Had the phone sim & cid unlocked and flashed from orange to the new htc upgrade but after putting some programs on it decided to go back to standard htc settings.
Do i now need to unlock again (or everytime i reset it) or is it still unlocked?
Thanks
Robert
I already try with official rom, but my herald is still brick, i can not syncronize the herald with pc to run the official rom.
It is freeze in inicial boot with HTC logo.
help, please anyone....
Try turning the phone off and then turn it back on by holding the camera and communication button. This should bring you to the boot loader screen at which time you can tehter to your pc and run the OEM RUU. That should do the trick.
[Thanks, problem resolved.
German Vodafone Herald bricked
Hello,
could anyone here give me an Original Vodafone Rom to unbrick my Herald? It must not be WM6, WM5 would be sufficient. I only want my device to alive
Or is there another way to unbrick this phone? I only can get in bootloader modus and so i can not start the phone to CID unlock so that i can flash with another ROM like HTC Original.
So Have anyone a possibility to unbrick the phone or CID unlock from bootloader?
For any idea, thanks very much.
Hello!
I have strange problem with my Wizard. 4 month ago i was trying to install Pathfinder 1.2, but when I installing this ROM using ShellTool my PDA bricked. Now all the time it's frozen on Splashscreen with IPL/SPL GSM and OS information. All HR completed without any errors and all ROM's upgrading finish correctly.
Once time, after 2 months for breaking, my Wizard just started and working very well, I do 2 HR and few SR and my Wizard still working good, but when I shut it down and pull out battery my Wizard again frozen and until now can't wake up. I have CID Unlocked by imei-check. I tried to install many different ROM's, e.g. Wizard Love, Dopod (CHS), T-Mobile, Orange (PL) but nothing work. I also tried way with SD Card but my ROM's doesn't work, I think I need some working dumped ROM. I was searching help on few forum but poeple on polish forums don't know how to help me. May someone here have idea where can i find working dumped ROM or have any other idea how can i fix my Wizard?
Thanks for any help
alldoe
PS Sorry for my english
which is your device,post full data of your phone,IPL/SPL...? Make...?
As you say you installed through Shelltool,is it a G4 DOC chip version ?
You say it's stuck at the splash screen with ipl/spl and gsm version,which splash screen,is it OS (Rom) initial splash screen or a Bootloaders (Multicolored) screen ?
Secondly ,try to get it into bootloaders (multicolor) screen,if it gets into bootloaders,connect it to PC via usb cable,check small usb appears at the bottom of the bootloader mode in the phone,if it does,than flash a carrier's official Rom to recover back to it's default status.
Good luck
Try the Button's ROM (which is in Wizard Upgrading subforum). Then unlock it again (It may be causd by a fake CID unlock when you try to unlock when IPL/SPL is 2.xx)
My current
IPL/SPL 2.24
GSM 02.25.11
OS 2.24.10.1
I have G3, but I was using ShellToll because I can't install by RUU file.
My Wizard stuck at ROM Splashscreen, i can get into bootloader screen, but when I flash any ROM, everything upgrading well but after Reboot it still frozzing at Splashscreen. I was tried Button ROM sometimes but it doesn't work, I have CID unlocked by Imei-check.uk and everything is okay, I can install ROM from G3 and G4 chips. And ... I remember, that before CID Unlocking my IPL and SPL have different value.
PS. I was unlocking my CID, after my Wizard bricked.
alldoe said:
My current
IPL/SPL 2.24
GSM 02.25.11
OS 2.24.10.1
I have G3, but I was using ShellToll because I can't install by RUU file.
My Wizard stuck at ROM Splashscreen, i can get into bootloader screen, but when I flash any ROM, everything upgrading well but after Reboot it still frozzing at Splashscreen. I was tried Button ROM sometimes but it doesn't work, I have CID unlocked by Imei-check.uk and everything is okay, I can install ROM from G3 and G4 chips. And ... I remember, that before CID Unlocking my IPL and SPL have different value.
PS. I was unlocking my CID, after my Wizard bricked.
Click to expand...
Click to collapse
You can download this rom CUSTOM__RUU_Wizard_1050412_WWE_101_11210_WWE.exe on XDA,it contains IPL/SPL 1.01,and upgrad this rom,then you'll find your IPL downgrad to 1.01,and SPL still is 2.24,and then,use aWizard tu unlock your CID,after this,your CID should be unlocked,you can use RUU upgrad any rom you want.
I just do this yesterday,my CID isunlocked now.And RUU now works on my device.
luoluomeng said:
You can download this rom CUSTOM__RUU_Wizard_1050412_WWE_101_11210_WWE.exe on XDA,it contains IPL/SPL 1.01,and upgrad this rom,then you'll find your IPL downgrad to 1.01,and SPL still is 2.24,and then,use aWizard tu unlock your CID,after this,your CID should be unlocked,you can use RUU upgrad any rom you want.
I just do this yesterday,my CID isunlocked now.And RUU now works on my device.
Click to expand...
Click to collapse
Hello! I have CID unlocked. When I install Button ROM my IPL and SPL is the same (1.01). Every RUU works but It still frozen. 2 Days ago i found on other forum this advice:
INSTRUCTION :
1. miniSD - formated in PC - FAT format (now FAT32 !)
