Hi,
my mobile shutdown when placet to magnetic car holder (neodymium magnet). but only in certain place (in picture...) and not always.
does anyone have a same problem?
thanks
Mine is ok, but I have an Wiko Hightway with that problem.... since I know there are a lote of smartphones with this problem
Related
http://www.pdamods.com/products.asp?cat=23
Has anyone ordered this and tried it on a Vodaphone VPA ? Does it work ?
Thanks in advance
Got one in my car, works a treat for holding and charging it. The cradle's also got a telephone-socket-like port for a Serial GPS, but I use bluetooth so I've never used it.
Hi
Yes but which PDA do you have ? Is it a Vodqphone VPA ?
You posted in the "Himalaya & Andes" section, I'm using it with an XDA II.
Take a look at Brodit mounts on www.handnav.co.uk , you buy the type of holder you want for your PDA (powered/basic etc..) then buy a clip designed specifically for your make/model of car.
Each one is designed specifically for each car and just clips on to dash trim without screws etc..
Top notch kit
The one posted above uses a suction mount on the windscreen, been on for almost 2 months now and it's not fallen off once.
Ok, apparently it doe snot work with the Vodafone VPa, bu they have sent me one for this model and that works fine
check out a device called a berry from a company called SPcomms
Works with the XDAIIi and other models. really funky toy
I have had installed in my car a rather nice tbh bury car kit , nice in that you can swap cradles for different phones thus the kit never becomes obselete.
i got a cradle for my hermes but it does not route anything through the kits external speaker making it an expensive charging cradle , i noticed that other htc handsets have software patches to make them work with these cradles but thus far thb have offere no answer to my problem , anyone else have this or a similar kit and found an issue?
Hi,
I found this on another forum
http://www.expansys.co.nz/ft.aspx?i=117490&thread=34
the guy had the same problem, no sound from the hands free kit, turned out to be a faulty cradle
Malcolm
look in their support site, there's a wave.dll or something similar to resolve this issue. It's specific for the tytn:
MDA III - Important information:
If you wish to hear audio response over car speakers, you have to replace file "Wavedev.dll" on your MDA III. Please reset system after replacing. Manual D
check here http://www.bury.com/technologies/GB/hands-free/47/UNI_Take&Talk/HTC/
bottom of the page
did you ever resolve this problem? I use thb kit and eventually got mine working.
Hi, I'm thinking on buying ORA Car Pack
http://www.mobileplanet.com/p.aspx?i=153768&asource=151727
They sell it for 27 dollars. Does anyone own this? Can someone give me a recommendation? I want to buy a cheap carkit for my kaiser, with 12v power included. I want to have it glue to my car dashboard or to my windshield with a vent mount.
Thanks in advanced
In the past I also bought car kits made for that specific PDA I owned by that time. The problem though is that - during your "PDA-life" - you spend a fortune on this so I decided to go for some "general" system like Brodit or Richter (see http://www.mobileplanet.com/p.aspx?i=156824). The advantage with this system is that you only have to replace the actual PDA holder rather than the complete system when you get a new tech toy - which is also less expensive.
I'm very happy with the Richter system now since quite a number of years.
Christian
Well interesting point of view but the ORA car park system, seems to be a universal type of holder and would as such suit their owners in case of pdas change
I'm curious about return of experiences too.
About that ORA system, but also about the Arkon CM799 http://www.mobileplanet.com/p.aspx?i=147464
which would seem to suit the TyTN II too.
As I'm thinking of having the Kaiser into some kind of hard plastic or rubber protector case, I think it's best I stay away from specific to the TyTN II car kit since the phone would be to thick to hold in the especially designed systems.
One question for you Eurybia though : does the adapter you got for the Richter system allows to have the ability to have the Kaiser keypad opened or closed at will ?
Thanks !
I dont like Arkon product. I bought an active charger before, but after not more than 5 months, the "spring" to hold the PDA was loosen (not tight anymore).
Derek Smalls said:
One question for you Eurybia though : does the adapter you got for the Richter system allows to have the ability to have the Kaiser keypad opened or closed at will ?
Thanks !
Click to expand...
Click to collapse
Nope.
And even when I think about this feature now I wouldn't miss that anyway. In times of bluetooth, voice dialing and more or less mainly GPS usage in the car I wouldn't use the keyboard while driving anyway. For me the most important thing is that the unit is fixed properly in the holder so it won't drop between the seats or alike even on rough roads.
My eyes are too bad and my fingers too big to play distant-mice-piano anyway.
Anyway, nor the arkon active holder nor the brodit (or Richter ) active holder costs 27 dollars. So I asked again to see if anyone owns one of this or if someon can recomend an active holder carkit for more or less the same price.
anybody can suggest/recommed any car holder which are easily installed..I mean whenever I need to put the kaiser in any car that can be done so easily? are there such solutions available or custom made?
You're looking for one of the "Windsheild/Suction Cup" mounts. Just about any website that sells cases etc for the Kaiser will also have one or more of these.
Hi folks!!
I need help to fix this problem I have with the mini GPS, The Mini don't recieve any signal from the satelites , I use NaviComputer and GoogleMaps with the Mini's GPS, two days ago it worked perfectly.
by the way i don't move any settings, so I DON'T KNOW what happens
Thank you!
Please Sugestions?
-kOS- said:
Please Sugestions?
Click to expand...
Click to collapse
Hello my friend.
First update quick gps.Test the gps program you have in an outside area.
Then you can use htc gps tool
http://forum.xda-developers.com/showthread.php?t=360477
it works for our mini.
Just try these and tell me if the problem is fixed
Hi nsourm
Well dude, I already do all you told me, but i got the same results.. nothing happens, also i made a Hard Reset, update the GPS data, run the app, still nothing
i attach some screens for you review.
HI Guys!!!
I FIX THE GPS!!!!!!!!!!!, the problem, the antenna cable was loose, I reconnect it again and it Worked 100%
So could you share with us, where the antenna is located?
A photo maybe?
Please take a look to this video -> HTC Aria Disassembly, you will see EXACTLY the same layout in the Mini;
The coaxial cable for the GPS is the blue one, the white one is for the WiFi, the WiFi antenna is located in the top yellow cover of the mini (the one that protects the camera and the speaker), the GPS antenna i believe is located in the same location.
Remember I don't identified it, because my problem was the GPS blue coaxial cable was loose, I only reconect it and solve my problem.
Best Regards
Wow! You have dared to disassemble your phone!
Great that problem is solved.
-kOS- said:
HI Guys!!!
I FIX THE GPS!!!!!!!!!!!, the problem, the antenna cable was loose, I reconnect it again and it Worked 100%
Click to expand...
Click to collapse
Hello, my dear,
I still cannot find the gps antenna...
At the video posted above they don't talk about GPS ANTENNA...
Could you, please, give me a hand? My HTC Mini shown the same problem...my GPS just stopped working.
I'm desperated!
Pleaaaaaaaaaaaase!
HEEEEEEEEEEEEELP!
Thanks in advance
Did you have install Android system ?