Hello!
Any options turn off usb charging?
I use external dac and problem with,,,
Thanks
Related
I'm on CM 10.2, so it could be a bug with that.
At work I have a usb 3.0 hub, which will charge devices at 1A, twice USB 2.0. But if you hook the tablet up to the hub the tablet will display that it's charging, but for some reason it really isn't. It displayed charging for an hour and lost 5% while screen off.
Go and enable USB Debugging and all the sudden the hub will light up and charge at 1A.
kinda dumb, but it works.
I am using a Seek Thermal imager via the N10's USB OTG port. My battery is old and takes a dive when I use the imager. Roughly only an hour of use before it kills the battery. Obviously the thermal sensor draws power from the n10's battery.
I think I read somewhere that I cannot use the pogo plug to charge while using the otg. Is that correct? That would have been an ideal solution.
Would it be possible to use an external battery (14000mAh USB battery supply) and feed/splice it into the usb otg cable with the imager? What about a 4 port USB hub using the battery and thermal sensor plugged into the otg? Not sure since I don't think it works like a USB host and don't think you can back feed power via USB host port.
Any ideas? Could any of this work? Thanks for any suggestions!
Ed
In short, I have an unrooted sprint s6e+. I plugged my usb dac in today and while I got great audio out of it, it wouldnt charge while connected to the audio device (usb otg cable with a charger connected, verified the charger works) is there anything I can enable without root to charge on the host cable? If not, has anyone tried wireless charging while in host mode? And does it work?
Doesn't seem like anyone else was wondering, but no... Cannot wireless charge in host mode either...
if i have my edge recharging on a wireless charger (connected with samsungs own power supply and usb cable) then i'm guessing it's not a good idea to also plug the phone into the PC so i can copy some stuff on there?
Does anyone able to use USB Hub while charging the phone? I have a Type C USB Hub with charging port. The connected USB devices became disconnected once I plug in the charger at the hub. They became connected again once I removed the charger from the hub. Is this an issue with the hub itself or does it have to with software on the phone? My Pocofone F1 are able to use the USB devices while still being charge so I don't think the hub is the problem. Can anyone confirm?