2. Wizard On and Bootloader (press reset and keep photo button let go reset) 3 color display. Put in card to Wizard.
3. Connect USB - PCC to PC
4. Launch MTTY 1.42 (my ver.) with USB connection
5. Write command - r2sd os end press enter
6. Program it will record OS on miniSD
7. After recording make Hard Reset or turn on Bootloader
8. On Display should be written - Format partition ?? (5 sec.) - to confirm press Voice dial button. If inscription it will disappear repeat point 7.
9. If Format partition successful wait OS is write. Done.
10. Draw out miniSD
11. Make Hard Reset
12. Enter in bootloader
13. FOR NON CID WIZARD - Flashing Wizard RUU (must be proper version) - ERROR 300 is bad RUU ERROR 266 turn off Wizard and turn on connect to PC
14. With CID (for example CID G4) seek forum for flashing Wizard with CID G4
My Wizard it lives
Click to expand...
Click to collapse
I was carry out all command step by step, and after flashing proper version Orange ROM my Wizard woken up, but today my Wizard get stuck again and now this way don't work, and I have to find a new method to rescue my PDA.
My Wizard woke up! I find ERA PL ROM (RUU_Prodigy_3829_382130_027111_TMO_PL_PLK_Ship) which flash excellent and working, but now I have a new problem. I can install other ROM after that but none of them work, every stucked at Splashscreen like before.I need to find some WM6 ROM which will working? Someone have some suggestion?
alldoe said:
Hello!
I have strange problem with my Wizard. 4 month ago i was trying to install Pathfinder 1.2, but when I installing this ROM using ShellTool my PDA bricked. Now all the time it's frozen on Splashscreen with IPL/SPL GSM and OS information. All HR completed without any errors and all ROM's upgrading finish correctly.
Once time, after 2 months for breaking, my Wizard just started and working very well, I do 2 HR and few SR and my Wizard still working good, but when I shut it down and pull out battery my Wizard again frozen and until now can't wake up. I have CID Unlocked by imei-check. I tried to install many different ROM's, e.g. Wizard Love, Dopod (CHS), T-Mobile, Orange (PL) but nothing work. I also tried way with SD Card but my ROM's doesn't work, I think I need some working dumped ROM. I was searching help on few forum but poeple on polish forums don't know how to help me. May someone here have idea where can i find working dumped ROM or have any other idea how can i fix my Wizard?
Thanks for any help
alldoe
PS Sorry for my english
Click to expand...
Click to collapse
i have the same proplem but i have a g4 wizard and it's not cidlocked tell me plz what to do plzzzzzzzzzzzz :'(
Hello. I have a problem...I have the SFR S300+ from France and I want to use it in my country. I did everything written in this thread --> http://forum.xda-developers.com/showthread.php?t=293957 but my PPC is not sim-unlocked. When I start Trin_Unlock_v1.exe from my phone and check "SIM Unlock" the program starts and then appear a screen "Success! Device SIM/Network lock removed" but after that when I start the PPC again there is another screen "SIM Lock" that tells me that I have tried xx times and I have to wait until timeout...
If anybody know how to remove the sim-lock please tell me... I'm trying for a month and I can't find a solution for this problem.
I am with WM6 if it's important
Thanks in advance and Merry Christmas to all
I had to install an old radio rom before unlocking my s300+ (i had to launch the application while using this old rom), don't know if it is necessary though now.
Quote "This is a patched radio ROM that can be used to remove the Operator
SIM lock and CID lock from HTC Trinity based telephones."
I trckon you must run the RomUpdateUtility located in the RUU file in order to flash your device with another radio rom, then you launch the unlocker(sim and cid un locker) . Try with another sim card to see if the operation was successful and if it is the case, flash your device with a new radio rom. Hope i helped (i had the same problem)
I tried with a few radio roms but without success. Can you tell me please with which radio rom have you unlocked your Trinity I am with 1.46.00.11 and the phone is locked
I have the same problem ... I downgraded radio to 1.16.00.00 patched version, executed unlocker but when i reboot ( i tried hard and soft reset ) the SIM was locked yet
any info about unlocked process ???? any reported problem with M700 from Orange ????
Yesss! I did it! It's unlocked I started the "AUTO_Unlock_v1.bat" file and after it finished the radio rom was 1.16...I put the sim card and the phone was still locked... Then I decided to do it in the second way... with the "Trin_Unlock_v1.exe" file transefered on my phone.. But this time I put the file not on the phone memory but on the memory card. When I started the application and it finishes I switched the phone off for a while...(10-15sec.) and then I put the sim card. When I started the phone there was no screen asking me to put a password.
I got old tytn (not from network) from friend. I can't turn on phone in the comm manager. I tried different roms and hspls (1.40 and 2.10). But I can't flesh radio to phone it just got stuck at 0%. After soft reset it got stuck at bootloader, so i need to flesh rom (os) again to run Win. I assumed is locked, so I tried sim unlock v3a from pof, it make no difference.
Can it be hardware problem?
Please help.
I too have the same problem, I can not flash the radio and the phone is not online, I would like some advice, thanks