Hello i've tried to reset my nokia lumia 530 because i have the blue screen with sad smiley when i booted my phone.
So i run WDRT 3.14 my device connected to the appli , it download the firmware but an error occured in the end of installation and now my phone is block in the purple installation firmware.
If i reboot it chain "Nokia logo then the purple screen"
My phone isn't reconized anymore by WDRT can i do something else?
Sorry for my english.
Thanks.
try this methode :https://forum.xda-developers.com/showthread.php?t=2515453
i can reinstall the firmware but in the end i have this error.
Flashing completed successfully! Status: 0x0001
Safe write descriptor index reached: true
Payload data transfer speed (34.54 MB/s) Elapsed time 35.84 sec
Payload data size 1237.891846 MB
Read flashing status..
Invalid flashing status (1) after flashing
[IN] programSecureFfuFile. Closing \Users\L_I\Desktop\Package\FullFlashUpdate.ffu
programming operation failed!
Rebooting device
Sending reset command to device
Reset command sent successfully.
Operation took about 37.00 seconds. Average transfer speed was 35.08 MB/s.
DEVICE_REPORTED_ERROR_DURING_SFFU_PROGRAMMING
THOR2 1.8.2.18 exited with error code 393216 (0x60000)
Related
Hello,
These are what I did:
Installed WDRT
Installed WP Internals v2.8
Attempted to switch to mass storage mode from Manual Mode
It asked to Unlock Bootloader
Took Unlock Bootloader option
Flashing failed when switching to mass storage mode
Phone rebooted to blue screen "Bitlocker key required"
Then I tried almost every steps here on various posts to reset/flash a new rom., it always ends with flash failed or...
I get this error from thor2 when trying to falsh ffu: Signature check of FFU file fails. Reason(s): The FFU file is not correctly signed or not signed for this device.
I am unable to use the emergency mode of thor2 (I have the files needed) as it times out at 'get connectionstring''
I dont know what else to do., Please any help is appreciated
PS: Couple of posts I ve been through
https://forum.xda-developers.com/showthread.php?t=2515453
https://forum.xda-developers.com/wi...nt/fix-dead-phone-bricked-bootloader-t3496232
@Heathcliff74
@DilanChd
@rgxHost
Thanks
V
Yesterday suddenly while turning on my device it stuck at android one logo.
Device status : Bootloader locked, No Root. Never hard reset in past. it was running as it was out of the box with latest May 2020 security update.
So, i tried to unlock bootloader with adb which offcourse failed.
then i tried to hard reset, as i opened recovery mode (power + vol+) there was an error E: failed to load bcb message, failed to fsync : operation not permitted.
still i choose wipedata/factory reset. it stuck at [wiping data... formatting disk...] for 5 hours. i understood it wont proceed.
Then, i opened the device went to unlock bootloader with EDL method as shown in few videos ( by connecting pins and plugging usb to pc). it showed in the pc ( qualcomm was listed in device manager> ports)
Then i downloaded Mi flash and official rom, was unable to flash with error "ack count don't match".
Again reading here and there, i downloaded miflash-beta, it was able to flash the device successfully.
disconnected the usb, connected the battery strap and started device > Again it stuck at android one screen for 1 hour.
So, i again went to recovery mode to find out that the error " E: failed to load bcb message, failed to fsync : operation not permitted." Still exists.
Read here in some thread that it is related to partition damaged, but no solution anywhere.
Please help me with solution. This is my only phone. i don't have any job nor money to buy other phone during lockdown.
HELP.
Thanks everyone for this wonderful forum.
MIA1_Stuck said:
Yesterday suddenly while turning on my device it stuck at android one logo.
Device status : Bootloader locked, No Root. Never hard reset in past. it was running as it was out of the box with latest May 2020 security update.
So, i tried to unlock bootloader with adb which offcourse failed.
then i tried to hard reset, as i opened recovery mode (power + vol+) there was an error E: failed to load bcb message, failed to fsync : operation not permitted.
still i choose wipedata/factory reset. it stuck at [wiping data... formatting disk...] for 5 hours. i understood it wont proceed.
Then, i opened the device went to unlock bootloader with EDL method as shown in few videos ( by connecting pins and plugging usb to pc). it showed in the pc ( qualcomm was listed in device manager> ports)
Then i downloaded Mi flash and official rom, was unable to flash with error "ack count don't match".
Again reading here and there, i downloaded miflash-beta, it was able to flash the device successfully.
disconnected the usb, connected the battery strap and started device > Again it stuck at android one screen for 1 hour.
