Database Users

Qtek S200 not respond after upgrad ROM finish

ISP : 2.09
SPL : 2.15.0000
GSM :02.19.21
OS : 2.9.7.29
after upgrade ROM finish. Wifi not respond when i turn on nothing to happen. How to do?

qtek s200 not starting
after i upgraded to wm 6.1 i maked a soft reset and the phone dont shoes the os
when start and the screen goes blank please help me :'-(

qtek s200 not starting
\]after i upgraded to wm 6.1 i maked a soft reset and the phone dont shoes the os
when start and the screen goes blank please help me

nothing helps (stuck in dos, spv m600)

okey... i had WM5
by tutorial on this forums i downloaded RUU_Prophet_220734_2207114_024721_NVID.exe . runned it started to install , 95% - booom! ..
then i tryed to do hard reset , NOTHING happening
i dont remember spl and ipl was before but now they are 2.20 and 3.08 .. RUU
model - htc prophet , spv m600
also it turns off sometimes while instaling those.
EDIT:
i followed this: http://wiki.xda-developers.com/index.php?pagename=Prophet_recovery
after 99% of install it just rebooted and now shows same 3-color dos..
PLEASE HELP ME :\\\

Htc p3400 hanged at start up page onyl

Dear Please help my PDA HTC p3400 has hanged at started up only at front screen only it is not moving further. i had done hard restet also then also not working. Please help me out .
Waitng for reply.

hard reset
Jeet8626 said:
Dear Please help my PDA HTC p3400 has hanged at started up only at front screen only it is not moving further. i had done hard restet also then also not working. Please help me out .
Waitng for reply.
Click to expand...
Click to collapse
do hard reset

i had done hard reset also

Try to bootup without the SD card (and may be SIM), I had this problem with my Vox, the SD Card was corrupted. After formatting the SD Card, everythig became normal.
Best of Luck

Same problem
Jeet8626 said:
Dear Please help my PDA HTC p3400 has hanged at started up only at front screen only it is not moving further. i had done hard restet also then also not working. Please help me out .
Waitng for reply.
Click to expand...
Click to collapse
Hi!
i have the same problemwith my P3400
i have made the upgrade to wm5 to wm6.1
the pda at the first time has booted and i have configured the regional time and the pen alignment until the the screen that says Setup complete, click to proceed (or something like this).
After this, it gets stuck on the windows mobile 6.1 boot screen
i have made the re-update with the same rom update.
the problem persists!
I have made with/without sd card and sim.
Now when it boots apears
ONBL 1.07.0000
SPL 1010.olip
GSM 02.84.90
OS 1.17.0.0
then changes for the wm6.1 boot screen
and stucks here
S/n-SZ716FW06338
XT01
GENE 100 (old gene i think)
please help me
thanks in advance
Pedro Matos (from Portugal)

matosmatos said:
Hi!
i have the same problemwith my P3400
i have made the upgrade to wm5 to wm6.1
the pda at the first time has booted and i have configured the regional time and the pen alignment until the the screen that says congratulations, click to proceed (or something like this).
After this, it gets stuck on the windows mobile 6.1 boot screen
i have made the re-update with the same rom update.
the problem persists!
I have made with/without sd card and sim.
Now when it boots apears
ONBL 1.07.0000
SPL 1010.olip
GSM 02.84.90
OS 1.17.0.0
then changes for the wm6.1 boot screen
and stucks here
S/n-SZ716FW06338
XT01
GENE 100 (old gene i think)
please help me
thanks in advance
Pedro Matos
Click to expand...
Click to collapse
i have done it!
Now i have the wm6.1
i found another rom update! (coooollll!!!!)
heheehehehhe
thanks anyway!

i have the same proplem you had can you tell me how you done it with new rom espiecly i cant flash room and i cant do anything
thanks

for ur info @matosmatos
hi
as per the numbers quoted by u urs is a old gene so falsh roms for old gene only this is just for ur info
goodluck
matosmatos said:
i have done it!
Now i have the wm6.1
i found another rom update! (coooollll!!!!)
heheehehehhe
thanks anyway!
Click to expand...
Click to collapse

