I've had my elocity for a few months now and use it on a daily basis (with the dextor mod) and it's great except that lately I've noticed that the screen seems to be getting touchier. I mean, if I breath to hard it does false touches. Also, it just appears to do random touches sometimes (activated apps or bringing up menu in apps, etc..) ... it is getting to the point were it is starting to drive me a bit nuts. Anybody else experiencing this?
yeah, i've noticed excessive touch sensitivity at times, but its been off and on. i know having greasey/dirty/sweaty hands/screen causes lots of probs, so a clean screen is highly recommended.
i haven't put a screen protector on mine yet, but i suspect putting one on would give a slightly insulated layer to indirectly lower the touch sensitivity a bit. might be an idea.
Related
So since replacing my touch screen, I've noticed that the touch screen is having constant alignment problems. I read on another forum about a foam border going around the screen possibly causing problems and removed it and am still having problems.
When doing a test in the Notes function, it seems the more towards the center of the screen the stylus is, the more accurate it is. But when i start getting towards the corners, it either stops or freaks out.
Any ideas? Thanks!!
I tested out the HD2 outside in below freezing temps, and it really had a tough time registering my finger presses. It took about 5 minutes, before it could register properly... Anyone experience these issues?
Yes, and the wind keeps pressing things which makes it almost useless. I'm hoping some of the hints here on how to make it less sensitive will help but I haven't tried it yet.
I've noticed the "ghost" pressing (the screen registered a LOT of presses when my fingers were nowhere near the screen) of the screen too. I also contacted HTC support on the issue, and they said it was not a known problem.
So, again, I'd suggest that if you're experiencing issues with the screen in cold temperatures (finger touches not registering, "ghost pressing" etc.), let HTC know about it!
i got that kind of ghost typing too. pretty funny to watch but annoying when you see its deleting mails, answering sms or calls people ... will contact htc as well to let them know.
Confirmed here too. Though I thought it was caused by constant rain/snow here in Moscow, which fell directly on the screen when the ghost tapping occured.
Yeah I get the ghost tapping but only after i've been in a call and hang up, it then starts doing all sorts of things by itself normally ending up with dialling someone!! :/
I dunno about the ghost-typing but isn't it a common fact that capacitive screens don't work well with low temperatures?
That's a capacitive touch-panel "Feature" . HTC can't do anything about it (besides lowering the screen sensitivity).
edit: Umiss beat me to it lol
you can lower the screen sensitivity either by installing the new 1.48 rom or using the cab from the hints and tweaks thread in opening couple of posts. Should help.
i have applied the de-sensitive cab but when i use my finger to press down and drag selections, i can never be precise .. the screen starts to "shiver" around like Jack from the Titanic ...
hmmm is there any tweak to reduce this?
BTW, do i need to align the screen regularly?
thanks!!!
appreciate any help on this
I too have the same problem. I have read the other exhaustive thread on screen problems but couldn't come to a conclusion. Is this a software issue or hardware fault?
Do you mean the built in tactile feedback vibration where the screen buzzes to let you know it's been touched?
Settings/Personalise/Vibration/and then uncheck the box
Try the screen sensitivity reducing tips, or better still use BSBtweaks, it has a toggle to reduce sensitivity that works.
also, i found being too gentle with my fingertip makes it juddery. a firm press with the pad of teh finger works better for me than the tip.
I align my screen after any hard reset / rom flash.
i had this issue too, it appeared suddenly a few days after i upgraded the radio on my previous rom. with the current combination everything is in place now.
I would say it is a hardware fault. My first HD2 was perfect with no screen sensitivity issues. Unfortunately, it was accidentally damagaed and I had to replace it. The replacement unit did suffer from the sensitivity issue and although the sensitivity fix improved things substancially, it it still wasn't anywhere near as good as my original unit. So it went back to the store and they game me a replacement which I am happy to say doesn't have the sensitivity issue and is a joy to use again.
The new unit does however have an uneven backlight but I'll probably live with that as it's the lesser of two evils!
omg why cant they built it right one time!