So, i again went to recovery mode to find out that the error " E: failed to load bcb message, failed to fsync : operation not permitted." Still exists.
Read here in some thread that it is related to partition damaged, but no solution anywhere.
Please help me with solution. This is my only phone. i don't have any job nor money to buy other phone during lockdown.
HELP.
Thanks everyone for this wonderful forum.
Click to expand...
Click to collapse
did you find any solution
Same with my phone. Did you find any solution ?
Today i wanted to update my phone from cynaogenmod to a recent lineageos. It followed this guide jfltexx/install, but when i tried to "heimdall flash --RECOVERY ...", the blue progress bar on the phone got to ~99% - then heimdall crashed:
Code:
...
Downloading device's PIT file...
PIT file download successful.
Uploading RECOVERY
100%libusb: error [udev_hotplug_event] ignoring udev action bind
ERROR: Failed to confirm end of file transfer sequence!
ERROR: RECOVERY upload failed!
Ending session...
ERROR: Failed to send end session packet!
Releasing device interface...
Because at that point nothing would change anymore, i unplugged the phone and rebooted. Since then the phone won't boot android anymore and reports "Firmware upgrade encountered an issue. Please select recovery mode in Kies & try again." when booting to recovery mode. Download mode is still accessible, but worthless:
Flashing the original ROM fails with "Complete(Write) operation failed": imgur
Flashing it with a PIT i found on this forum doesn't work either: imgur
Is my phone completely lost? Is there something i can do?
aenderboy said:
Today i wanted to update my phone from cynaogenmod to a recent lineageos. It followed this guide jfltexx/install, but when i tried to "heimdall flash --RECOVERY ...", the blue progress bar on the phone got to ~99% - then heimdall crashed:
Code:
...
Downloading device's PIT file...
PIT file download successful.
Uploading RECOVERY
100%libusb: error [udev_hotplug_event] ignoring udev action bind
ERROR: Failed to confirm end of file transfer sequence!
ERROR: RECOVERY upload failed!
Ending session...
ERROR: Failed to send end session packet!
Releasing device interface...
Because at that point nothing would change anymore, i unplugged the phone and rebooted. Since then the phone won't boot android anymore and reports "Firmware upgrade encountered an issue. Please select recovery mode in Kies & try again." when booting to recovery mode. Download mode is still accessible, but worthless:
Flashing the original ROM fails with "Complete(Write) operation failed": imgur
Flashing it with a PIT i found on this forum doesn't work either: imgur
Is my phone completely lost? Is there something i can do?
Click to expand...
Click to collapse
Hello,
Please follow my Guides. I recommend you to follow the guide "clean install from scratch" and also use Odin. Everything you need it's on my thread and in my collection.
Issue Resolved
The solution was to use a shorter USB cable. Thank you so much for making me not loose my faith!
Days ago , i had an invalid boot image problem when i try to flash lineage os.Then i wiped internal storage and fix mount /data errors.But because of image file somehow my phone model and brand is changed.Then i discovered QFIL and use a solution from here for fix everything.It fixed everything but my phone was in Factory Mode.I tried an file i found on internet for fix and i flashed it with QFIL.But my device not open and i tried to flash qfil and qcn file again.It gives me error every time and i selected erase all before download.But 30 minutes after i press download my pc battery get low and turned off.
Now when i connect my device it says "USB device is not recognized.The last USB device you connected to this computer has malfunctioned and windows doesn't recognize it" . I tried change value of ErrorControl of USBSTOR in regedit but i cant find usbstor.inf in system32 after i did it.Now i have a phone with no vibration , no fastboot ,no recovery, no boot or edl.I tried edl points over and over again and i tried re-install drivers too.I cant see anything cause my phone cant boot.
My Device =Asus Zenfone Max (ZC500KL/ZO10D with Snapdragon 410)
ROM: Stock rom with Factory Mode
QFIL Port : No port (It didn't recognize )
Device Manager : unknown usb device (device descriptor request failed)
Error Code: A request for the USB device descriptor failed. CODE 43
Note:Sorry for my bad English.Please help
I press power button 10 sec and pc can't detect it but qfil can.So i tried again.But it gives me sahara error everytime
I am giving port traces and log files in below
I was flashing a firmware with Odin on SM-T725 (it's not first time) and error occurred. Now i have a problem because also if i start tablet with + and - volume and put usb cable in it , it start in download mode but after 5 second it reboot. It goes in bootloop on error "An error has occurred while updating th device software . Use the emergency recovery function in smart switch pc software". The problem is that is i start to flash again wigth odin it start but in 5/6 second it reboot. I really don't know how to flash again if it always start to reboot!