Last night I put to charge my XT1563 with its motorola charger it dispolayed the message Turbo Charging as always. This morning phone was dead, no signs of charging or recharging whatsoever. After a while of having it connected to a "normal" charger it started again to charge, but hooking it up with turbo charger does nothing, I mean it simply ignores the fact that there is a cable hooked up. I have also noted that my computer no longer sees the phone, whereas before it always detected it and asked what to do with it.
Anybody has had the same problem? My guess is that the battery needs replacing as when I use my motorola charger on my wife phone it pops again the message "turbo charging"...
Any help is appreciated.
Raul
zzappe said:
Last night I put to charge my XT1563 with its motorola charger it dispolayed the message Turbo Charging as always. This morning phone was dead, no signs of charging or recharging whatsoever. After a while of having it connected to a "normal" charger it started again to charge, but hooking it up with turbo charger does nothing, I mean it simply ignores the fact that there is a cable hooked up. I have also noted that my computer no longer sees the phone, whereas before it always detected it and asked what to do with it.
Anybody has had the same problem? My guess is that the battery needs replacing as when I use my motorola charger on my wife phone it pops again the message "turbo charging"...
Any help is appreciated.
Raul
Click to expand...
Click to collapse
Switch your phone off at night and check your battery level the next morning. If the battery can keep his charge no replacement is needed and a factory reset could do the trick.
It does keep the battery level and already did 2 FR - still no turbo charge ,not recognized by PC.
Looking around for FL40 for a battery replacement but cant find one available .....
Personally, I think that a battery that doesn't charge on a certain charger, but can hold a charge once it is charged is not the principal suspect. Check the connector, the cable, the software, etc before replacing the battery.
-Justin
Related
My battery went flat and I can't find my mains charger, so I connected it to my laptop using the usb cable, with the intention of recharging it. But it doesn't seem to be charging and I can't turn it on at all. Is that normal? Will it only recharge from a mains charger when the battery's dead? Finally, is it safe to by any odd charger off ebay etc.?
I do not know if that is normal or not. However with regards to charging, I have used a Motorola charger with USB connection successfully in the car and from the mains.
If it is all the way dead, you have to charge with original charger. USB charge will not work. Nor will a Motorola charger work. I think that as long as the charger is 5volts, you should be okay. My Motorola charger is like 3v or something.
Thanks
I had the same problem. It does not charge in the beginning, however, if you leave it connected to USB, it will start charging in an hour or so. damn long, but it's better than nothing...
Tried to keep it connected via usb for a few hours, no luck, guess I'll just have to wait till I've bought another mains charger. There seem to be plenty of cheaper ones on ebay etc., is it safe to buy any usb charger?
This happened to me, and I nearly had a heart-attack until I came to these forums for a solution. Apparently, the phone has to be on for the charger (mains or usb) to actually charge the phone. This is because the operating system of the phone controls the charging of the phone. If the battery is completely dead, the operating system cannot control the charging, and so no matter what kind of charger you use, and no matter how long you leave it plugged in, you won't be able to charge the battery.
The only way to get it to work is to get a bit of charge into the battery directly - not through the phone. In other words, you need to jump start the battery (almost like you would jump start a car's battery). What I did was take the battery to a phone repair shop, and asked them to boost the battery using boosting equipment. Their battery testing equipment will be able to tell you when there's sufficient charge to get it going. Then turn on the phone and plug in the charger immediately once it's booted up (in other words, when the operating system can kick in and start controlling the charging process).
Hope this helps.
PS, there's a post on this forum somewhere on how to do-it-yourself, but in the long run, I found my way to be the easier way.
PPS. Once your phone is back up and running, never let the battery run down completely.
Same happens to Motorola V3.
It is ridiculous design flaw.
This is really annoying, I was hoping to sort this out with a new charger (in the post now) but looks like I'm going to have to go to a t-mobile shop. Will they definitely have something to charge the battery a bit, or should I start looking into buying something to charge the battery at home?
Yes you need the main charger.
I was using my other phones charger(motorola) with my cingular 8125 and battery is completly empty it doesn't charge it.
