Database Users

Speaker not working

hi guys..
I was watching a video clip and suddenly I see I can't hear any audio from it. I was surprised.. I tried to soft reset it couple of times... but with no luck... I couldn't here any tap sound or even when the phone rings.. nothing sounds.. and finally I did hard reset... but in despair.. still the same problem. but when I try to shake my jam. I could feel something moving.. i don't know if any bit/piece is disconnected.. when i try to tap it hard at the speaker.. i could hear to the music and after few seconds.. its stops.. again..
Has anyone come across such a problem.. I think probably my speaker needs to replaced.. any suggestions or solutions to this..
I would await for ur replies.
kindly advise..
thanks
Iffu

i have the same problem to. Please Help!

This is a "common" problem with the Magician. Mine had it as well. I sent it for repair since it's still under warranty. Some ppl had the guts to open it and fix the loose contact themselves. So if you're not a techie just take it to your service centre for repair :-(

No sound?
Hi. i had a similar problem some days ago. no sound at all from my magician. i've discovered that the problem was that my magician thought i had headphones conected. a simple insert of a headphone jack and removal brought my sound back to live. No problems since than.

Just a gentle few bangs did the trick
After reading several suggestions and info about the speaker problem, I tested my 02 mini with a song. It played ok through the speaker. So the speaker works, but appears to not "Switch" on when being used as a phone. Anyway long story short - I hit the corner of it into the palm of my hand a few times and da da it works again. I also blew through the speaker hole. Someone mentioned that somewhere as well. Hitting into my hand seemed to provide enough impact without creating any damage.

Had same problem too, and sent it away for repair. Three weeks later and the repair company are sending me a replacement this week as apparently they were unable to fix it!
Fault appeared without any warning and I had been using the phone pretty heavily all day. All I hope is that the replacement will have a newer ROM installed to save my ineptness from screwing up an upgrade.

This Jam is a peice of shi#e. I bought one in February, had various problems with both speakers - regular earpiece was unclear and speaker phone was just too damn low in volume.
Some people claimed this was an exception, or that it was the ROM or whatever. Right......
Finally sent the Jam back for warranty repair in May- there were many other defects with the phone that accumulated. I had bought insurance as well so I told them to just replace it. The seller admitted that this (audio/speaker is a common problem in this phone)
I just got the insurance replacement today - yep ages later. This one has firmware 1.11 WWE.
Guess what: the speakerphone on this one (brand new replacement) doesn't work - at all. Not at all. This is brand new, out of thebox. Incredible....
What is worse is that I am going on a month-long trip in a couple of days, so there is no way I can get another one - and by the looks of it, even if I got a replacement, the chances are that it too is a piece of ****#e without a functional speakerphone. This I-mate Jam (or whatever the 50 name sit goes by) is just a low quality piece of garbage.
HTC/I-Mate is garbage company. There is no chance in hell I will be buying any future Jam or I-mate phone.

Qtek 9100 - Mic & speaker dead, for the 2nd time

Hello all!
First, thanks for an awesome forum! It has both helped me tweak my Wizard, and also get help when I have needed it.
Well, I have no choice now but to ask here. Last autumn, my warranty was almost up, and a wierd problem presented itself. The mic and speaker suddenly just stopped working! The sidespeakers still work, I think, because the phone rings when someone calls me. But the caller can't hear me, and I can't hear the caller. And there isn't a hint of sound in it, no static or noise, there simply is nothing.
As there were only a few days before the 2 year warranty was up, I ran to my dealer and turned it in. A few weeks later, the phone returned, working again. But now that I come to think about it, I don't remember if I got a replacement or if they actually repaired it... It looked a little like they handled it rough though, maybe it was another phone... Well, that's not important right now.
The same thing has happened again! Summary:
1. Mic & phonespeaker dead
2. Stereo speakers work under certain conditions
3. Wired headset that came with the phone works, both for calling and media
So it seems like a hardware problem. Please note, although I downgraded the phone to original, official Swedish Qtek 9100 ROM, it has been thoroughly tweaked and upgraded to a number of different WM6 ROMs - but all that has been working beatifully!
Still, what are the odds for the mic&speaker dying twice in a row, on different phones (i think the present one is a replacement)?!?
Question: Does anyone recognize this? Is there a possibility that it is software related, and maybe fixable? I have searched both the web and these forums but haven't really found any information on it.
ANY input would be greatly appreciated!
Additional information:
Qtek 9100 (Swedish), G3 model, WM6 upgrade successful (unlocked)
EDIT: There are no system sounds, which is wierd, because the phone can still ring. I thought the system sounds came from the stereo speakers on the sides of the device?

