Hi,
I've just bought a Motorola HS810 for my O2 XDA 2 (I have uninstalled the pre-installed O2 software) and cannot seem to get them to work together. The device is bonded ok on handsfree mode but doesn't seem to respond to anything that is sent from the headset. I've noticed there seems to be some fix going around from http://bluetooth.i-networx.de/ but not sure if this is relevent. Any help is much appreciated.
Thanks,
John.
it's not working on my end as well
me bad, it's working
i forgot to enable the BT Headset profile
Related
Have been using XDA II with Motorola HS810 headset for the past month. All working fine until a couple of days ago. The XDA locates and bonds to HS810, confirms use for the Headset profile. Now the headset will not respond to incoming calls. I've reset the XDA several times, rebonded the HS810 to no avail. Any clues? BTW when it was working - fantastic... comfortable and highly recommended... except for this latest glitch.
Thanks in advance for any solution offered.
Try to reset HS-810 by connecting with the charger for 5 seconds and dis-connect it.
I am not sure whether it's work for you. However, this method was stated in the manual for the previous model.
Hope this help
hey,
something similar to what happened to me a couple of weeks back. my xda2 would recognize the headset upon bonding (and numerous resets and rebonding) but would not transfer the calls or receive any throught the headset. i then found out that i installed an application that was screwing with the bluetooth profile (not to mention my alarms/notifications). if you recently installed some new apps you can check out which one could be jerking with the bluetooth program. in my case i did a hard reset, installed the original programs i had originally (and the only ones i use), and from there i found out which app was causing the screw up. hope that helps.
2 cents
robson
Thnaks for your feedback.
The only non-standard programs on the XDA are "City Time" and "Lextionary". I'm loathed to go thru' another hard reset but will try deleting both of these progs and see what happens.
Hi,
I've recently purchased an xda 2 from O2 it came with a free bluetooth headset, but I've a few problems and wondered if anybody could answer a couple of questions.
1. The little blue flashed LED, is it meant to flash all the time that bluetooth is being used? It seems to start flashing and then just stop.
2. When I go into my bluetooth settings and turn it back on when it's switched itself off I don't get the LED flashing then I go back into the settings again and it says that it's off. Is this what it's meant to do?
Any good guides/tools about using bluetooth with this device?
Beginning to pull my hair out and I've not much to spare!
Cheers
Marc
Free? from O2? how?
1stly howd u manage 2 get sumit out of O2 for free? i would be worried about that allready!!
what bt Headset did u get? with mine, i get a blue light flashing intermitently when the headset is turned on, and it doesnt change when im making a call.
which bt settings are you talking about? obviously you need to have bonded with the device, which the headsets instructions should cover.
to turn bt on the phone on you click on the bt icon at the botom of the active screen and select the On radio button.
if headset profile is enabled then there should B a small blue headset symbol next to the bt symbol, if its not set, or not turned on then it will be gray. if it is gray then click on it and hopefully it will turn blue to activate the headset profile.
there are sum interesting bt tools around, but the "recomended" setup is the Pocket Bluetooth Tools for the O2 XDA II and the MDA II which is available from here:
http://bluetooth.i-networx.de/index_e.html
I hope that helps.
Smiley
sounds like you are using bluetooth tools and have got the clock symbol live (not greyed out), it times out the internet connection but doesnt seem to tell o2's software that it turned it off so when you go in, it quite often seems to think its on when its actually off !!
Hi, I didn't have the bluetooth tools loaded, but I've downloaded them from the site you suggested and everything seems to work better.
The headset did indeed come free from O2 I was quite surprised too.
I've think I've attached an image of it, not sure what make it is does BlueTrek sound good?
Yeah that sounds about right, their website doesnt actually give any details, helpfull as allways!! :roll:
neway, have u got everything working properly now?
Smiley
Hmm...somebody had the same problem with his Bluetreks G2 and the XDA2.
He did a special pairing mode and it solved the problem.
I think its in the G2s instruction manual.
Had a look at the manual can't see anything special in the way that you pair the G2 to the XDA2.
Do you use this bluetooth toolkit?