Didn't wait for a hour but if that works.It's good i love my wizard
motorola V3 chargers do work. used the missus' when battery ws completely dead. interestingly, doesnt work the other way around...... :?:
help with my dead battery
Bdcol
Could you direct me to that post on how to charge a dead battery - I have searched but can't find it. This is a really annoying problem - does anyone know of a commercially available battery charger which doesn't need the phone OS (the battery looks pretty standard to me).
Many thanks
Chris
Hi,
My wizard main battery (wiza16) was very low and the wizard stop with a message “The internal battery is very low”. After coming back home I have tried to charge but it is not taking charge and didn’t turn on anymore. I recently bought a new battery (wiza16, 3.7 VDC, 1250 mAH) thinking that it will work again but still the same problem, wizard is not taking charge or turn on.
Can anyone help me?? What can I do to start my wizard? Do I need to change the tiny little battery (which is inside the wizard)? Kindly help me.
Wizard service manual
Hi,
See if when you connect the power plug the led turns red, if yes....
If Charge light is red when plug in AC adapter, it means the main battery is not charge enough and can’t power on,
You just need to continue charge unit the light become Amber
If not, i think you have a problem.
Check if charger its working and if its pluged.
If it helps --- ftp://ftp.xda-developers.com/Wizard/Docs_Tutorials/Wizard_Service_Manual.pdf
Wizard Battery discharge completely
Hi,
Thanks for quick reply. there is no light when i connect my wizard with PC. I don't have the AC charger, I have lost that for long and was using my PC usb to charge. trying to get one AC charger.
There was no problem with my wizard, just can't turn on after it's battery discharge completely. Even the new battery couldn't turn that on.
You'll need the original charger if the battery has complelty discharged as it will only charge from the computer if the phone is powered on.
This happened to me before.
There is a trick to giving the battery a quick charge which will give it enough juice to boot the phone up and allow it to charge from usb. its not recommended but works.
You will need a spare usb cable, cut one end of, strip the wires back and connect the red wire to + and the black to - on the battery, only do it for a short period, about 30 seconds while conneted to your computer.
You may need to give it a few 30 second bursts to give it enough juice.
Pop the battery back into the phone and switch it on while pugged into the PC
Took me a few attempts to get enough charge in the battery for it to boot up.
Wizard battery
You can also use a 9V battery to jumpstart your battery. But then you have to be more careful. I connected the 9v battery to my Wizard battery for about 15 seconds, then tried to start up my device. If not successful I started again with 15 seconds jumpstart..
But you can find more information here in the forum: just search for jumpstart or something similar....
Regards
huibuh_!
Wizard Battery discharge completely
Thank you all for information. 9V battery method didn't work for me. Looking for AC charger online and get a link (http://www2.dustin.se/pd_5010073700.aspx). Do you think this is the right one? If yes, then I can order.
yea that's the right one but if you have a friend with a ppc or maybe a razor you can use there charger most ac adapters are starting to use mini usb just a way of saving some money even though having an ac adapter is good
could also try and get one of those usb plugs that you can plug up to a wall and plug in a usb cable into the slot
but don't take my word for this wit hmy wizard i haven't had it shut all the way day
if anybody can verify this would work
AC charger not also working
I have got the AC charger yesterday. When Connect the Ac charger first time the red light on my wizard showed for just half second then dissappear. Still let that connected for whole night but no response.
Thank you all for help.
@Keland44, most Razr chargers dont work, they MUST be at least 850mA in order for the Wizard's battery to receive anything. The older Razr chargers are sometimes as low as 350mA, but the never ones are as high as 1.2A, so you need to read the label on the charger itself to be sure.
ashasaur said:
@Keland44, most Razr chargers dont work, they MUST be at least 850mA in order for the Wizard's battery to receive anything. The older Razr chargers are sometimes as low as 350mA, but the never ones are as high as 1.2A, so you need to read the label on the charger itself to be sure.
Click to expand...
Click to collapse
Yup that is about right,
If the battery is complelty dead, then you need to original charger.
If you have got the right charger and you get a red light and it goes off. your phone might have a problem.
This happened to my last wizard after stupidly trying to dry out the screen after getting it wet which stopped the touchscreen working (i was drying it out while the phone was still on) well my wizard crashed.
Took ages to get it back on but it was very unreliable then one day, it wouldnt go on and charger done nothing. Unpluging and pluging the charger in several times got a red light on.
