It can't power on, and can't recharge...
I update it by Wallaby ROM, but failed....and I try reflash the old backup ROM, At first it success...But at twice,,,I update it with another wallaby rom...faild...then reflash backup rom,,,,,but....it dead...
can't enter the bootloader....can't power on....can't recharge...
when I put it on recharger...it's red led can shine awhile...then go out...
Pls help me,,,,How can I do?
Related
plz need help
while trying to update radio rom from sd card i bricked my hero
no powering up no charging led no connection to pc just like dead
need some help how much deep i amin s..t
Sorry about it but, its not "easy" to brick by flashing a new radio, unless wrong radio flashed or interrupted during flashing.
Some experts may be able to help if you put your question little more in detail...which radio etc.
update-hero-radio-63.18.55.06JU_6.35.08.29-signed
i was trying tp update this radio
hero-generic-2.73.405.38-rooted-signed firmware current FW
I had this problem as well what I did was contiously restart my phone take battery out put it back in. Done this like 20+ times then the phone managed to boot up.
Thanx but i already did that no use still dont know what s the problem
Htc hero bricked plez need help
i dunno whats wrong i was trying to update my radio rom minus nandroid backup
i flashed twice process stuck i pulled the battery now i have the dead phone no led no display no usb connection need help
Just checking but this sounds like you flashed a GSM radio onto a CDMA hero, is this what you have done? if so you are FOOOOOOBARRRRRRED son. and to be honest you really should have read about the radio flash.
If thats what it is,
if it isnt then good luck.
djmazhar said:
i dunno whats wrong i was trying to update my radio rom minus nandroid backup
i flashed twice process stuck i pulled the battery now i have the dead phone no led no display no usb connection need help
Click to expand...
Click to collapse
+ why do you think it got stuck? how long did you leave it?
List type of Hero you have, radio you were trying to flash aswell. Also will it boot into fastboot? (hold down vol down key and turn on)
Dan...
Thats what I asked in post 2.
i was trying to update radio rom 63.18.55.06JU_6.35.08.29
my SPL - 1.76.2007
rom -hero-generic-2.73.405.38-rooted-signed
and it does not boot into fast boot
Bricked htc hero some1 plz help!!!!
i have searched n searched online 4 2weeks for solutions but i have not found not 1 thing to help me,i accidentally flashed a gsm on my cdma & i cannot boot it @ aw,no led lights but yet it charges,i can only hold vol up & tap power & it juz vibrates 3x & i need some kinda of solution,anybody!please......
Hi all.
I tryed to upgrade my 6815 to WM6.5. During the flash process it got stucked in the midle. The screen got all black and it does not do anything. I think the bootloader is dead.
I tryed to charge it. The red light is working, so it's charging. But the phone is dead.
Can anyone help me?
Thanks
PS: Sorry if this thread has been posted before. I search a while in the forum and didn't find any that could help me with my problem...
if it is charging and u have orange light pull up batery for half an hour, hold the soft 1 and soft 2 buttons and insert batery holding them. don,t leg go of the buttons... see what happends. it should go in bl an the flash a custom ron or smth. if bl is dead go here
Hi.
Thanks for your reply.
The light is not orange, ir red when I plug it to power..
I will try the first option you give me.. the second one is not for me, I'm not so advanced.. heheh
My htc gene is bricked.I have tried all the methods. I am unable to recover using Orefkov's method. When I try to press power key or soft reset button , onlr red and green light blinks. Nothing else happens. no charging indecator when i connect it to wall charger. I am even not getting the tri color screen.
please help me. to at least get into bootloader.
I have tried to connect using MTTY also but it is not detected using usb. help less now with no bootloader.
pravin.kamdi said:
My htc gene is bricked.I have tried all the methods. I am unable to recover using Orefkov's method. When I try to press power key or soft reset button , onlr red and green light blinks. Nothing else happens. no charging indecator when i connect it to wall charger. I am even not getting the tri color screen.
please help me. to at least get into bootloader.
I have tried to connect using MTTY also but it is not detected using usb. help less now with no bootloader.
Click to expand...
Click to collapse
don't panic
to enter boot loader just on device
press and hold camera button and press soft reset button .
deepv84 said:
don't panic
to enter boot loader just on device
press and hold camera button and press soft reset button .
Click to expand...
Click to collapse
No luck. I have tried to go to bootloader using press and hold camera button and press soft reset button
pravin.kamdi said:
No luck. I have tried to go to bootloader using press and hold camera button and press soft reset button
Click to expand...
Click to collapse
remove battery and then hold power button for 20 seconds (this will remove stored power from device )
then insert battery
press and hold camera button then press power to bootloader
hope this will work
Pravin,
What happened??
Did it work?
no bro i have tried power cycling also nothing is working.
ok dude did it worked?
if not tell me i'll help you via team vewer to unbrick it
dont worry just dont panic i've unbricked mine too
what happen
hey bro ,,
what happen, r u able u restore u r set...... if not tell us ...
bye
My Gene also dead
Please help me,,
i try to update rom but it fail,
now when i start my gene it show color screen...
please help me what i do
my yahoo chat id [email protected]
added you on yahoo
hey amit ,,
can u explain more in detail what u do exactly with u r handset..
.......
When i try to update my rom, i don`t know what happan but now, my phone not start when i try to start only blue and red light flash. nothing.
when i press reset with camera button i saw three color screen.
Tell me what i do..............
hello gurusingh,
I was update my htc p3400i ROM, after completion. Phone turn off but not restart, if I try camera button and reset button only green and red right blink not any indication shown on screen,…please help me.
