Tried intalling Android 6.0 Marshmallow and phone got bricked ( I assume), it's stuck on the Huawei logo. Turning "off" just restarts it and vol+, vol- and power button just puts it into the EMUI screen where it says "Verifying update package", "Installing update package". This gets to 100%, phone restarts and back to huawei logo. any ideas?
Thanks in advance.
Hi!
Is a P8 Lite ALE-L21?
Try this to unbrick: https://forum.xda-developers.com/p8lite/help/fix-bootloop-freeze-logo-t3639688
.
Related
I have a problem with p8 lite, when i update it to marshmallow from b188, it start updating but it stuck on 0% and screen start blinking, no response after that, doesn't turn off or on, also doesn't factory reset and also no response on adb or fastboot
try to boot wiht al three buttons pressed and connected to pc with usb
I have the same problem , did you perhaps find a solution
Hi there
I've just replaced the screen of my P8 lite. I booted, everything working fine in Lollipop. so i start downloading the update to 6.0 via the updater app.
it just casually installed the update, went to the screen with percentage of how far the update is at. It finished, 100% then decides to reboot and poof, only black screen, no boot up screen or all the other stuff. Just a plain Black LED Backlight.
I've tried downloading the 6.0 to 5.0 firmware on my sdcard in dload map. when i boot the phone by holding volume +, volume - and power button, it just boots back in the black screen, not starting the update.
I've also tried other firmware the site offers.
Here is some information about my device:
Huawei P8 lite ALE-L21
Which steps should i consider taking here?
thanks in advance
Update: apparently it's just some problems with the hardware of the screen, since when i press volume +,- buttons it still makes sounds, and double tap takes a photo. But isn't it still quiet strange that right when the update hits 100% it started malfunctioning?
Hi.
Last night I copied the downgrade update.app on my huawei p9 lite and the installation went fine. after the update the phone is not starting again. When I turn it on the only thing that happens is that the red huawei logo is displayed and that's it. nothing else.
I copied another update.app on the sd card but I can't start the update process when I hold down volume +/- and power.
Any advice how to bring the phone back to life?
Thanks for your help.
I have a tab e 8.0 which doesnt turn when i press the power button but if i plugged in my charger it turns on then it will go to "installing system update" with a android logo then it will say "erasing" then "installing system update" then "erasing", it goes looping like this, at first i flash a stock rom but the problem is still there, is this a soft brick or hard brick? Any solutions? Tia
Up
Any solutions?
Any solutions ??
Everything worked fine,
i just update to c432 version and stucked to huawei logo, i tried to go to emui or recovery but the phone keeps to be stucked to the huawei logo.
It starts only to the system and works fine after battery is out of charge, then i plug it in and works with the previous version like nothing happens.
Is any way to hard reset it and make it work again? i don't need any data from the phone, everything is backed up
Please help!!!!