Related
Hi
need help!!!!!
My phone is completely messed up.
i got an update form LG.
after installing it the phone got suck in boot loop.
I has CWM installed.
i but could and even when try to install new rom it was still in boot loop.
i installed manual via adb commands TWRP.
and then thing became real bad.
no after it powers up i get the LG logo.
1 sec after i get few error codes and then black screen without ADB support.
i trierd to get into download mode after reading in forums that only this can help.
but I can't.
I powered down my phone in all possible methods:
power 10sec, power + V- 10 sec, power + V+ 10 sec.
after the phone is off i tried power it back into download mode with the next combinations:
power + V+ and then USB, power + V- and then USB,power + V+ and V- and then USB.
did not work.
can't get into download mode.
I will be happy to get some help.
Thanks
Ran :good:
sorry was wrong.
try turn phone off, add usb, then press volume up. I think that's it.
Hi
did no work also
I am having the same problem, went to lg service centre, they could not enter download mode as well. I might need to change the circuit board for $321 singapore dollars..
Hi
i think you have to use this fix: http://forum.xda-developers.com/showthread.php?t=2582142
This happened to me,
Try holding the power and volume down hold until lg logo, let go and press and hold the volume down and power again, it should get you in recovery.
It might get you into a screen called "Factory hard reset" Agree using the power button, and it should take you to your recovery, and try flashing a ROM along with the Gapps (if you want, which I did) and then I used a recovery file after booting back into recovery to restore it to my previous state.
Good luck :good:
Shut down phone
From what I got from this, you're having problems shutting down your phone, correct? It keeps booting back up after the screen goes black? If this is the case, hold the power button (and don't let go) until it goes black, reboots itself, then goes black again. Shouldn't take more than 2 seconds after rebooting to shut down. Then, you can do volume up + USB to get into download mode.
Ben_Z98 said:
From what I got from this, you're having problems shutting down your phone, correct? It keeps booting back up after the screen goes black? If this is the case, hold the power button (and don't let go) until it goes black, reboots itself, then goes black again. Shouldn't take more than 2 seconds after rebooting to shut down. Then, you can do volume up + USB to get into download mode.
Click to expand...
Click to collapse
Thanks for your help,it sorted out my problem! :good:
Please help me. I am in a sort of panic right now.
I have a ZTE Blade C2 v809, sold here in Portugal as Meo Smart A12. It was rooted and working fine. I was however getting some error 24's trying to install apps. I thought this might have had to do with using Titanium Backup to remove TouchPal (I did make a backup first), so I decided to restore TouchPal. There were however some errors in the restore and it was stuck there, so I decided to reboot the phone.
Chaos. Now it wont boot. If I press the button normally, the phone boots, I see the android logo, the screen goes black (Not shutdown black, a sort of light black background) and nothing happens. If I try to boot into Recovery mode by holding the power button and the volume down key, I just get the android logo stuck there, nothing happens. If I hold the power button and the volume up key, I get the picture of that laying down android with the message error.
Any more info I must provide please tell me, I am desperate for a solution, If I lose this phone I wont be able to get another one.
Okay I fixed it. Turns out the recovery menu DID work if I waited for a long time and tapped the screen. Used the update.zip available from the site, and it works like a charm
Yay, I bricked my phone, too.
I did something similar, changed recovery-from-boot.p name to recovery-from-boot.p-bak and install-recovery.sh to install-recovery.sh-bak
Now the phone doesn't boot properly, in fact it's stuck in a boot loop:
>starts
>shows white ZTE logo on screen
>restarts
Tried connecting the phone via USB cable and used fastboot devices & adb devices commands, no devices found.
Also tried pressing "power + vol down" and "power + vol up", nothing. I can't enter recovery mode or bootloader.
Apparently the remaining way to get in it's trough the SD slot, or maybe there's another way.
I kindly ask for help, couldn't be possible that I ruined this cell phone so fast.
Ideas, somebody?
Hi Masters,
Need your advice here.
My p9 lite cannot boot up and only shows your device is booting now screen.
I cannot power off even force power off, and there is no responding whatever key combinations i pushed.
The step taken to this error is I did unlock my p9 lite and tried to flash twrp by following the guide, then I cannot enter fastboot mode and recovery mode after that.
I tried take out the battery and let the phone disconnect with power supply, after i put back the battery, i push the power key it still shows same screen as your device is booting now.
Any idea how to resolve this? I assume some fatal error with the motherboard, but i can say nothing after i unlock the phone.
Your suggestion and advice are much appreciateļ¼ thank you!
I had the same problem,what I did was force power off by holding power button for ,well idk how long but until device booted down,then I held volume down and connected it to pc,so it enters fastboot,but you have to do it fast,as it will reboot once its turned off.Then I tried various twrps,revolution recovery etc,and the only one that worked was meticulus twrp.I know you said you cant force power off,but try holding power key long
Once you hold the power off button, the phone will never power off, instead, the phone will reboot and bring you to the error page "your device is booting now" and stuck there. I tried to push the power up or power down button before i see huawei logo, but it will show me the same page.
Yes,when you hold power off phone will reboot,and you have to be fast with volume down and cable.Pre-plug the cable it computer ,bring it near phone,power off and before it boots plug it in while holding volume-
thank you for your suggestion. I tried many times, no matter how quickly i am, I only able to see the device booting page. I have mentioned one point above, i did take out the battery, and i see the error screen after i put back the battery, so i assume the problem with motherboard.
