leave it off.
Click to expand...
Click to collapse
Had a similar problem. Phone died while using it then wouldn't light up when plugged in. Left it plugged in for half an hour wouldn't seem to charge via wall or car charger. Tried doing a hard reset with/without the battery & plugged in/not plugged in in various combinations. Got nuthin. Drove around for hours looking for a replacement or open T-Mobile place, until it got too late and I went home. Live chat with T-mobile rep was a waste of time. Plugged it in the wall and left it, as this once brought back a G2 battery that I thought was cold dead. Five hours later it was lit up and charging, showing 40% charge on the battery indicator app once I turned it back on. "HTC Sense" crashed immediately on boot then recovered. Seems to be fine so far.
- Suggestion; plug it in and leave it overnight if it seems cold dead and doesn't appear to be charging. It seems to need to hit some critical threshold before it will work again (as indicated by previous poster). Also pick up a couple spares off amazon or newegg if you don't have a second phone available.
My P8lite died while charging (was almost full). Does not turn on, leds off, even when I plug it in - nothing happens, does not heat up. Anyone had this problem? Maybe something broke inside?
Have you tried disconnecting the battery? Then try to plug in your charger.
TheOldMan said:
Have you tried disconnecting the battery? Then try to plug in your charger.
Click to expand...
Click to collapse
Yes, right now. Nothing happens. Any other idea?
Went back to life out of nowhere! Maybe it needed to rest a couple of days... So weird!