It still seems flaky, I tried answering a couple of calls with the headset yesterday and nobody could here me at the other end of the phone. Sometimes I get it where the phone says that I have "no bluetooth available" I have to remove the battery and insert it again. Is this normal?
Regards
Marc
Marc,
I get the same symptoms you describe when I'm using ActiveSync with my XDA2 over bluetooth, but never with my HBH-65 BT headset. I'm not using any additional bluetooth tools or anything like that. Just the standard built-in bluetooth on my original (November 03) ROM.
Sometimes if my bluetooth ActiveSync connection is idle for a while the connection drops and the flashing blue light on the XDA2 goes out. However, if I tap the little blue BT icon at the bottom of the Today screen, the setting shows that BT is still turned on. I have to tap it on, then off then on again to cycle the status and convince the machine that bluetooth is really back on again. :? This sounds like the problem you describe.
However, no problems like this with my BT headset, which works perfectly.
This isn't any help, but at least you know you're not alone!
Does anybody know if a registry entry exists to turn the bt headset profile on and off?
I've got headset working now but it switches off frequently.
Cheers
Marc
I have a BlueTrek G2 for my Imate and it's working with no problems at all ... I tried BT tools but didn't find it useful as I thought it will give me a "Hands free" profile but it doesn't :x
mokl: maybe it's a ROM issue ... mine is 1.72 WWE, what's yours ?
The rom version is 1.60.00WWE
Just to let everybody know, I had some major problems with my bluetooth on my XDA 2. Tried everything, eventually got a replacement from 02 and the new one works fine now, so it must have been a hardware fault.
hi, my name is warren and i'm from australia, and i require some help with my o2 xda ii mini
i have been playing around with bluetooth stacks and programs to get my bluetooth gps reciever to talk with my xdaII mini, and have come intio a new problem that has only seemed to come about recently
so.. the phone works fine
except.. when i am in-call, if i turn the pda on (eg to make a note or check the call timer) then the phone stops working. i can still hear the other person, but they can't hear me. i assume the microphone stops working or something? if i call them back immediately it works fine again, its just if i turn it on in-call!
i installed a bleutooth stack on here but i cant uninstall it to see if that fixes the problem
HELP!
thanks,
Warren
Which BT stack did you install? Most GPS receivers work flowlessly. In most cases the only thing to install is a patch called BTComPort.cab.
yeah unfortunately i realise that now!
i did install the above "BTcomport" patch but i also installed this stack: http://forum.xda-developers.com/showthread.php?t=249219
nto sure what to do. i tried uninstalling it but it says files are in use. i tried deleting all the required files, but cannot delete 2 of them which are apparently in use
I just recently acquired a stereo bluetooth headset from dell model number BH200 and so far the stereo music quality is superb, but the moment a call comes in or I pick up a call it immediately disconnects itself. My question would be if any of you guys have any experience with this issue. the Stereo bluetooth and handsfree profile are both set to active. Any suggestions or hints?
I'm going to go on a limb here and assume that you guys haven't had access to the aforementioned bluetooth and i'm short out of luck here... right?
p.s. SAY IT AINT SO!!!!
Hi, I also have the same headphones and the same problem - only on HTC Universal flashed with WM6.
I search a bit on Google and it seems that the problem is with MS Bluetooth stack - it was working correctly for WM5 (but no A2DP), now in WM6 A2DP works, but handsfree does not.
Right now I'm testing alternative BT stacks - started with UniBT (it's Broadcomm stack modified for Universal) - now A2DP works flawlessly (before that, it didn't), but handsfree/headphones mode does not. At least trying to receive the phone call doesn't turn the headphones off.
i tested my fuze with a jabra bt2010 and it works fine. I'd prefer to not carry 2 bluetooth devices so i'm trying to find a way for it to work. I've been suggested to use a widcomm bluetooth stack as well but i dont know how to change my stack. If anyone here does know how to do it, please do enlighten us.
It's been nearly a month so I'm going to bump this thread in hopes of someone might possibly have some insight into this.
Push/bump.
I got the S9 now, it works for both functions but craps out completely when i'm outside, really bad signal reception as well as "muffled sounds" according to my audiophilic and audiophobic friends.