How many of you did return the faulty and unlocked phone to service centre then get "free" services?
Hi Guys!
I'm new to XDA developers, but I've been following this forum for many years.
I would like to resurrect my old phone, a Samsung Galaxy S4 Value Edition (GT-I9515), witch is most likely bricked.
About one year ago, the device started to randomly reboot, until it no longer powered on (It was NOT rooted or modded).
Recovery also did not work, so I decided to flash the stock firmware with Odin. The flash failed, so i decided to follow a (really stupid ) guide that said that to solve it was necessary to flash a PIT file of the Samsung GT-I9505, so I tried it.
Since then, I'm not able to boot the phone anymore.
What can I do with the phone now? What have I tried? I'll try to be as clear as possible:
Recovery mode:
I can boot into recovery only by pressing VOL UP + POWER with phone connected to charger, and then inserting battery keeping pressed the buttons, but when I try to boot into Recovery Mode, 3 different things can happen:
It does not power on
It vibrates, then reboot and freeze in Samsung GT-I9515 logo
It vibrates randomly and then open successfully the stock recovery
Download mode:
I can boot into download only by pressing VOL DOWN + POWER with phone connected to charger, and then inserting battery keeping pressed the buttons, but when I try to boot into Download Mode, it seems that the screen freeze at a certain point while loading the recovery mode warning (this warning loads slowly, like a slide from top to bottom). The device rarely fully load the warning, and when it does, when I press the VOL UP key to confirm entering download mode (sometimes it does not respond to VOL UP click for confirmation and i must reboot) Odin is able to find the device but during a flash the Odin log stop at Setup Connection, so the device is not responding.
Normal boot:
Yesterday, after hundreds of attempts, I was able to start the phone normally (I don't know how) , it asked for the initial configuration and language, but when I turned it off, the problem reappeared and I was not able to boot it normally. In most cases, the device freezes in Samsung GT-I9515 logo, it continues to restart or simply does not vibrate or power on.
When charging, I don't see anything such as the charging battery icon or the LED.
I realize that I was wrong to flash that PIT file, but is there anything I can do to make this device work properly?
Thank you in advance for your cooperation.
Noone?
Hi!
I have a problem with a galaxy a40 device, I flashed a stock ROM with Odin, everything went fine, green lights, PASS and all, but now the device just won't go pass the SM logo anymore. When I turn on, logo appears 2-3 secs I get a warning of the unlocked BL then logo comes back and after a second the phone restarts itself and the same goes on forever ( well about several hours, and after that it just shuts off somehow ). I cannot enter recovery mode or download mode at all. I keep pressing the combinations Power + Vol Down, Power + Vol Up, All three and every combinations I have just found on the internet so far. Odin doesnt recognize the phone, which is not a surprise since it won't start up. I have tried with adb but waiting for device is all I get.
How is it even possible that I cannot enter download mode at all? There was no problem with the physical keys, and the power still works, I cannot test the Vol buttons tho.
Has anyone ever had a problem like this? How can I come back from this? Is there a way to flash a ROM without download mode or turned off phone?
Thanks for any help!!
The download mode for this model is different from previous Samsung's :
IIRC, with the phone off, you need to hold VolumeUp and VolumeDown, then plug in the USB cable connected to a computer (you may need to press Power to power up the phone, I can't recall properly).
From there, you should be able to restore a stock ROM with Odin.
Let us know if it helped !
gmarko247 said:
Hi!
I have a problem with a galaxy a40 device, I flashed a stock ROM with Odin, everything went fine, green lights, PASS and all, but now the device just won't go pass the SM logo anymore. When I turn on, logo appears 2-3 secs I get a warning of the unlocked BL then logo comes back and after a second the phone restarts itself and the same goes on forever ( well about several hours, and after that it just shuts off somehow ). I cannot enter recovery mode or download mode at all. I keep pressing the combinations Power + Vol Down, Power + Vol Up, All three and every combinations I have just found on the internet so far. Odin doesnt recognize the phone, which is not a surprise since it won't start up. I have tried with adb but waiting for device is all I get.
How is it even possible that I cannot enter download mode at all? There was no problem with the physical keys, and the power still works, I cannot test the Vol buttons tho.
Has anyone ever had a problem like this? How can I come back from this? Is there a way to flash a ROM without download mode or turned off phone?
Thanks for any help!!
Click to expand...
Click to collapse
Here the same problem, have a40 in loop and never get rocgnized for computer, tryed many different cables, and installed a booring large amount of drivers software and nothing...
you need to power off device completely. let battery drain if you can't shut down. press and keep holding volume down + plug in usb cable for Odin3 (I doubt both?)
aIecxs said:
you need to power off device completely. let battery drain if you can't shut down. press and keep holding volume down + plug in usb cable for Odin3 (I doubt both?)
Click to expand...
Click to collapse
Generic answers, repeated 800 times why really need to waste a post with that? and that not was the problem:
1- For no usb recognition, is this phone bad design, in the back tap where is the battery in the samsung logo more or less if you push with fingers and charge is because the design of baterry is so crap and your usb port goes off when the under tap cable moves or just get little out of conection. If you can get working after push, usb on phone will do too.