Just upgraded the firmware on my Cingular 8525. I downloaded the latest version from the ftp website.
rom version 2.06.502.3
rom date 02/02/07
radio version 1.34.00.10
protocol version 32.67.7020.10h
What the phone does. The phone still works and I can make out going phone calls, but I am unable to download my mail or bring up web pages. It comes up as web page can not be loaded. I've tried to search for an answer but have not found anything yet.
I am using an old att sim.
Thanks
Scott
Scott,
Have you checked to see if the connection settings are set on the device (settings - connections)? Perhaps the ROM upgrade (is a Cingular one or HTC?) does not contain those settings - in that case you will need to manually enter them. Perhaps this might help: http://forums.mobiledia.com/topic18250.html - not sure if the settings in here are right for your service or contract. A search here and on MoDaCo: http://www.modaco.com/HTC-Hermes-HermesMoDaCocom-f204.html might also provide the settings that you need
Good luck
My connection settings are correct. They were working before I upgrade the firmware. I am using Att settings which is proxy. Unless with the new firmware they changed. I think it might have to do with the bootloader being 1.09 I just trying to figure this out.
Thanks for your help,
Scott
So you are old ATT Blue in USA, correct?
Running the RUU 2.06 with Radio 1.34?
Do another hard reset as some times the first boot is not letting the entire Ext_rom complete, I do not know why but it happens sometimes on the new Cingular ROM.
After that if it doenst work then go to Cingular.com and check your GPRS setting in the "Connection" part of your setting and make sure the settings include the correct user name (wap.cingular.......... and password CINGULAR1..... etc)
Related
After upgrading my O2 XDA 64Mb (was 32MB upgraded by expansys), it no longer connects to GPRS.
I have tried both the mobile web and wap connections, but the message i get is
"There is not answer at the number dialed. Verify phone number and then try again. To chage your connection settings, tap Settings. If the problem continues, contact your ISP or network administrator."
This was a 'clean' upgrade (ie. I haven't restored any backup after the reset). I am now on 3.17/4.21 ENG O2 versions.
Any help appreciated.
When you say "after upgrading" do you mean after a ROM upgrade, or after the memory upgrade?
This could be nightmare cos (as i'm sure you know) the memory upgrade will have voided your warranty. If its happening straight after the memory upgrade then maybe you can go back to expansys and get them to pay for fixing it if they are responsible.
If it has happened after the ROM upgrade then check if all setting have gone back into the device. The error message sounds like settings.
It was since installing the RSU upgrade. I thought about settings, but I have done autoconfigure - and not changed anything else. I've check the AP name, and speed etc. What else?
I also had this problem once it wasnt from the device it was from the Operator i didnt use the Auto settings i have created my own settings and finaly i called the customer support at my operator and solved everything i hope this would help try it.
:wink:
Hmm... now I can't downgrade my rom either.
Can anyone get me radio 4.16 for XDA as a file for rom image tool?
xdarit does not yet have support for creating gsm rom update cards.
hi, I bought a mda pro.
If I want can I install the rom of I-mate in english?
and where can I download?
and for unlock?
thank you
Hi,
sorry for eventually beeing unpolite, but have you ever tried to read a single post in this forum ?
Here is a complete forum called "Universal upgrading" .. there you will find all the answers to your questions.
If you don´t find them within 10 seconds, try the search. If you still don´t find it .. no, you don´t have the skills to upgrade your mda, you will toast it.
- Superbowl
PS: if you still have questions AFTER you read, you are welcome to ask.
Download this file, it contains the I-Mate JASJAR Rom update with a No Device ID executable.
ftp://xda:[email protected]/Uploads/MDA_PRO_JASJAR_ROM_UPGRADE_WWE_11353_137_10301.zip
Put the MDA in bootloader (Camera + Reset + Power)
Connect the device via USB
Run MaUpgradeUt_noID.exe
Once updated, press reset on the MDA Pro
That's it! Then you'll have a nice MDA pro with MSN, Skype and ALOT more free RAM!
