Hi, just wondering if anyone has seen an issue like mine. I looked but did not find a thread or problem like what I am having right now. I have an original VS980, I was using TWRP 2.6.3.3 (the newest one) and tried to flash the new CM11 nightly and GAPPS, and it boot looped. I went back into TWRP using the vol down and power buttons, and installed a stock rom. Still boot looped. I restored a backup that I had actually restored and used before, of an earlier CM11 build, and that bootlooped too!!! So I have tried a couple of methods of restoring to stock firmware, and each time I am reaching the same point. The phone boots and the setup wizard starts. I click next, and the little activation window pops up, and just spins until the phone reboots. There is no signal showing during this.
I can get into download mode, and I can do factory resets. But I still can't get my phone activated, so I can't get into the stock ROM, to root or install TWRP again. Any ideas? Hopefully someone can help me by tomorrow, I am without a phone (I'll be fine lol).
Try doing this: http://forum.xda-developers.com/showthread.php?t=2448960
And if/when you get it working, don't use TWRP 3.3, it's all kinds of FUBAR'd at the moment. If you use 3.2 you'll be just fine.
Sent from CAMACHO, my Verizon G2 (VS980) running PAC ROM.
Vepaot said:
Try doing this: http://forum.xda-developers.com/showthread.php?t=2448960
And if/when you get it working, don't use TWRP 3.3, it's all kinds of FUBAR'd at the moment. If you use 3.2 you'll be just fine.
Sent from CAMACHO, my Verizon G2 (VS980) running PAC ROM.
Click to expand...
Click to collapse
Yes, I tried this. When it boots, it just gets stuck at activation.
BUMP NEED HELP!!!
EDIT: More info, so maybe someone can see where I went wrong. I tried the WACOMalt method, and flashed VS98010B_13.tot to my phone. Someone in that thread mentioned that if you are on VS98011A then flashing VS98010B might not work. Then I tried a few times with a different restore method to flash a VS98011A stock image, and came to the same result, boots fine but does not activate and I cannot do anything with the phone.
gotta say twrp 2.6.3.3 is working fine here on d802 uk and has been for the last week or so ive flashed roms,restored from backups and all was fine -providng you've got the latest twrp or cwm youll have no problems
Sounds like you are zeroed. Check status for IMEI, ect. If good, you may need to "reactivate" online. If not, hope you backed up EFS, would be time to restore it. If both the latter fail, flash stock and go to Verizon.
Steamer86 said:
Did you back up your EFS?
Click to expand...
Click to collapse
Unfortunately no.
Edited ^ Our EFS isn't in a separate partition. A bad wipe can and will destroy it. EVERYONE should back this up after root, no matter what you're doing with the phone. And store it in a few places.
Steamer86 said:
Sounds like you are zeroed. Check status for IMEI, ect. If good, you may need to "reactivate" online. If not, hope you backed up EFS, would be time to restore it. If both the latter fail, flash stock and go to Verizon.
Click to expand...
Click to collapse
What do you mean "check status"? If you mean from system settings -> about phone, I cannot even get to that since I am stuck in setup wizard. I am planning on going to Verizon tomorrow, first thing in the morning. I have already flashed stock, so they will not see anything out of the ordinary. I am also bringing my HTC Rezound, in case I need to go back to that. Hopefully they can help me reactivate the G2 though...
There's a key combo to pass that. Go online on your account, switch theline over to the rezound, activate, back to the g2, try and let it go through activation. If it doesn't work, return. Sounds like your EFS is gone though.
Okay, I tried that. I can bypass the setup wizard by pressing vol up, then vol down, then back. I took my sim card out to do this. Under about phone, it shows unknown for emei and all the other settings. But I keep getting an issue, whenever I turn the screen off, it cannot turn back on and I have to reboot it. So, I think my EFS is messed up, but I have restored stock. I can get into the rom and look at about phone settings. But I am having issues with the screen turning off and not turning back on. And when that happens the phone reboots itself after a while.
I don't have my Rezound sim card on me right now to try activating it. I will just find it tonight and take everything to Verizon tomorrow. I'm sure they will help me out of this jam. Thanks for your help dude!
You are zeroed regardless, as you suspected, nothing to do but return. Back up that EFS next time! If you are stock, you'll be fine and get a "new" refurb. Someone will get your nice refurb when it's repaired. You're good.
This is almost embarrassing to post, but I need some help...
