DOPOD 815 Pro struck on HTC BOOT screen - JAMin, XDA Neo, S200 General

hi my new dopod has a problems
after soft reset it struck on HTC BOOT Screen
i hard reset it using 1]camera button 2]connection 3]reset
and press green key
but stiil struck on HTC screen
please i want om update
thanks

Hi, u might try this
step 1
camera + connection + reset
step 2
hold camera + connection, just release reset only
step 3
still hold camera + connection + green button
should be ok, there is mistake on the manual, the way u do should be still performing soft reset, I think

ok i tried that ant it says format complete but still stuck on HTC
tried rom update but error 260
please help

what is the send button ?
A black screen tells me "press send button to format".
but i don't know what the send button is...
help !

send buttom is the "green phone" buttom
in other word, the buttom you make call...

Related

Htc 3300 no boot

Problem with my htc 3300.
I try to boot but is freezes . I di hard reset it starts showing th first screen then freeze.
Can you help me
make hard reset. if is not working, install a clean wm6 version, official one. And don't forget about CID Unlock
Athanti said:
Problem with my htc 3300.
I try to boot but is freezes . I di hard reset it starts showing th first screen then freeze.
Can you help me
Click to expand...
Click to collapse
Do a hard reset yes. I had the same problem once and this helped me.
Hard reset= hold both selection button next to green and red button.
Keep them push down and switch on your Artemis. Afterwards you will get a question. To proceed is pushing the green key.
Your Artemis will be restarted again with all basic (use lost all your contacts but you still be able to activesync them back if you did make a backup)
**good luck**
Hard reset= hold both Left&Right button + Reset button (lower left)
An rainbow screen will appear (PDA must be connected on USB)
After, you can flash a ROM again...

booting problem

hi my handset dopod 818 pro which was working very slow when i installed n software, i got n software from this site of radio rom upgrading but after this my handset in not working, then i made it factory resetting then to its not going further, the message indicated when i pressed the camera+comm+rest after this the message came press send button after that in the screen show dopod & in the top of the screen first there was 4 lines was coming ipl, spl 3rd line was radio rom now which is not showing & the last os this comes after that the handset goes shutdone, can u guide me what to do for this will very thankful for this
thanking
I think you want to hard reset your device... before doing that make sure you're alredy back up your contacts and Messages.
To hard reset There are 2 ways..
1. Start> Setting > System> Clear Storage... when asking for password type 1234 and Press Yes option..
and the other way
2. With Pressing Comm Button + Camera buton and then reset the device.. remember dont release the Comm Button and Camera button.. when asking to press the Send Button.. Press it.. and release the Comm button and Camera button.. and after that. also release the send button...
If Success your device gonna back to It Factory Setting..

HELP me with my brick htc touch opal(viva)

I recently flashed my opal to wm 6.5 and it worked perfectly fine. Yet today when I tried to install a software which would help display chinese character, after reboot, it got stuck in the smart mobility screen. I have tried hard reset and it didnt work. HELP ME!!!
you can still hard reset it in that state... do the usual hard reset, press both green and red buttons at the same time and with the stylus press the reset button at the back and release it. don't release the green and red buttons yet, release it when you see the instruction "This operation will delete all your personal data blah blah"... then just follow the on-screen instructions.
If TheRem's solution doesn't work you can reset the phone while holding down the Volume down key and it will take you to the SPL (tri color screen). from there you can plug in your phone to USB and flash PhamQuangs ROM again.
Double Post
Closed.
Dave