MDA Pro upgading
hollinshead
I see that you have updated your MDA Pro with the IMate ROM Update, Im keen to do this but wanted to know what the pitfalls are?
What about connection settings? How can I get them back?
Does all the software work OK? Can you still Video call?
Ive had problems with the signal being a little poor in my area, does the radio upgrade seem to solve it or not.
Sorry for all the questions, but if I balls this up, I have no original ROM to go back to, as TMobile dont seem to release them on the net.
Any help you can give would be great
HI,
at least you should make a complete backup of your extended rom. There are all the files you may need to re-install the original customization, e.g. the original connection settings.
- Superbowl
Problems
Its academic now really as I cant complete the upgrade, it comes up with the wrong country code error.
Is there a solution to this, mine is UK TMobile?
Did my MDA pro this morning
1. Make sure you are running form the bootloader or you cannot install as the id issue comes up. If you aren't sure about accessing the bootloader- run the update first - it will fail but phone should be in bootloader.
2. Disable USB connections in Activesync,
3. Re-run update - all should work fine.
The new rom includes a prompt on set-up for your carrier settings and should work fine without having to use the files from the extended rom backup you shoud make before playing with a new rom (allows you to install the specific customisations for your device
Thanks to the poster for the link to the files
Issues solved,
MS voice command now installs
Streaming video via ORB works (a bit gimmicky though and no full screen)No more t-mobile schemes - much nicer dial skin and today themes
It works fine, the T-Mobile MMS settings are installed for you (just select the network when going through setup on the PDA after the flash).
The GPRS / 3G settings you can add manually.
Access point: general.t-mobile.uk
Username: t-mobile
Password: one2one
Video calls etc work fine, because its all included in the I-Mate rom. What's more, it doesn't have that horrid T-mobile dialler theme!
I have an unlocked MDA i'm using on at&t, i am having troubles trying to use modem link on it, it has tmobile 2.26 rom on it, but when i try to use modem link i can't change the access point name, it says wap.voicestream.com and gives me no other options, nor does it give me the option to add a new access point. Internet, MMS, SMS all work fine, just unable to use modem link. Also i can't get the computer to recognize it as new hardware even when i activate modem link as voicestream.com. Is there something in the registry that i need to change like i had to in order to remove the grayed out portions on MMS settings? Sorry for the long post, i'm still kinda new to the whole wizard game, but i must say this site is a wealth of knowledge. Thanks for any help you can provide.
Travis.
My Xv6800 data does not work. I've done everything that i found from the forums. Anyone have any advice? I did 2.40 olipro, then did stock rom, then DCD 3.2.6 and radio 3.42.50.
Did you load your carrier cab? I am assuming since you have an XV6800 that you Verizon, if so get the Verizon cab and install it.
Cabs are available here.
http://dcd1182.n715dp.com/index.php?dir=carriers/
BTC
You will have to add the cell modem back in your self. When you flash with the custom rom there is no cellular modem added by default . It's documented some where (I had the same issue the first time I flashed). You have to go to connections click add then select cellular modem. Make sure you have the correct network settings (UN/PW) and your all good to go.
D
IS there any way to made a carrier cab? I do not see the one I need on the list. I have the original phone and I can pull it off from that phone.
depperly said:
You will have to add the cell modem back in your self. When you flash with the custom rom there is no cellular modem added by default . It's documented some where (I had the same issue the first time I flashed). You have to go to connections click add then select cellular modem. Make sure you have the correct network settings (UN/PW) and your all good to go.
D
Click to expand...
Click to collapse
I think you need to refer to the post by BillThyCat because your wrong about that. A cab file is all it takes.
The only reason you would need to load a cell modem driver is if you were going to have it connect to a different ISP that your default carrier data network, as far as I know, as I have never had to load any sort of driver to get my phone back on the data network after flashing.
If your carrier isn't listed, and you have the original phone still handy, I believe there is info you can copy from your EPST screens and put into your new phone that will reenable data. Tho this is something I have not had to do since I have a carrier cab available.
What carrier do you have? Maybe someone else here with the same carrier can help out.
