Database Users

my bravo wont boot up

Help please guys totally new to this, i flashed bravox to my phone and today i was gonna flash cm7 but after trying to go into 2nd init defy and it didn't work (i went to stock recovery) i decided to reboot my phone (this is where it starts). That doesn't work, it just loads the motorola logo then powers off and continued to bootloop. So i tried to sbf it using rsd lite that worked and i reached the stage please manually power up this phone, so i try. The logo loads again and i saw the ripples so i think it got the phone back to original state but it still doesn't boot the only good is that it doesn't bootloop anymore
---------- Post added at 08:26 PM ---------- Previous post was at 08:12 PM ----------
it booted but i have no idea how to close this thread

Before you close it please let us know what you did, there are many new users here that will face this kind of problems in the future!!

[Q] Huawei Ideos S7 Hard Reset????

How to hard reset Huawei tablet S7 when turn on it ask for about email nad password
any recovery or flashing method to remove this /////

I tried to upload the file you need, but it wont let me, pm me I will send it to you I had the same problem I will send you the file and instructions on how to get it done

Hi Sapperpipo, can you send me the hard reset procedure too? Pls PM me thanks!

Not sure if this will help:
http://wiki.modaco.com/index.php/Huawei_Firmware_S7
http://www.taskjohann.com/2011/11/factory-reset-for-huawei-s7-tablet.html

I have tried to use the quoted 2nd link, downloaded the dload file and used it. somehow on the middle of the installation process it stops and all the button lights start to blink faster than their initial frequency when the progress bar is going. i don't know what the fix is for this. i have a feeling that this can help me get back my lost 8gb internal SD if i would have been able to flash it successfully on my ideos7.
has anybody tried this already, would be happy to know.

Blinkers
Do not use battery. Use only power connector. First press back and power on and after a few sec leave power button. You should see a white bar. Leave Back button and disconnect charger. Keep stock firmware in external sdcard formatted to FAT32 under dload and make sure you have only unlmt.cfg and along with UPDATA.APP and upg.
Reconnect charger and press power on. If the flashing does not start try again. Fast blinking happened to me, say after 5 bars or may be 6. After rooting device I tried some mod and ended up in a mess. Had to start all over again. But it started and went thru properly after two tries.

After trying this a few times, My S7 keeps rebooting. not stable, need to find another Rom..
---------- Post added at 05:34 PM ---------- Previous post was at 05:15 PM ----------
Link to new berlarus rom S7 slim.
Gonna flash and see now.
http://www.mediafire.com/?r98ck9f0l2d46x2

Nish4 said:
After trying this a few times, My S7 keeps rebooting. not stable, need to find another Rom..
---------- Post added at 05:34 PM ---------- Previous post was at 05:15 PM ----------
Link to new berlarus rom S7 slim.
Gonna flash and see now.
http://www.mediafire.com/?r98ck9f0l2d46x2
Click to expand...
Click to collapse
So have u try dis,stable or what ?? result ??

LGG2 bricked on fastboot mode.

Hello I tried to flash dorimanx 11.2 kernel onto lgg2 with cloudy g2 2.2. It is the T-mobile LGG2 so D801.
I tried to flash using twrp. it said flash was successful. The screen came up with
[900] Fastboot mode started.
when I plug the phone into my computer it says
--reset--
--postchaerge--
When I go to devices on my computer it has under unspecified "Android" and it says there are no drivers installed for it, though lg g2 drivers are on my computer and I've been using them lately.
My phone does not stay off. It automatically boots to LG logo then to fastboot mode
If I hold down power and volume. It goes to LG screen and stays there for 5-10 seconds then the screen goes blank and the red LED indicator starts flashing. It seems to keep doing this until I release the power and volume down and then it goes to LG to fast boot.
If I reboot the phone by holding power+vol down and when the LG logo appears release both and then press them again it goes to factory data reset screen.
Thanks for any help, KipKipK

Okay, I waited overnight and no replies. Has no one seen this before. Is this phone dead. I will be sitting at my computer for the next few hours if someone would help walk me through something
*** update
tried to get into download mode this morning. power + vol up plugged into PC
IT WORKED! However it only had the download screen up for a few seconds when it changed to firmware update.
Going from the top of the screen down it says.
1 firmware update.
2 then has a connection symbol with rotating circles around it
3 it says DO not unplug the USB connection until the process is complete.
4 Then a progress bar at 0% that isn't moving
5 Lastly it has a panel that says USER B100 and a few lines down ROOTED
Under devices it is now detected as LG AndroidNet Phone
Under device manager it says under ports. LGE AndroidNet USB Serial Port (COM14)

you Are OK my friend don't worry ... now you should flash the original firmware for your phone ... read here carfully and you should be just fine
http://forum.xda-developers.com/showthread.php?t=2432476&highlight=can+i+use+kdz+files
there is 2 ways to flash the firmware
the best way is the tot file way its faster and always work fine
Good luck . don't worry
---------- Post added at 01:08 PM ---------- Previous post was at 01:02 PM ----------
your download mode is fine don't misss there just power of your phone and charge it
read the post carfully
download all what you need and last step connect the cable and go to download screen to flash
if the process didn't start at the bigenning remove the usb cable and insert it again while in download mode and after you click the flash button.
---------- Post added at 01:13 PM ---------- Previous post was at 01:08 PM ----------
http://forum.xda-developers.com/showthread.php?t=2797190
https://www.youtube.com/watch?v=4X_ovKnu-FA
https://www.youtube.com/watch?v=hVLd-HlqveE
https://www.youtube.com/watch?v=wJtcPNklrfw
---------- Post added at 01:16 PM ---------- Previous post was at 01:13 PM ----------
you can also try to go to TWRP again first (before flashing original firmware)
http://forum.xda-developers.com/showthread.php?t=2534981

Awesome. I'll follow that guide + what you said to do and inform you how it goes.
*** THANK YOU! phone is revived. Time to start the process over again and figure out where I went wrong.