Gene Dead

My htc gene is bricked.I have tried all the methods. I am unable to recover using Orefkov's method. When I try to press power key or soft reset button , onlr red and green light blinks. Nothing else happens. no charging indecator when i connect it to wall charger. I am even not getting the tri color screen.
please help me. to at least get into bootloader.
I have tried to connect using MTTY also but it is not detected using usb. help less now with no bootloader.
pravin.kamdi said:
My htc gene is bricked.I have tried all the methods. I am unable to recover using Orefkov's method. When I try to press power key or soft reset button , onlr red and green light blinks. Nothing else happens. no charging indecator when i connect it to wall charger. I am even not getting the tri color screen.
please help me. to at least get into bootloader.
I have tried to connect using MTTY also but it is not detected using usb. help less now with no bootloader.
Click to expand...
Click to collapse
don't panic
to enter boot loader just on device
press and hold camera button and press soft reset button .
deepv84 said:
don't panic
to enter boot loader just on device
press and hold camera button and press soft reset button .
Click to expand...
Click to collapse
No luck. I have tried to go to bootloader using press and hold camera button and press soft reset button
pravin.kamdi said:
No luck. I have tried to go to bootloader using press and hold camera button and press soft reset button
Click to expand...
Click to collapse
remove battery and then hold power button for 20 seconds (this will remove stored power from device )
then insert battery
press and hold camera button then press power to bootloader
hope this will work
Pravin,
What happened??
Did it work?
no bro i have tried power cycling also nothing is working.
ok dude did it worked?
if not tell me i'll help you via team vewer to unbrick it
dont worry just dont panic i've unbricked mine too
what happen
hey bro ,,
what happen, r u able u restore u r set...... if not tell us ...
bye
My Gene also dead
Please help me,,
i try to update rom but it fail,
now when i start my gene it show color screen...
please help me what i do
my yahoo chat id [email protected]
added you on yahoo
hey amit ,,
can u explain more in detail what u do exactly with u r handset..
.......
When i try to update my rom, i don`t know what happan but now, my phone not start when i try to start only blue and red light flash. nothing.
when i press reset with camera button i saw three color screen.
Tell me what i do..............
hello gurusingh,
I was update my htc p3400i ROM, after completion. Phone turn off but not restart, if I try camera button and reset button only green and red right blink not any indication shown on screen,…please help me.
I shall very thankful, if you solve my problem
Sanmukh singh
MSL, Mumbai.
hi gurusinghbrar,
My Htc p3400, can not start......
i was updating this rom "RUU_Gene_hTC_Asia_India_1.17.720.1_4.1.13.34_02.79.90_Ship" after 100% complete it turns off , but not start only Green and red light flash during press reset button...
i was try all methods,#remove batery 20 sec and then start with camer button & both camera and voice button. but result is same...
#No indication during Charging.,no usb detected in PC.
please help how i can recover my device.....
sanmukh singh
[email protected]
HTC P3400i GENE100 Dead
I have a HTC P3400i GENE100. I successfully installed orefkov SPL and then upgraded my original ROM WM 6.0 to cooked wm 6.5. After installation my device was too slow than before hence I flashed it with RUU_Gene_hTC_Asia_India_1.17.720.1_4.1.13.34_02.79 .90_Ship.exe. After flashing it 100 % my New Gene restarted, but didnt boot to booting screen. Its not going into bootloader mode also. It shows blank screen i.e. black. I tried several combinations of keys (Camera + Power button or Camera + Reset or by pressing both "-" button + Reset) for going it to bootloader mode. But none of them working. When I plug in charger the green & red light blinks once and nothing else. Same if I press reset with stylus, the green & red light blinks once and nothing else happens. I know that I have bricked my New Gene, when I flashed the ROM, which was meant for Old Gene, which I came to know after reading the posts in this forum. I have to use JTAG Method for recovering my Gene. Hence I have read many posts about it in this forum. But can any one of the great masters here, help me with a proper guide that can help me recover my Gene 100%.
Thank you for spending your valuable time in reading this post.
Regards
Parag Gawali
prgawali said:
I have a HTC P3400i GENE100. I successfully installed orefkov SPL and then upgraded my original ROM WM 6.0 to cooked wm 6.5. After installation my device was too slow than before hence I flashed it with RUU_Gene_hTC_Asia_India_1.17.720.1_4.1.13.34_02.79 .90_Ship.exe. After flashing it 100 % my New Gene restarted, but didnt boot to booting screen. Its not going into bootloader mode also. It shows blank screen i.e. black. I tried several combinations of keys (Camera + Power button or Camera + Reset or by pressing both "-" button + Reset) for going it to bootloader mode. But none of them working. When I plug in charger the green & red light blinks once and nothing else. Same if I press reset with stylus, the green & red light blinks once and nothing else happens. I know that I have bricked my New Gene, when I flashed the ROM, which was meant for Old Gene, which I came to know after reading the posts in this forum. I have to use JTAG Method for recovering my Gene. Hence I have read many posts about it in this forum. But can any one of the great masters here, help me with a proper guide that can help me recover my Gene 100%.
Thank you for spending your valuable time in reading this post.
Regards
Parag Gawali
Click to expand...
Click to collapse
check ur mail
Gene back to life
Thanks to Sumeet...
I got my HTC P-3400i New Gene back to life. It works better too. Sumeet is the man, who has given life to my entirely dead gene. I thank to him and suggest needy to contact him in their cases.
Thanks to XDA-developers Forum too...
Regards
Parag Gawali
same problem i had pls help me
Fido/Sumeet, please help me my gene got bricked when i was downgrading my gene from 6.1 to stock rom. after successful rom update my gene doesnt got restarted i'm getting black blank screen.
pleaseeeeeeeeeeee guys help me.....