Are you guys using a screen protector?
I used to have perfect screen behaviour. Recently, I saw the multitude of cheap 3 for $x screen protectors, and tested about 8 different brands.
Some were pure crap, didn't prevent fingerprints or oil...
The mirror ones and some clear ones killed sensitivity!!! Made my touches jump all over, my presses inaccurate.
Some matt screen protectors were too thin and were absolutely useless (and easy to scratch).
Only a few were good enough not to cause a problem.
Can only suggest you try remove the screen protector if you encounter the same issue.
Cheers
Unfortunately this is a known problem:
http://forum.xda-developers.com/showthread.php?t=595655
Getting the device changed has helped to reduce this in some cases.
leobox1 said:
i have applied the de-sensitive cab but when i use my finger to press down and drag selections, i can never be precise .. the screen starts to "shiver" around like Jack from the Titanic ...
hmmm is there any tweak to reduce this?
BTW, do i need to align the screen regularly?
thanks!!!
Click to expand...
Click to collapse
i was trying out the iphone, i noticed
iphone screen is matte.. no stickiness if sweat and swipe is smooth..
hd2 glossy if you sweat, you get friction... swipe depends on friction
if i were to put a matte screen protector, maybe it helps? anyone knows about this?
IPhone 3gs and HTC Hero both have an oleophobic coated screen which greatly reduces fingerprints and smudges. HD2 does not. Don't know why HTC don't use this tech on all of their capacitve screens.
ok i used a matte screen protector... result = smoother flicks and less finger prints.. but shivers is MORE...
hmmm what is wrong with our screen? * i tried iphone... NO ERRORS in typing..
could it be our software compensation for errors is screwed? u know as in the software is predicting the center of the finger wrongly
leobox1 said:
ok i used a matte screen protector... result = smoother flicks and less finger prints.. but shivers is MORE...
hmmm what is wrong with our screen? * i tried iphone... NO ERRORS in typing..
could it be our software compensation for errors is screwed? u know as in the software is predicting the center of the finger wrongly
Click to expand...
Click to collapse
all people i know has this issue i think it is software htc is not a fool company to release all devices defected
and i wonder why they take so long to fix it..
Is anyone else having problems with their touch screen?
It will occasionally become unresponsive, and other times will just start 'clicking' repeatedly in random spots.
I find myself having to turn the power off and on (via the button, not a hard power cycle) to fix the issue. Its starting to get annoying.
Anyone else?
Yes, I am getting the same thing but I've found that if I just turn the screen off and then back on it fixes the problem. I don't need to reboot.
You think this would warrant an exchange? or is it just how its going to be?
I've put several hours on mine, but haven't experienced this issue. I don't know, if this happened to me more than once, I probably would exchange it.
It was happening to me all the time. I had to get a screen protector and haven't happened since.
ryoojin83 said:
Is anyone else having problems with their touch screen?
It will occasionally become unresponsive, and other times will just start 'clicking' repeatedly in random spots.
I find myself having to turn the power off and on (via the button, not a hard power cycle) to fix the issue. Its starting to get annoying.
Anyone else?
Click to expand...
Click to collapse
gigadigit said:
It was happening to me all the time. I had to get a screen protector and haven't happened since.
Click to expand...
Click to collapse
Very good "solution" to what should be an obvious problem. The Nook Color has a *capacitive* touch-screen. If you get "junk/gunk" on the screen, it's gonna cause you issues. I find this to be the case while holding my NC and playing Flight Director for a while. The issue: My hands become sweaty and as a result of the slight film of sweat/oil on the screen, the NC's ability to measure the capacitive changes on the screen (and react appropriately to them) is compromised.
Keep your screen clean and you won't have this issue.