I think it has to be something to do with the actual firmware inside the bh200 that is wreaking some unknown havoc.
Dell bluetooth headset BH200 not working with Sony Xperia X1i
I have a Dell Bluetooth headset model BH200 and in A2DP mode, works flawless but the moment it is used with handsfree mode for call, the connection is broken and the headset switches off itself. This headset works very well with other non WM6.1 devices. Any clues with anony one what should be done in this case, some people have suggested JETware Hands-free Extension , any one tried on this.
I actually gave up on the bh200 and got myself a jabra bt8010. it works like a charm and the sound is just as good as the bh200
Indeed... i used to have a WM device (Mio A501) and I had the WM6.1 Pro..
I bought this BT at that time and it didn't work on WM6.1 (it even didn't asked me the PIN to pair it) but, when I tried with WM5.0, everything worked great, great sound on call's music, etc.. now I have a Sapphire and I'm not able to make calls on it (music works), but since I'm not driving and people used to look like "what a crazy guy speaking in English alone, no cables, it must be a mp3 or something.. hmmm" when I was on a call, it doesn't make a huge difference
i have yet to try this on wm6.5 but I highly doubt there would be a change..i'll give an update when I do charge up the bh200
i charged the bh200 up completely and tested it out.. it was a failure.. looks like 6.5 did not do anything to help...
Maybe windows mobile 7 will work.......... maybe.
You can use BH200 on call by this way only(I tested)
1. Turn on BT
2. Accepted call(However just Turn on your BT after accept call is OK)
3. Turn on BH200
4. Pair ur PDA w/ BH200
5. Done
IS this thead still active? I have a solution
Guys..
Use Reg edit and make the following modifications in your WM device by creating a new DWORD value 0 with the parameter UseESCO. Check out the path
HKLM\SOFTWARE\Microsoft\Bluetooth\AudioGateway\UseESCO = DWORD:0 (Dont use space between UseESCO)
Then restart the phone and delete any previous BT devices on your phone, start up the paining process and get it to work.
worked flawlessly on my Dell BH200
Thanks,
Raj.
seriously????
the fix is in one freaking registry tweak????
I'll have to wait 2 months before i can test this since i left the damn thing to rot in the US while i'm here in thailand..-_-
mputtr said:
seriously????
the fix is in one freaking registry tweak????
I'll have to wait 2 months before i can test this since i left the damn thing to rot in the US while i'm here in thailand..-_-
Click to expand...
Click to collapse
Of course Bro. I waited for 6 months myself too.. and finally found it in a microsoft forum.. well at last got it to work and my 200 sounds better than ever with its new functionality..
All the best
Raj
sweet! thanks a bunch man!
prudviraj said:
Of course Bro. I waited for 6 months myself too.. and finally found it in a microsoft forum.. well at last got it to work and my 200 sounds better than ever with its new functionality..
All the best
Raj
Click to expand...
Click to collapse
Heya, Finally got back ot he US and tested out the BH200 with the fix you mentioned. it works!!!!!
although, i'm wondering if you're having problems with the bh200 not wanting to connect to the phone automatically.
Need help for the same problem in android
I am having similar issues on my Nexus one. Dell BH200 works for music playback but stops functioning when a call is made or received. Even the connection between the phone & BH200 gets lost.
I would be really glad to get some help on this.
recently, I've got a problem when I'm attempting to connect nokia BH 106 bluetooth headset to my tombstone 2, but failed and failed. the headset just didn't appear in my device list!
my SE liveview is on its way, and I'm worrying about whether it will work normally with my tombstone 2 or not...
so, could you help me? or just tell me whether liveview will work normally or not......thanks a lot!
sent from my Milestone 2
Have you read the manual for the BT handsfree and put it into pairing mode before trying to pair it?
Szadzik said:
Have you read the manual for the BT handsfree and put it into pairing mode before trying to pair it?
Click to expand...
Click to collapse
I tried to reset it to factory settings, but this didn't work. My SE liveview works very well with my tombstone, so I sold the headset. Anyway, thanks a lot~
sent from my MOTOROLA Milestone 2