I have no idea how this happened since i just did this yesterday and it worked perfectly but i'm in a boot loop now.
1. I got stock
2. updated to 5.0.2
3. rooted
4. installed auto rec
5. rebooted
6 flashed twrp .
7 restarted. and now i'm in a boot loop.
The only thing the phone does is repeatedly go to lg logo. No LED light on.
I can get to factory reset screen.
It doesn't seem like I can get to download mode. I am trying by holding power button until phone goes and stays black. Then I press up vol button and plug into usb, but it just goes to LG boot loop again.
***Okay. NOW I ****ED UP. turned the phone off again to try and get it into download mode. Now the screen is black and it won't even go to LG screen.
So, It looks like I probably want to try and do the factory reset, which will get me to twrp, if I can get back to the factory reset screen but now the phone is just stuck off. (no blacklight on)
***Because the phone wouldn't turn on I decided to try to remove the battery. Somewhere in the process of removing the back cover the phone decided to start the boot loop again.
- I used this to get to factory reset, which got me to twrp.
- What do I do now? I found some posts that sound similar to what I want but really don't want to mess anything up so i'm just going to wait for a reply
- long term goal is to get cloudy g2 2.2 and dorimanx.

Since I didn't get a reply I just kind of said eff it and flashed the cloud g2 2.2 rom and the KK baseband. Device is now functioning. Time to decide if it is worth getting the kernel

what is the situation now is your phone go to twrp or not what is the situation here .
---------- Post added at 09:26 AM ---------- Previous post was at 09:23 AM ----------
if your phone can go to download mode just flash the original firmware . and tell me what kind of original firmware is it KITKAT or JELLYBEAN and don't upgrade to 5 LP
---------- Post added at 09:34 AM ---------- Previous post was at 09:26 AM ----------
and don't do anything
just you can download your phone twrp model exact model from here
http://www.gregtwallace.com/lgg2-projects/twrp/?version=2.8.7.3
and don't use twrp 3 aor up
we just need TWRP 2.8.7.3 this the best one till now ... i am using it

Please Help ... My Moto G4 PLUS Is Dead :( I m Dead Too Please Help..

Hey there is a problem.. while updating the stock... from updates it was updating and suddenly it went totally black.. its not turning on .. only when i put to charge or connect to PC only that notification lights blinks continuously .. and my volume down button is not working. so i cant see that i can go to boot loader .. so is there any way to get it done???? and i didn't turn on the debug mode on also...  please let me know if there is any way to turn on the device... and please let me know why the led lights blinking which is besides finger print sensor.. and also when i connect to PC sounds comes which says its connected.. and when i disconnect sounds comes of disconnection.. and if i hold the power key sounds come of disconnection and connecting ... and while connected to MOTO G4 PLUS i can see in device manger as in other device QHSUB_BULK & Unknown device ... help

There is a guide in the "guides section" for hard bricks
Sent from my Moto G4 using Tapatalk
---------- Post added at 10:46 PM ---------- Previous post was at 10:45 PM ----------
Try this https://r.tapatalk.com/shareLink?ur...share_tid=3657761&share_fid=3793&share_type=t
Sent from my Moto G4 using Tapatalk

Same here after reboot in recovery from stock sept + xposed nougat
---------- Post added at 04:18 PM ---------- Previous post was at 03:41 PM ----------
ccalixtro said:
Same here after reboot in recovery from stock sept + xposed nougat
Click to expand...
Click to collapse
Forget it, already fixed ir with that guide.

Im currently running Xposed Nougat on my phone, I am using Magisk's systemless version though, with ElementalX Kernel. I recommend experimenting with your phone a bit, try flashing elemental X then Xposed. Might work

There is an unbrick guide.. Use it! the bootloader got updated with the patch, therefore, if u downgrade bootloader and update it again, the phone will brick... Use it to unbrick and flash the latest stock!

Sharp AQUOS R firmware needed(or reset)

Greetings i have a sharp aquos R(605sh) that has gone in bootloop and doesnt start because of a software issue(systemui keeps stopping on bootup) so if anyone has a firmware or knows a way to reset this please guide.

anyone?? UP

No way without getting it started
You can't reset it with button dont get into recovery mode neither into download mode this phone suvk no rom no root no development at all

Maybe this can help k-tai*sharp*co*jp/support/developers/oss/shv39/index.html

UP
---------- Post added at 12:06 PM ---------- Previous post was at 11:58 AM ----------
https://k-tai.sharp.co.jp/support/developers/oss/aquos-r/index.html
This is for 605SH ... I still don't know how to flash these