I have the T-Mobile G2, btw, which was rooted and with TWRP 2.6.3.3
So I was installing an AOSP ROM, and like a dumbass, instead of installing gapps like I meant to do, I accidentally flashed Smikey's KitKat ROM on top of Cyanfox. I realized it too late to stop it, and once the flash finished, I did a wipe of everything but internal storage and tried to restore a backup of CloudyStock. When I rebooted it goes to the LG screen with a secure boot error, and then a black screen where you can still see the backlight if you tilt the phone.
I tried using the LG Mobile Support tool to go back to stock, (It will go into download mode), but I can't get it to push any of the three stock images to the phone.
Holding down and power to do a hardware reset doesn't work either.
Help!!!
I picked up a cheap Tmobile prepaid to use until I get this figured out, but I want my G2 back! Does anyone have any advice at all, or did I brick my phone beyond repair?
I forgot to mention, I'm not sure if it's the phone or the drivers aren't properly installed on my computer, but LG Mobile support tool is reading my phone as a V500...
http://forum.xda-developers.com/showthread.php?t=2010624
Anyone know if this method for unbricking the Optimus G will work?
Alright, my friend has a Verizon LG G2 and i helped him install Malladus 2.0.1. He was previously on Malladus v1.2.5, and he followed this guide here: https://docs.google.com/document/d/1xsU9W656TA-Lw1LAlL7hqROf2QjiOI2puyDU-DDP41Q/edit and everything went okay. When he tried to restore his apps via Titanium Backup by trying to restore the apps from the nandroid, the apps didn't show up. In the guide, it said if you need to go back to android 4.2.2, you need to flash the 12B radio, so he flashed the 12B radio and restored his backup of Malladus 1.2.5. After rebooting into system, he got stuck in a boot loop, so he tried to get back into recovery, but wasn't able to because it wouldn't turn off. Also, he could not get adb access and now his device doesn't respond at all when clicking any buttons or plugging it into the charger/computer. Any ideas?
edit: charger doesn't charge the device
bump
Has he tried removing the battery?
Infinite Jest said:
Has he tried removing the battery?
Click to expand...
Click to collapse
Unfortunately, you can't remove the battery on the lg g2, but he left the phone plugged in over night and he is now able to get into download mode
edit:he got into recovery, so i think we're good now
I'm really stuck and I hope someone out there might be able to help me out (or at least stimulate my brain to try and figure out what I did!)
I was looking to return my G2 back to T-Mobile (D801). Since i rooted it and installed a custom recovery, I know I needed to wipe it and return the phone back to stock. On my first pass of performing a factory reset, the phone will no longer boot past the LG screen. I didn't have a back up on the phone since I hadn't prepared for that step at the moment I was clearing the data from it (stupid of me, I know).
I've tried to sideload a rom through ADB just to get it to boot, but none of the ADB commands seem to be recognized. I don't even care about getting the phone back into working condition, I just need the phone to go back to stock recovery so it doesn't show as rooted (so T-Mobile will accept it).
Does anyone has any suggestions on how to accomplish this? I really need to figure something out since the clock is ticking to return it before I get penalized. Any help is welcome and appreciated!
Thanks.
One of my friends was having me try to fix or at least recover data from her Verizon G2- it's been stuck on the LG screen for about a week, can still go to recovery/download/other basic screens but that's it, all she did was put it in her pocket and it stopped working. Unfortunately I'm REALLY new to anything Android (please forgive me if I'm using terminology incorrectly!) so I've been lost trying to work this out.
I found out today that she went ahead and got a new phone altogether but she asked me to pull the data from this one. Before this I've tried using LGFlashTool to reset the phone without removing the data, but every way I've gone about doing that has told me that "there was an error connecting to the device" or something along those lines, same in Alligator Toolkit 3.1 and even Windows Device Manager.
At this point I just need to get the data from it, but it's not rooted so I can't install TWRP (not sure about any alternative recoveries), and I can't root it because it hasn't been able to get past the aforementioned screens.
Is there a way to basically just copy all the data on the phone to a computer without a recovery, rooting it, or anything like that? Or is there any way I can install a recovery like TWRP?
Another thing is that strangely last night I managed to make it turn on and work properly, but when I finally decided that it did work and went to unplug it and put it away, it went straight back to the LG screen. I'm not really sure what I did to get it to work that time but I haven't been able to make it happen again.
Sorry if any of this is unclear, I'll be up late available for any clarifications. Thanks in advance for the help!