Hello all!
It is a glorious day to be alive!!! Or to have a fully functional Wizard, at least!
Lol - my topic isn't very old, and i reply to it myself with a solution (?). I Googled after the Wizard service manual, and found it right here on Xda .
In all honesty, i didn't do all that much. I just followed the disassembly instructions of the wizard about half-way through, to the point where you get down to the back of the motherboard. I poked and fiddled enough to locate the mic assembly, only to discover that the mic is soldered to the mainboard of the phone. So, i figured i'd just leave it be, because if the mic is really broken the motherboard needs to be repleaced, or a replacement mic needs to be soldered on there.
After removing A LOT of dust in there (honestly, i think the service center that had my device last time wasn't very careful with anything, even a screw was missing! ), i reassembled it. The flat cable running to the keyboard was also a little skewed, but that may have been me, anyway i corrected it too. Same with the speakers.
Long story short, after successfully reassmbling the phone, i fired it up, called my home phone and voila! I works!
Not much of a fix, as i don't really know what i did exactly, but dust, dirt and some bad connections/soldering may have benn the culprit.
All in all, i'm very pleased with my afternoon here. Thanks for stopping by .

epatnor said:
Hello all!
It is a glorious day to be alive!!! Or to have a fully functional Wizard, at least!
Lol - my topic isn't very old, and i reply to it myself with a solution (?). I Googled after the Wizard service manual, and found it right here on Xda .
In all honesty, i didn't do all that much. I just followed the disassembly instructions of the wizard about half-way through, to the point where you get down to the back of the motherboard. I poked and fiddled enough to locate the mic assembly, only to discover that the mic is soldered to the mainboard of the phone. So, i figured i'd just leave it be, because if the mic is really broken the motherboard needs to be repleaced, or a replacement mic needs to be soldered on there.
After removing A LOT of dust in there (honestly, i think the service center that had my device last time wasn't very careful with anything, even a screw was missing! ), i reassembled it. The flat cable running to the keyboard was also a little skewed, but that may have been me, anyway i corrected it too. Same with the speakers.
Long story short, after successfully reassmbling the phone, i fired it up, called my home phone and voila! I works!
Not much of a fix, as i don't really know what i did exactly, but dust, dirt and some bad connections/soldering may have benn the culprit.
All in all, i'm very pleased with my afternoon here. Thanks for stopping by .
Click to expand...
Click to collapse
hi epatnor,
I think the problem with your phone was a stucked microswitch in the 2,5 mm connector for the headset. I read about it here in the forum. Sometimes the switch stays in the closed position and the phone still thinks the headset is connected. Thats why all the sound is sent to the not connected headset and therefor your phone seems to be not working (unless you connect the headset)...
But removing the dust is for sure not a bad thing...
For the next time: I think there was an easier solution for this problem than disassembling your phone...
regards
huibuh_1

Thanks huibuh_1,
Yes this was probably not the smoothest way of "fixing" it. That said, the stucked microswitch theory would actually fit my problem well - I can see now that the exact problem I was having would arise if such a switch was indeed stuck.
However, I think that the problem would be more intermittent since I actually use that port now and then - especially since it's the only way to talk (besides using a bluetooth headset that is). And since I connect the wired headset now and again the switch is used and moved, I suspect that this would result in the speaker/mic coming online again maybe..? Temporarily at least?
All the same, thanks for replying - this might happen again and with your information I'm better prepared for it!

