I rooted my SM-G7102 using KingoRoot App for Windows.
Later I installed Twrp recovery using Odin 3.10.7 :http://forum.xda-developers.com/galaxy-grand-2/orig-development/twrp-unofficial-twrp-recovery-t2798433
Booted into recovery, did a factory reset and tried installing Resurrection Remix: http://forum.xda-developers.com/galaxy-grand-2/orig-development/rom-resurrection-remix-m-v5-6-7-t3360391
It installed successfully I latter install 6.0 micro gapps as advised on the ROM's Page and rebooted however it just showed me Sammy BootLogo and then a blue screen and then restarted again
I later did a complete format including /data and also tried installing CM13 unofficial: http://forum.xda-developers.com/galaxy-grand-2/orig-development/cm-13-0-ms013g-cyanogenmod-13-grand-2-t3299635
however same results.
Another alter I tried was installing both ROMs mentioned above without GAPPS however it didn't work too!
Would love to recieve some help, Thanks.
[EDIT]
p.s: I was using Samsung's Stock Andorid v4.3 firmware before flashing.
Also here is my recovery log: https://gist.githubusercontent.com/ArchKudo/ab4738a2482121fde280643fc86b5ab6/raw/0cae8a800552fc331d841bd1a6798c9a41e524ec/recovery.log
[EDIT 2]
It worked! Installed 4.4.2 and re-flashed
Flash 4.4.2 firmware
Then flash custom roms
Igor2906 said:
Flash 4.4.2 firmware
Then flash custom roms
Click to expand...
Click to collapse
Thanks for the reply!
Should I use the same TWRP recovery as mentioned before?
Also is 4.3 known to cause bootloops or is there some guesswork involved?
noobno.NaN said:
Thanks for the reply!
Should I use the same TWRP recovery as mentioned before?
Also is 4.3 known to cause bootloops or is there some guesswork involved?
Click to expand...
Click to collapse
Yeah use TWRP
me2 facing same problrm but i have first install from official 4.4.2 firmeware plz help
Hey guys,
I'm trying to install Dr. Ketan's M6 ROM to my 910F.
Following all of the instructions on his thread here.
I am using CWM,
I rooted my 910F with cf-auto, I got the "Set warranty bit: Kernel" message, however, the phone worked fine.
I couldn't get the bootloader and modem from his link, but I searched for the same filename and found it elsewhere.
Flashed M6 and then the fix for the 910F, however, it never boots. I left it an hour+, just boot looping on the Samsung screen.
Does anyone have any advice? I'm unsure how to go around this and get my device up and running again. I may have left out information, which I can provide if needed.
Does anyone have any experience with this issue installing the same ROM on the 910F?
All help will be greatly appreciated.
Narafu
Narafu said:
Hey guys,
I'm trying to install Dr. Ketan's M6 ROM to my 910F.
Following all of the instructions on his thread here.
I am using CWM,
I rooted my 910F with cf-auto, I got the "Set warranty bit: Kernel" message, however, the phone worked fine.
I couldn't get the bootloader and modem from his link, but I searched for the same filename and found it elsewhere.
Flashed M6 and then the fix for the 910F, however, it never boots. I left it an hour+, just boot looping on the Samsung screen.
Does anyone have any advice? I'm unsure how to go around this and get my device up and running again. I may have left out information, which I can provide if needed.
Does anyone have any experience with this issue installing the same ROM on the 910F?
All help will be greatly appreciated.
Narafu
Click to expand...
Click to collapse
Flash the kernel again , i flashed the h-vitamin kernel and then it booted correctly , but dont forget to, flash super su 2.78 after flashing the kernel .
You can also flash this rom on h4 bootloader (august patch) . I flashed it on h4 and didnt faced any issues.
Reporting Via N910G
yashthemw said:
Flash the kernel again , i flashed the h-vitamin kernel and then it booted correctly , but dont forget to, flash super su 2.78 after flashing the kernel .
You can also flash this rom on h4 bootloader (august patch) . I flashed it on h4 and didnt faced any issues.
Reporting Via N910G
Click to expand...
Click to collapse
Will attempt this now. Just got to charge my device a little. Ran it down earlier. Will report back with what happens.
I completely forgot about flashing supersu afterwards.
Do you by any chance have a link for the H4 bootloader? :angel:
Narafu said:
Will attempt this now. Just got to charge my device a little. Ran it down earlier. Will report back with what happens.
I completely forgot about flashing supersu afterwards.
Do you by any chance have a link for the H4 bootloader? :angel:
Click to expand...
Click to collapse
Sorry , i dont have .
Reporting Via N910G
Still not working - any advice anyone?
Narafu said:
Still not working - any advice anyone?
Click to expand...
Click to collapse
I followed through this on my canadian variant. http://galaxynote4root.com/t-mobile-note-4-roms/how-to-convert-galaxy-note-4-into-galaxy-s7-edge/2/
(Download the latest rom from dr.ketan's site)
Go in your custom recovery, wipe data + system followed by a factory reset
Flash ROM followed by data fix/kernel then supersu
When it's finished, it took my phone around 30-35 minutes to finally boot up from that samsung screen. Keep it plugged in and charging and do whatever. The next boots are quick and take 20 seconds ish.
I had the Dot os ROM installed on my device, however in my attempt to update TWRP on it - I must have messed something and the device was going beyond the Samsung Logo. I thought reverting back to Original ROM would be a safe bet. I have flashed to the original ROM using Odin and the rom boots up beautifully, I then flash TWRP via Odin and then copy the Dot OS Oreo zip and Gapps zip files and flash it. Everything installs fine but after the first boot it goes to a weird static colorbar screen (much like the screen gone bad) and stays there. I have tried a different ROM but it all ends up doing the same and stuck on the 'black' screen. Any suggestions what might I do ?
I have a yu yureka running on cm11 kitkat stock rom on which i tired to flash twrp. I flashed the right files but now the phone is stuck in bootloop. How do i fix this? I tried searching a lot but the only solution i found was to flash the stock firmware. All the links to download files are broken. Can anyone help me? Im a newbie at this stuff.
Groverkss said:
I have a yu yureka running on cm11 kitkat stock rom on which i tired to flash twrp. I flashed the right files but now the phone is stuck in bootloop. How do i fix this? I tried searching a lot but the only solution i found was to flash the stock firmware. All the links to download files are broken. Can anyone help me? Im a newbie at this stuff.
Click to expand...
Click to collapse
Remove battery
Hold volume up
Insert battery
Connect usb cable
Enter fastboot command
Unlock bootloader
Flash twrp
Format data and cache
Flash custom ROM
Your method will not work
method will not work. I fixed it after a lot of trying.
Solution: Flash an old version of TWRP(like 2.8). Kitkat doesn't support the newer versions of TWRP. This is why flashing new TWRP doesn't work. Now install the stock ROM of KitKat cm11 and install Stock recovery. UPDATE cm 11 to cm12 using official updates using stock recovery. Now flash new TWRP and it will work. I don't use this site a lot but if you ever see someone askung this then this method will work.
I've been trying to load a custom ROM up on this Canadian G903W for a little while with no success. I can get TWRP on with ODIN but once I go to install any ROM available on XDA the phone will not boot. Just hangs at the Samsung logo. I eventually had to boot back to original stock firmware to get it working again.
What am I doing wrong?
Did you both try official LineageOS 17.1?
Same
Same issue mate. The 903W seems to be neglected, I had a hell of a time getting twrp to flash even (turns out all you have to do is stock rom flash first).
I'll see if I can get an eng build and debug the bootloops.