P3400 gene100 is not starting!

Hi,
My 3400 is not starting. When i start the phone it hangs up in the "windows mobile direct push technology" screen. I tried without SD card and SIM but no luck. I have all my contacts inside and I need them. How can I fix the problem of my phone. Please help.
ONBL 1.10.0000
SPL 1.10.0000
GSM 2.79.90
OS 1.10.0.0
-aneesh
aneeshnr said:
Hi,
My 3400 is not starting. When i start the phone it hangs up in the "windows mobile direct push technology" screen. I tried without SD card and SIM but no luck. I have all my contacts inside and I need them. How can I fix the problem of my phone. Please help.
ONBL 1.10.0000
SPL 1.10.0000
GSM 2.79.90
OS 1.10.0.0
-aneesh
Click to expand...
Click to collapse
i don't think u can save ur contacts now
just hard reset ur device but all data will be lost.
How to do the hard reset? please tell me.
no way to save data?
Hi,
I searched google and got the method to hard reset.
-------------
To perform a hard reset (Full Reset) press and hold the left SOFT KEY and the right SOFT KEY, and at the same
time, use the stylus to press the RESET button at the middle left side of your device.
Release the stylus, but continue pressing the two SOFT KEYs until you see the following message on the screen:
This operation will delete all your personal data, and reset
all settings to manufacturer default. Press Send to restore
manufacturer default, or press other keys to cancel.
Release now the two SOFT KEYs, and then press the TALK (Send) button
---------------------
But when I press the reset button phone restarted but nothing siplayed as mentioned above. Again it went to windows screen and hung there! Cant even do hard reset? What can I do now? Please hlep.
It is ok now. thanks
aneeshnr said:
It is ok now. thanks
Click to expand...
Click to collapse
its nice to hear that ur device is working .
enjoy!!
I was update my htc p3400i ROM, after completion. Phone turn off but not restart, if I try camera button and reset button only green and red right blink not any indication shown on screen,…please help me.
I shall very thankful, if you solve my problem
Sanmukh singh
MSL, Mumbai.
sanmukhsingh said:
I was update my htc p3400i ROM, after completion. Phone turn off but not restart, if I try camera button and reset button only green and red right blink not any indication shown on screen,…please help me.
I shall very thankful, if you solve my problem
Sanmukh singh
MSL, Mumbai.
Click to expand...
Click to collapse
which rom u have updated??????????
hi deepav84,
i was updating this rom "RUU_Gene_hTC_Asia_India_1.17.720.1_4.1.13.34_02.79.90_Ship" after 100% complete it turns off , but not start only Green and red light flash during press reset button...
i was try all methods,#remove batery 20 sec and then start with camer button & both camera and voice button, nothing shown in USB in PC. but result is same...
please help how i can recover my device.....

Categories

Resources