Half of touchscreen not working

Hi guys, just now my mom's X5's right half of the screen stopped responding. Apparently she went to a concert and it started to rain but the phone itself didn't actually contact any water. Point is since it was raining, the air was damp, after that she claimed the right half of the screen stopped responding.
Checked using developer's tool -> show pointer location that it stops detecting touch input EXACTLY at 0 on the x-axis. Any solutions to this other than sending it to the repair center? I've still got another year of warranty on this but preferrably not to send back to warranty as service centres are known to take their own sweet time in repairing phones plus the X5 had already been flashed to a custom firmware.
thanks.

My brother's phone had the same issue and i flash the original firmware and eventually sent it to the warrenty.
After 2 weeks phone returned fixed by a new panel. You should try and see. You won't lose anything.
If you are sure they won't fix then you should by a touchscreen from ebay or somewhere similar.
Sent from my U8800

Recently Water Damaged, now booting - but microphone not working.

Recently my Nexus 6P got some water damage from a canoe trip (even though it was in a water "resistant" pelican case), and was not booting up. Took it to get repaired and the shop cleaned up the corrosion on the bottom of the phone where they said the water damage was. Phone booted up perfectly and everything was working great - wifi, gps, speakers, vibration motor, etc.
A few moments later my wife called me and I answered only to realize that she could not hear anything from my end. The microphone was not working. Took the phone back and they replaced the bottom PCB (daughterboard) of the phone which holds one of the main microphones.
No luck. Now I'm able to use my Nexus 6P for EVERYTHING except making phone calls, which kinda blows. I know I could use bluetooth etc. but that's not really a solution for me.
Does XDA community have any thoughts / ideas about what the problem could be and any possible solutions for me?
Thanks a ton guys!
Nathan

I think your only option is to take it back to the repair shop again.

Shop said that is all they could do for me. The daughterboard is brand new, so if the microphone is still not working, could it be something wrong with the connection to the main board? Would replacing the ribbon cable prove useful?
Thoughts appreciated!
Nathan

Without seeing the device it's very hard to say, but yeah, possibly.

I'm having the similar issue where I went to a foam paarty and got the phone wet. Fortunately everything is working fine except the proximity sensor. Sent phone to Ubreakifix for repair but tjeu couldn't find the part anywhere. Huawei/Google don't provide the replacement part & Huawei don't repair water damaged phone.
If someone could tell me where can I find the Proximity Sensor replacement will be very much appreciated.
Thanks

Help ! Water damage . audio wont work

Hey guys I'm new here. A few weeks ago i happened to not notice that some liquid spilt on my phone while driving and i left it there like that for a while . then When i got a call and answered couldn't hear the other person. Then i noticed water on the fingerprint scanner as i had a spigen case and it had managed to get into my phone. I turned off my phone immediately and disconnected everything. Next morning i happened to removed the board and dry it out as i have done this many times before when i changed the thermal paste. The water damage indicator was red. After ensuring everything had dried out i put it back together and my phone powered back on and it charges well. But when i go to play an audio file. I get an error Sorry, the player does not support this type of audio file. The audio recorder hangs and i camera app also works but when i switch to video it hangs. Phone has been reset to factory. Same issue. Sorry for the long story. Need some Help on what part to replace. Is it the mic and speaker that's busted or some component like the DAC. If so where is the Dac located and how can i go about fixing this. Any part websites you recommend I'm from India.

Any help is nice guys. Please

My first V20 was one I bought on ebay that had sound not working. Also the camera was not working. I though it would be an easy fix, well, hoped actually, but it was not. I didn't pay much for it so I though it was worth the risk. The problem you have sounds exactly the same. Software reset won't fix it.
I did get it to work though temporarily. I put the motherboard in the oven for 10 minutes. It worked for a few days only.
The problem is that the DAC chip is now faulty due to water damage I'd say. You need a new motherboard. I would suggest buying a new v20 and keep the old one for charging your spare battery on quick charge! Or you can buy a new motherboard only on alliexpress for about 50/60 euros.

Thank you. I did consider an industrial oven. Could you please help me with temps you used? Was it the same error you got while trying to play a track?