here is the working modem for N7100 IMEI recovery..
Use Odin 1.85,
open odin add the modem file on PHONE and start...done!!!
Related
Hi all,
I'm trying to flash the modem from the Bell variant of the N900W8 on my N9005 but Odin reports failure and my phone says "Secure Check Fail : modem".
I'm able to flash the existing modem without issue. Any ideas?
Edit: hmm sounds like I should flash the NON-HLOS.bin file first?
Edit 2: Flashing the NON-HLOS.bin file first didn't work either...
edit:
I finally managed now to flash DBT NB4 with PIT..
Hello guys,
I have some problems with my N9005.
First problem:
I tried to update my bootloader, also modem witn Odin 3.09
BL: NA6
Modem: NA2
Tried to update bootloader to ND5, also tried modem to NC2. I used key combo to get into download mode.
Auto Reboot and F Reset Time ticked, nothing else. Tried one by one, first BL with BL tab, modem with CP tab
Nothing changed after reboot... still NA6 and NA2
I also used mobile odin, skips modem cuz of write protection. This also is readable in download mode.
Second problem:
After every reboot (normal, recovery, etc.) the time is reset, you have to config manually or let it grab frome time-servers.
Annoying...
Can anyone help me?
Can anyone help me?
I tried to flash N9005XXUENB7_N9005DBTENB2_N9005XXUENB1_HOME.tar.md5 with PDA tab now, with hidden.img it stopped with FAIL (size)
So I used the pit file for DBT and tried again, still FAIL! (Size)
Note 3 now starts only to download mode with firmware upgrade error warning...
edit:
I finally managed now to flash DBT NB4 with PIT..
Sometimes pit file is needed for certain firmware.
http://forum.xda-developers.com/showthread.php?t=2643109
When updating bootloader and modem, u have to shutdown phone completely before the 3 combos. And do it one by one at the correct tab.
Sent from somewhere under the sky, at the corner of this rounded earth.
I was trying To install twrp But Odin sayed 'no Pit partition ' And on The Phone there is The screen 'firmware upgradw encountered An issue . Please select recovery mode in kies. I tried To install Pit file with stock firmware But is The Same. (May i didnt checked debug usb)
Flash a full stock ROM in odin
No Pit partition. And when i flash rom + Pit give me The Same error
HI, NEED HELP !
My Phone doesn't see my sim card and IMEI number. *#06# not working because my phone doesn't see my sim card.
I can't flash BL via odin. Just AP, CP, CSC...
Problem is "BL" I tried AP,CP,CSC without BL its work but sim card and IMEI not working...
Odin fail :
get pit for mapping
cm.bin
FAIL...!
EDIT: Phone is bootloop, KERNEL SW check fail device 2 binary 1 error...
How can I fix this?
go to service center
( Official Firmware )
I Have a J3 SM-J320A and I want to install the Canada Firmware SM-J320W8. If I try to flash the ROM with ODIN appears a bootloader error on the phone and fails to flash sboot.bin.
Is there a way for install the firmware or make .tar file without the bootloader?
I made a .tar file just with system.img file and another file without sboot.bin for try to flash it with odin but when I press start ODIN closes by itself.
Both models have the same chipset and supports the same frequency networks.