Is there a way to check if wizard g3 is cid locked or not ?
assume it is and run lockiwiz anyway
Related
hi I tried to unblock CID becuase of invalid CID message, and the device is going on SIM LOCK state after reboot? How can i unblock this SIM lock and inblock CID also?
Please help
How do i make sure my phone is unlock and SuperCID. I know if i insert another cariier sim card and if it i can make phone call then it is unlock. is there any other way to say or test is my phone unlock?
What about SuperCID?
v3patel said:
How do i make sure my phone is unlock and SuperCID. I know if i insert another cariier sim card and if it i can make phone call then it is unlock. is there any other way to say or test is my phone unlock?
What about SuperCID?
Click to expand...
Click to collapse
Use mtty (read here)
Hi
I use mtty to read bootloader, and return this info:
With info 2 - HTCSSuperCIDHTCE
with info 4 - HTCSQTEK_506žW’ŸHTCE
In wiki they booth should Return "HTCS" + CID + (4-byte checksum) + "HTCE"
Is my CID - Supercid? or Qtek_506?
What means Qtek_506, what is the CID for Vodafone PT?
no one?
I reset my 8125 and supposedly relocked the CID so i could send it back to cingular
is there any way to check if it is CID locked so i can retain my warranty?
You can check it using the CID actions button in Wizard Service Tools. From what I've read on here though, the manufacturer doesn't usually check whether or not it's still CID locked anyway.
I checked it, but it shows its still unlocked. I tried using the Lokiwiz backup to restore it and it didn't work. Any ideas on how to get my CID back?
hi guys!
i tried once lokiwiz03a and it unlocked the simlock. very fine. i got a tmobile card and tried a A1 simcard. worked!
now, i got drei simcard. i swapped the cards, turned on my charmer but the display tells me "simcard missing".
ok so i try lokiwiz03a again. and i see now there is still Lock Status: 0100000000000000
all right, i tried the wizard service tool, read the cid info and get this output:
Reading CID block...
Calculating CID block sum...
CID checksum: 446B90C3
Decrypted stored sum: 1FAFAC2328E0332F
Decrypted calcd sum: 1FAFAC2328E0332F
Key index : 3 - Block index: 158
CIDkey: 63400132
CID IMEI: 357037007738520
CID: CHRTMO12
Phone is CID LOCKED!
all right, i go to UNBLOCK CID(SuperCID) and i got this message:
SPL version is 2.06.0001
DOC chip is write-protected!!
Downgrade SPL to no higher than 1.06 and
repeat procedure.
the wizard service tool also tells me this info:
=> Bootloaders:
IPL: 2.06.0001 (G4 device)
SPL: 2.06.0001 (G4 device)
SPL date unknown
so i know its a g4 dev.
after searching the forum i could not figure out if i can or cant downgrad to a spl like this.
anyone got an idea how to unlock this device properly? or is my only change to go and pay some money to get it done?
thanks for you help
ok i think i found the answer myself.
the charmer does not support umts and my new simcard is from a umts provider. therefore the card can probably not be read...
thanks anyway.
if someone still has an idea please keep posting.
thnkx
HELP
wat answer u found? can u help me as i hav the same prob and unable to resolve??
how to unlock htc wizard cid in bootloader mode?
Here you go:
http://forum.xda-developers.com/showthread.php?t=332320
A little search always helps
i dont understand how to unlock, hard spl g4 cant faind my device...
Please start with this tool:
http://forum.xda-developers.com/showthread.php?t=295038
It helps you to do most of the hard parts!
The only way to unlock while in boot loader mode, “imei-check.co.uk”
so there is no way to unlock for free?