I shall very thankful, if you solve my problem
Sanmukh singh
MSL, Mumbai.
hi gurusinghbrar,
My Htc p3400, can not start......
i was updating this rom "RUU_Gene_hTC_Asia_India_1.17.720.1_4.1.13.34_02.79.90_Ship" after 100% complete it turns off , but not start only Green and red light flash during press reset button...
i was try all methods,#remove batery 20 sec and then start with camer button & both camera and voice button. but result is same...
#No indication during Charging.,no usb detected in PC.
please help how i can recover my device.....
sanmukh singh
[email protected]
HTC P3400i GENE100 Dead
I have a HTC P3400i GENE100. I successfully installed orefkov SPL and then upgraded my original ROM WM 6.0 to cooked wm 6.5. After installation my device was too slow than before hence I flashed it with RUU_Gene_hTC_Asia_India_1.17.720.1_4.1.13.34_02.79 .90_Ship.exe. After flashing it 100 % my New Gene restarted, but didnt boot to booting screen. Its not going into bootloader mode also. It shows blank screen i.e. black. I tried several combinations of keys (Camera + Power button or Camera + Reset or by pressing both "-" button + Reset) for going it to bootloader mode. But none of them working. When I plug in charger the green & red light blinks once and nothing else. Same if I press reset with stylus, the green & red light blinks once and nothing else happens. I know that I have bricked my New Gene, when I flashed the ROM, which was meant for Old Gene, which I came to know after reading the posts in this forum. I have to use JTAG Method for recovering my Gene. Hence I have read many posts about it in this forum. But can any one of the great masters here, help me with a proper guide that can help me recover my Gene 100%.
Thank you for spending your valuable time in reading this post.
Regards
Parag Gawali
prgawali said:
I have a HTC P3400i GENE100. I successfully installed orefkov SPL and then upgraded my original ROM WM 6.0 to cooked wm 6.5. After installation my device was too slow than before hence I flashed it with RUU_Gene_hTC_Asia_India_1.17.720.1_4.1.13.34_02.79 .90_Ship.exe. After flashing it 100 % my New Gene restarted, but didnt boot to booting screen. Its not going into bootloader mode also. It shows blank screen i.e. black. I tried several combinations of keys (Camera + Power button or Camera + Reset or by pressing both "-" button + Reset) for going it to bootloader mode. But none of them working. When I plug in charger the green & red light blinks once and nothing else. Same if I press reset with stylus, the green & red light blinks once and nothing else happens. I know that I have bricked my New Gene, when I flashed the ROM, which was meant for Old Gene, which I came to know after reading the posts in this forum. I have to use JTAG Method for recovering my Gene. Hence I have read many posts about it in this forum. But can any one of the great masters here, help me with a proper guide that can help me recover my Gene 100%.
Thank you for spending your valuable time in reading this post.
Regards
Parag Gawali
Click to expand...
Click to collapse
check ur mail
Gene back to life
Thanks to Sumeet...
I got my HTC P-3400i New Gene back to life. It works better too. Sumeet is the man, who has given life to my entirely dead gene. I thank to him and suggest needy to contact him in their cases.
Thanks to XDA-developers Forum too...
Regards
Parag Gawali
same problem i had pls help me
Fido/Sumeet, please help me my gene got bricked when i was downgrading my gene from 6.1 to stock rom. after successful rom update my gene doesnt got restarted i'm getting black blank screen.
pleaseeeeeeeeeeee guys help me.....
Hi Guys...
I'm trying to cook a rom... but now I'm ...
MY PHONE is BOOTING and BOOTING and BOOTING, I connect the USB CABLE and then the phones turns ON and HTC screen apears then He reboot Again... and again and again...
I already try to flash the Stock Rom and Had the same problem...
Did you Hard SPL it? Also if you from turned off, Hold Volume Down and Power, does it boot into the tri color mode? If so you can get the image file and follow these steps here
http://forum.xda-developers.com/showthread.php?t=691779
To bring you back to square one, then hard spl it correctly and load your rom, I prefer energy, see my sig for that link.
Maybe you should enter the bootloader? try and flash a cooked rom or stock rom to see if it still works
I Already do that... but still the same...
I thinking that is batery down... when I unplugged the USB cable the phone deads...
I had another battery in work, tomorrow I will see,,, because e don't charge...
He Won't Pass HTC blank screen when and turn ON... e reboot and reboot and reboot...
EDIT: Already Find The Problem ... A Pin in Batery connecte was wrong...
So a friend have a problem with a ROM, and i decides to flash rom radio and with an other ROM and when i'm flashing HD2 freezing and lock at 53%, i trying to flash with any others Roms and i have a big problem, hd2 no reboot,, and no reboot in bootloader mode too after :S
i trying the Hard Reset manual and nothing !!
Who can help me ???
Sorry for my bad english!
Friendship Kindly.
if you can't get into bootloader then it is probably dead.
So volume down while pressing the reset key doesn't do anything?
If you plug it into a charger does the red led come on?
What version hd2 is it?
Thank's for your answer so,
i can't make it in bootloader even if i press volum down button and press the end key, he does nothing :s but he return in bootloader mode one time / 50 ...
when he connect to a source i don't see the red led for charging batterie :s
and i don't know what is this model, it's an HD2
And the last time i boot it, it's written Software uptade fail, try again with a /!\
If its a US T-Mobile one (has T-Mobile at the top and green & red buttons at the bottom) then its most likely that the radio he has flashed to it is the wrong one.
If this is the case, then there is no fix.
Otherwise, its best to see if you can send it back for repair