@smb_do
hi
assuming ur phone is just dead ie just blank screen do this
1.power off the phone remove batter and press the power button 3 secs
2.put batter back in to the phone
3.Press camera button and then power on at the same time u will get tricolor
used usb and Flash new ROM
or press camera button and do soft reset using stylus this will also give u the tricolor use USB and flash new ROM
goodluck
smb_do said:
i have the same proplem you had can you tell me how you done it with new rom espiecly i cant flash room and i cant do anything
thanks
Click to expand...
Click to collapse

thasnffffffffff

Im so so saaaad
I try avery thing hard reset , now roms every time it accept the now rom and whine it restsrts again tha same problem it stop at
ONPL 1.07.0000
SPL 1.07.oref
GSM 02.79.90
OS 1.9.1.1
please help me send me at
ahmedrefaat82/hotmaill.com

gene hanges at start up page onyl (after rom Upgade)
I am also facing the same problem. I have old Gene. I had upgaded it to
Pro User's ROM WM 6.1 Sumit
Everything was running fine till I soft reseted the device. On soft reset it stucks at the start up screen
On boot it shows following
ONBL 1.07.0000
SPL 1010.olip
GSM 02.79.90
OS 1.17.0.0
Then it shows the windows animations and then it hangs.
This has happned to me twice.
I had installed following applications after the ROM upgrade. Does any application creating a problem
1) HTC Home (6 tab plugin)
2) S2U2,S2P,S2V
3) Quick Menu
4) Opera Mini
5) TCPMP with many codecs

satishgosavi said:
I am also facing the same problem. I have old Gene. I had upgaded it to
Pro User's ROM WM 6.1 Sumit
Everything was running fine till I soft reseted the device. On soft reset it stucks at the start up screen
On boot it shows following
ONBL 1.07.0000
SPL 1010.olip
GSM 02.79.90
OS 1.17.0.0
Then it shows the windows animations and then it hangs.
This has happned to me twice.
I had installed following applications after the ROM upgrade. Does any application creating a problem
1) HTC Home (6 tab plugin)
2) S2U2,S2P,S2V
3) Quick Menu
4) Opera Mini
5) TCPMP with many codecs
Click to expand...
Click to collapse
Not likely, try a hard reset and see if your issue is solved

Addicted2xda said:
Not likely, try a hard reset and see if your issue is solved
Click to expand...
Click to collapse
I had tried that also but not able to recover I had to burn the ROM again .
I am scared now to soft reset my gene. Never know when it will get hanged again. (pls note that it does not hang on every soft reset).
I liked the new ROM (6.1 pro Sumeet) so much. It is fast and have left enough room to add/execute other applications. I have read so many good comments about the ROM. I do not want to change it to any other version.
Please.. please try to get some solution.
Thanks in advance.
regards
Satish

It Worked
Thanxxxxxxxx

Urgent help: HTS P3300 stuck up

Dear All,
Please urgent help required.
my HTC P3300 (Artemis) stuck up when i was trying to start it up. when i use to turn my cell on, i goes to the starting screen shows the following numbers and then stuck up.
IPL 3.07.0001
SPL 3.07.0000
GSM 02.69.90
OS 3.7.0.0
the screen does not move after that. i tried soft reset through the reset button but result is the same.
i also tried hard reset and when i puch the green phone button to proceed, a message come "FORMAT FAILED" and the phone stucks up.
i am quite a lot of problems since i have upgraded to WM6 from WM5 last week.
i am quite sucked with this problem. not been able to use my set since yesterday.
please also note that my HTC was not syncing with my PC since i have upgraded to WM6.
PLEASE HELP URGENTLY.
Nomi

You must upgrade :
-Remove SD-Card
-Remove Sim-Card
-USPL
-Upgrade new ROM

thank. i got through to install wm 6.1.
can any one please tell me which is the most stable ROM for 6.1 or 6.5
which one is better for my HTC artemis.
please post link to the ROMs

I'm using two roms :
Shady313-23081R1 : http://forum.xda-developers.com/showthread.php?t=546805
dheewatara-s 23075B1 : http://www.pdamobiz.com/forum/forum_posts.asp?TID=255901&PN=1

same problem..pls help
i have same rom and ratio with u nomi...but my problem still occur...
where do u get the USPL eventually?

