Hi guys, I'm from South Africa and I really need help right here!
After updating (not manually) my Huawei P8 Lite ALE-LO2 to android 6.0 it was working perfectly. A few days ago the phone started freezing and powering off, when I try powering the phone on it just flashes a red and green LED light and doesn't switch on, sometimes it does switch on but freezes on the Huawei logo. When I plug it in a charger it still flashes red and green light. Sometimes it would take me to rescue mode and says I need to re-update the system. The problem is I can't power it on, and therefore I can't do anything on the device.
Your help will be highly appreciated.
Related
I have a problem with p8 lite, when i update it to marshmallow from b188, it start updating but it stuck on 0% and screen start blinking, no response after that, doesn't turn off or on, also doesn't factory reset and also no response on adb or fastboot
try to boot wiht al three buttons pressed and connected to pc with usb
I have the same problem , did you perhaps find a solution
Hi there
I've just replaced the screen of my P8 lite. I booted, everything working fine in Lollipop. so i start downloading the update to 6.0 via the updater app.
it just casually installed the update, went to the screen with percentage of how far the update is at. It finished, 100% then decides to reboot and poof, only black screen, no boot up screen or all the other stuff. Just a plain Black LED Backlight.
I've tried downloading the 6.0 to 5.0 firmware on my sdcard in dload map. when i boot the phone by holding volume +, volume - and power button, it just boots back in the black screen, not starting the update.
I've also tried other firmware the site offers.
Here is some information about my device:
Huawei P8 lite ALE-L21
Which steps should i consider taking here?
thanks in advance
Update: apparently it's just some problems with the hardware of the screen, since when i press volume +,- buttons it still makes sounds, and double tap takes a photo. But isn't it still quiet strange that right when the update hits 100% it started malfunctioning?
Hi i tried to flash a custom rom through twrp but it resulted in a bootloop.I managed to get into bootloader mode and flash my official system,recovery etc through fastboot.This resulted in another bootloop i was tired of strugling so i left the phone bootlooping.When i got back the battery was flat (still is)and i now i cant get into recovery,bootlaoder or huawei firwmare restore option.When device is plugged in the red LED flashes and phone loops and turns off afteer few min and shows red bolt with circle around it and repeats.Is my device screwed or fixable?The battery doesnt charge either.
Hello everyone,
Yesterday I got my hands on an old Huawei P8 lite, it was working fine but I intended to root it and play with it a lil bit. The phone was running android 6.0 and I needed to rollback to 5.0. I flashed the rollback ROM without any problem, but then I went to flash the B170 ROM and after it was done, the phone's screen won't show anything. I can see the backlight turning on, and the phone is responsive, since it vibrates whenever I try to turn it on (the boot sound also plays) and the LED turns on whenever it's charging. However, the screen shows nothing but black. The boot logo won't show either. I'm afraid the LCD screen was damaged, but the phone didn't really suffer any kind of physical damage... it happened right after flashing the B170 ROM.
Does anyone have any tips? I've tried to boot the phone either on recovery mode or fastboot, but the screen it's still black, so I can just assume it's booting on that mode even if it doesn't show anything.
Thanks in advance
Huawei Ale-Lo2
Pls help stuck on huawei logo,when i insert the charger its fine,but when i get the charger it stuck on logo again...until it wont turn on and only red and green lights appears...no display