i have imate contineously restarting on bootloader mode
i also tried to hardreset but impossible
it shows
IPL 2.06
SPL 2.06
when i connent it to PC in boot mode it contineously restaring on boot mode
BR
UMER
Related
Ok here is the "Thing"
i put a hermes ROM on Elf (soft black) and i think the SPL and IPL has changed
its now:
IPL 1.17.0002 ,is it right ?
SPL 1.17.0000, is it right?
and i tried to download the Offical HTC elf Rom but after 2% it restart and write ID Vendor ERROR
what should i do?
P.S:i tried to do SuperCID but it need The ActiveSync Progoram to be ON, im stuck on bootloader Screen
MKR
My problem is, my htc touch elfin? (mda touch elf0300) stuck in bootloader-mode. Is there any Solution to get it working ?.
IPL : 2.26.0002
SPL: 2.26.0000
ELF0300
After 2 % crashed the rom update. I canĀ“t the uspl until again because, the device wont connects to active sync.
Need Help
Thank you
.
i have same problem too, but
IPL 1.16.0002 and SPL 1.16.0000
I also have this problem
IPL 1.16.0002
SPL 1.16.0000
Stuck on bootloader screen none of the usual reset options seem to work and doesn't show up when plugged in to usb port
Help
Thanks Si
i have I-mate JAMin
-----------------
IPL - 2.20
SPl - 2.13.0000
GSM -01.14.20
---------
When i on the phone .phone gon usb MODE. not going ok mode and only show usb mode.
so how can upgrade or downgrad this phone.
plzzzz solvetion want.
plz any one sovlution about this?
Install a original WM5 Rom and read hera about bootloader and hardspl or softspl. Here are so many treads about your problem.
I've tried to flash many roms, but gotten error at 3-5%.
Screen on my pda goes black and pda resstarting...
Please someone can explain, how to flash step by step, and what is reason for error?
When i switch it on I see:
ipl 3.04.0001
spl 3.04.0000
gsm 03.06.90
os 3.4.0.0
win: 6.0 by ferfecir
Now i done I don't know what!
When i go into hardreset, after, i see only IPL and SPL versions without GSM and OS. I do hardreset, cos I can't switch on by POWER button!
Please can someone help me to unlock SPL and reflash normally ROM?
All image files which i've tried to flash trough BOOTLOADER USB mode getting error on 3 - 79%...
Dear All,
Please urgent help required.
my HTC P3300 (Artemis) stuck up when i was trying to start it up. when i use to turn my cell on, i goes to the starting screen shows the following numbers and then stuck up.
IPL 3.07.0001
SPL 3.07.0000
GSM 02.69.90
OS 3.7.0.0
the screen does not move after that. i tried soft reset through the reset button but result is the same.
i also tried hard reset and when i puch the green phone button to proceed, a message come "FORMAT FAILED" and the phone stucks up.
i am quite a lot of problems since i have upgraded to WM6 from WM5 last week.
i am quite sucked with this problem. not been able to use my set since yesterday.
please also note that my HTC was not syncing with my PC since i have upgraded to WM6.
PLEASE HELP URGENTLY.
Nomi
You can tried to reload your last ROM (WM6), for this :
-Start in bootloader mode ("Voice Command" + "Power" + Reset with Stylus)
-Start a new upgrade Rom (With the last ROM)
It's works ?
If yes, you can upgrade Radio and SPL.
i did that but the flash process stopped at 3% (i think CID locking problem). i tried USPL but the process could not be done. i also dont have my previous ROM but i noted the previous numbers which are
IPL 1.14.0001
SPL 1.14.0000
GSM 2.67.90
OS 1.14.0.0
tell me what to do now??
i dont have my previous ROM. nor i know what were the factory provided ROM
please help
You can :
-Flash your original ROM (Operator and langage)
-USPL and 1.11.cmon (verify that your phone is USPL before another action)
-Upgrade your new ROM.
i dont have the original ROM.
the phone is stuck at boot page. USPL not working.
what to do now
You must to download a rom from the Same Operator and same location.