You may need to recreate the dialup connection under network connections as well, with most carriers the dialup # is #777 and then you use a login and password that is unique to your account. It's possible your carrier help desk may be able to walk you thru how to reconfigure this. Depends on the carrier.
This doesn't require software, just some configuration on the phone.
BTC
Hi friends,
I recently bought a HTC HD2 locked to T Mobile in UK. I used a Rebel sim to unlock it and I am now using it on O2.
However I am not able to start internet, neither can I receive internet settings from O2.
The message that gets displayed tell the phone is pre set to T Mobile internet settings and these cannot be changed
Is there anyway I can bypass these? Anyone else faced same thing before?
Thanks
Metal
settings - menu - all settings - connections - there should be a connection setup option in there.
if not, use this
phoneroms.co.uk/Programs/connectionsetup.cab
instal it, reboot the phone, it will auto run when you restart and configure your phone.
samsamuel
thanks for reply.
Yes I went to that menu option but the only thing I see is TMobile.
I am asked to select country (i select as UK), then I am asked to select operator and only option I have is T - Mobile.
Besides when I click on any browser, I get the T Mobile flash screen and then the browser starts.
I get an error as I am not a T Mobile customer. I have a link for settings there. When I click that it says -
This connection is pre configured. It cannot be modified.
You need to flash the WWE HTC ROM, as the T-Mobile ROM has the internet settings preset and you cannot change them.
hollinshead...
Thanks for the reply. I was guessing so from the little bit of research I have done.
Can you please give me some pointers in that directions...not really handholding but some links or step by step guide ?
I am new to WinMo actually...have been a symbian loyalist till now !
Sorry for sounding lame, but what is WWE?
WWE = World Wide Edition
Thanks.
I tried to d/l it from the HTC site. When I enter the serial no. I get
Sorry, this software download is not suitable for your device.
What are the other options I have? Other reputable links from where I can get it?
Can I d/l any ?
Thanks in advance
you probaly need to install hspl and then flash it
Thanks.
I got hold of a serial no after random searching. I entered that on HTC site and my download is in progress for WWE ROM.
Can I install it? Will that cause any adverse effects?
try using this network connection settings cab.
It appears you didn't try the one samsamuel posted.
http://forum.xda-developers.com/attachment.php?attachmentid=250891&d=1259353814
It won't let you flash it to your device, it will give you an error.
See here:
http://forum.xda-developers.com/showthread.php?t=611433
midnight, samsamuel
That does indeed work and I am now able to use internet on O2 even though I am locked to T Mobile. However I cant receive network settings. With O2 you send active to 2020 and you receive the internet settings. I get a message back that there is a problem and contact customer services. That is not an issue now as I can use the internet.
However I am curious to know if I will be able to upgrade my ROM in the future. I downloaded the WWE ROM but I got 294 Error for invalid vendor when I tried to install
In simplistic terms what is HSPL? is that irreversible? Are there any links for tutorials which make it simple for WinMo beginners.
Sorry but its my first day on HD2 and on WinMobile
metal675 said:
midnight, samsamuel
That does indeed work and I am now able to use internet on O2 even though I am locked to T Mobile. However I cant receive network settings. With O2 you send active to 2020 and you receive the internet settings. I get a message back that there is a problem and contact customer services. That is not an issue now as I can use the internet.
However I am curious to know if I will be able to upgrade my ROM in the future. I downloaded the WWE ROM but I got 294 Error for invalid vendor when I tried to install
In simplistic terms what is HSPL? is that irreversible? Are there any links for tutorials which make it simple for WinMo beginners.
Sorry but its my first day on HD2 and on WinMobile
Click to expand...
Click to collapse
Read the HSPL thread?
hollinshead said:
Read the HSPL thread?
Click to expand...
Click to collapse
Yes I did, but for someone who started using a new phone out of the box just few hours back, its a bit over the head.
I am trying to come to grips on what is HSPL, SPL, flashing, etc.
So I wanted to know if there is any basic tutorial, help pages etc which can be useful for starters. I am a tech guy so I can understand the tech terms but everyone needs a guidance first time around.