Prophet S200 hung up I need Help

Dears Freinds
I have Qtek s200 and i Upgrade it from win 5 to win6.5 and when it restart hang up and dosent work any more
so pls can anyone help me
Muamer

By Hung up do you mean it goes into the bootloader screen (tri-colour)

First things first
Did you perform a HardSPl if not you need to do this first. Do a search for it, but make sure you get the correct one. By this I mean a G3 or G4, when you go into the bootloader screen look at the SPL if it ends in .000 it is a G3 if it ends in .0001 it's a G4.
This is just the same as flashing a Rom.
Then check this page and download the Qtek NVID Rom flash that and it should get your beloved prophet back to WM5
http://wiki.xda-developers.com/index.php?pagename=Prophet_ROMs
BUT before you do any flashing open up your activesync click on FILE then CONNECTION SETTINGS uncheck ALLOW USB CONNECTIONS then OK.
Then connect your phone via the USB in bootloader mode (press and hold the communication button and press the reset button keep holding the communication button until you get the tri colour screen) look at the bottom left of the screen for USB (in the white part) as long as you have got this you can begin flashing.

Dear Dixiesmu
when I turn in on i jus t get the first page
IPL 2.10
Spl 2.20.0000
gsm 02.47.21
os 10.1.0.811
And i wnat to tel u that befor the os is windows 5 with sweden lang.
so the link u gave me dosent include sweden so can i use the english rom
and im new in this feld so can help me more if u can and i will appreciate that
Many thanx for you reply

My freind
I did what u suggest and it works and now my qtek is working agian and can i upgrade it to win6.5 and if u have tje link for my qtek pls send it me
Thanx again for your help
Muamer

WM6.0/6.1/6.5 Roms
I have found that Bikertibi roms seem to be the best (only my opinion and no disrespect to the other fantasic chefs, long may thier excellent work continue ).
They also include the HardSPL for both G3 and G4 devices.
Another good one is Gullum's Prophet TouchXB if I recall this also includes the HardSPL, but please check as I am not 100% certain.

G4
Hi Malfakhry
Forgor to mention that your device is a G4

Dear
How did you know that my device is G4
thanx

G3 or G4
If your SPl ends in .000 then it's a G3
If it ends in .0000 or .0001 thens it's a G4

dear
You are very helpfull thanx for you

Dear
I read in wiki that if its end in .000 is g3 and .0001 is g4
http://wiki.xda-developers.com/index.php?pagename=prophet_g3g4_how
so mine ends with
Spl 2.20.0000
so it must be g3 that right or not
thanx again

I also facing d similar problem like bro malfakhry. After flashing back to Qtek NVID Rom WM5 it go hang....and it show
IPL 2.20
SPL 2.20.0000
GSM 02.47.21
OS 2.20.7.34
May I know my device is G3 or G4?
How myself gonna to solve this hang issue?
Thanks in advance.
rgrds
lrew9999

G3 or G4
Hi All
If your device was a G3 the SPL can only end in .000
As your devices end in .0000 it is a G4
When you flashed the NVID rom this means there is no vender identification and will reset your SPL back to 0 all you do is count the noughts as it can only be 3 or 4 this then gives you the G rating.
If your phone hangs after this flash then try a hard reset first if it still hangs just go through the whole proccess again from the start remembering the hardSPL and when done perform a hard reset.

Dixiesmu said:
Hi All
If your device was a G3 the SPL can only end in .000
As your devices end in .0000 it is a G4
When you flashed the NVID rom this means there is no vender identification and will reset your SPL back to 0 all you do is count the noughts as it can only be 3 or 4 this then gives you the G rating.
If your phone hangs after this flash then try a hard reset first if it still hangs just go through the whole proccess again from the start remembering the hardSPL and when done perform a hard reset.
Click to expand...
Click to collapse
Dear Dixiesmu,
Its work now!!!
Thanks a million.