Sometimes i could get it to turn on, the charger would charge for about 5 minutes then the phone would die soon after.
Your phone might possibly be bricked.
Help :
I Have Same Problem with my wizard
Yesterday my wizard goes died, i think the battery out
when i came home, i use AC Charger for HTC Universal, for 1st time its red light then off,
after 15 minutes orange light, i try to turn on my wizard and works but only in boot loader 5 minutes again its going off again
until now my wizard wont turn on
some body help
OK, first I admit, the battery is a POS. I usually have enough battery life to make it through a full day, but usually it will die in the evening before I go to bed and put it on charge.
Recently I got a message, "Charging current is not enough for device power consumption. Please connect your AC adapter." Strange thing, though, it WAS connected to my AC charger. I get the same message with both of my chargers.
Battery will not charge, but has just enough power to keep the phone running as long as there is charge already in the battery. So the battery is almost dead, I put it on the charger all night long, get up in the morning and take it off, and then it beeps extra low battery! and then dies shortly after.
The only way I can get it to work is to leave the phone powered off for a long period of time and charge it then. Doesn't always work though. works if I take out the battery and charge it all by itself on a USB phone battery charger.
Sounds like the problem is somewhere in the phone, not with the chargers. Why would both of them do the same thing?
Please help.
does it do the same thing when plugged in and charging via USB??
could be a bad battery...
from old phones i had previous to my magic it sometimes helped to clean the contacts on the battery and charging pins on the phone..
I'll check that...
BTW, if I am plugged into an AC adapter, is it supposed to stay on even if I remove the battery?
NOPE! same message. Been charging all day now and only shows just over half charge on the battery. Most of this is from the hour or so that I had the battery out and charging on its own.
I left my phone charging overnight via the wall charger. Battery registered at 1% when I started the charge.
When I woke up this morning I had a large low battery icon on the screen and the phone won't turn on. I disconnected the charge, tried charging with another charger but everytime it shows the SAMSUNG logo, then the large low battery icon.
I tried removing the battery, cleaning the charger port terminals, swapped out different USB cords, everything but a hard reset.
No matter what I do the phone will not start up.
Has anyone experienced this before, or possibly no how to resolve it?
mfarlow said:
I left my phone charging overnight via the wall charger. Battery registered at 1% when I started the charge.
When I woke up this morning I had a large low battery icon on the screen and the phone won't turn on. I disconnected the charge, tried charging with another charger but everytime it shows the SAMSUNG logo, then the large low battery icon.
I tried removing the battery, cleaning the charger port terminals, swapped out different USB cords, everything but a hard reset.
No matter what I do the phone will not start up.
Has anyone experienced this before, or possibly no how to resolve it?
Click to expand...
Click to collapse
Happened to me several times (on both my focuses Rogers and AT&T), and I came to the conclusion it's a bug somewhere in the phone or the battery. I'm not sure exactly where the problem is (software, hardware) but I can tell you how I fixed it.
What happens is, the battery is almost depleted, it actually is 1%. The phone incorrectly reads that thinks it's charged fully and doesn't allow further charging the battery. So, you're not able to charge the battery correctly.
Now, as I previously stated in some other posts, I recommend having a standalone charger (Samsung i9000 ones are compatible are very cheap) as well as a secondary battery. The depleted battery gets charged fine in the standalone charger and when it passes 5% charge, it can be charged fine (again) in the phone.
This doesn't happen often, I believe it happened 5 times in more than 300 charging cycles (2 phones x 150 charges, I have them for over a year) so it's not that common.
I also found that it *may* work if you charge the battery in another phone.
As a general thumb rule, it's important not to leave the battery to completely discharge, and connect the charger/usb when it reaches about 40% (when you can, ofc). Please refer to my post here to see how you can preserve battery life.
Last night I charged my phone with the standard charging cable and the phone said it was charging. This morning I woke up and it had not charged at all. It still says it is charging but no power is going to the device. Any thoughts on how to fix this? Thanks!
Edit: Wireless charging is also not working.
I would try to charge the phone with another micro-usb cable without changing the stock 1.8Amps charger. It's very common for those cables to get damaged after some time of usage and not deliver enough current for the phone to charge.
That did not seem to do anything. The fact that wireless charging also isn't working has me worried.