Note: after you wipe the screen down (damp cloth, etc), you will need to click the power button and go the lock screen and then back into the NC before it works right directly after cleaning the screen. The dampness of the cleaning cloth throws up the calibration enough to cause very strange things. My experience with "correcting" this issue tells me that in some way, the NC is recalibrating itself when you go to the lock screen.
johnopsec, this has been my experience as well. After cleaning the screen from finger-jam i don't get the phantom clicks. I also noticed that because I live in a very humid climate (Florida panhandle) there will be a thin moisture layer buildup sometimes and it really helps to wipe this off. I also have an incredible that does not have this problem but it has a screen protector which, I am guessing (and as gigadigit expressed), fixes the problem. Just make sure the screen is clean and dry before applying!
screen response
Also,
If you are holding the side of the case by the screen this throws off the touchscreen, I was having the issue where it would be clicking and multiple letter inputs when typing.
Also when it is laying flat and you have the power cord plugged in you may get multi letter inputs.
The trick, hold it by the back not the sides.
and if you have it plugged in and need to type don't leave it laying flat.
I have experienced this problem and loosely seen it correlated with moist fingers.
no moist fingers here and on my 2nd nc. this ones starting to have the ghost touches too.
My Nook Color started acting up after paying levels 3-4 to 3-6 of Angry Birds. I'm not sure if Angry Birds caused the issue or not as I haven't gotten it to do it in another app. I'm running 1.4.2. Doing a lock and unlock fixes the problem until it returns.
I managed to get Phone Tester to run after it got into this state. I made a video of it using a crappy webcam. There's a stuck finger in the corner.
youtube.com/watch?v=OdcVG-Q8LS4
Touch Screen issues while unit is plugged in..
It seems I have read on some forums that some people have screen issues.
Personally I didn't experience this until I tried to use my NC while plugged into it's wall charger.. It seems to act as if it has a grounding issue, which is not the case when the unit is unplugged.
So when you are running your multitouch or touch tests, do it without the unit plugged in..
-CC
I have had the same problem with my touch screen. I have the nexus live wallpaper and whenever you touch the screen it sends off the animation. Well sometimes it just goes non stop and sometimes opens up the window where you can apply a widget. I guess the most practical solution would be a screen protector but if not ill restore it and send it off to B&N
There's a small little app in the market named "Nook Screen Recalibrate" this app is super simple and easy to use. I hope this helps
https://market.android.com/details?id=com.assid.android.nookrecalibrate&feature=search_result
Here is the issue I have...
Right is the N button side. Just a reference point for this.
Reboot the Nook (I use CM7).
Bring up the keyboard
Touch Q in the center - you get W.
Touch Q on the right - you get W
Touch Q on the left - might get Q but you usually get W.
Recalibrate using the Nook Screen Calibration (above).
Q now gives Q unless you press on the right side of the key. I also notice I still have to hit the back arrow more to the left or I bring up the keyboard.
I've learned to live with it, but the left side of the touchscreen is slightly off and you have to touch to the left side of any object on the last 1".
Awats said:
Here is the issue I have...
Reboot the Nook (I use CM7).
Bring up the keyboard
Touch Q in the center - you get W.
Touch Q on the right - you get W
Touch Q on the left - might get Q but you usually get W.
Recalibrate using the Nook Screen Calibration (above).
Q now gives Q unless you press on the right side of the key. I also notice I still have to hit the back arrow more to the left or I bring up the keyboard.
I've learned to live with it, but the left side of the touchscreen is slightly off and you have to touch to the left side of any object on the last 1".
Click to expand...
Click to collapse
yeah, for me it's the edge of the screen along the right side. it's less sensitive then the rest of the screen. I found that calibrating 2-3 times really works best.
There's also a fix in the nookwiki, but i can't get my adb to work on my laptop, I think its the drivers.
http://nookdevs.com/Recalibrate_the_NookColor_touch_screen
What is the left and right side?
I should have said that left is the side opposite the N button.
I downloaded Multi-Touch Screen from the market and I can see part of the problem is the angle of my finger. Straight on it's better.
Nook Color Touch Screen Problem
Having similar problem as described, after two years. Extended warranty expired ... two weeks ago (of course).
Tried cleaning screen, no help. Have not tried screen saver yet, but will.
In the meantime, I notice the comments about touching the sides, and I noted that as well.
Is it possible that this could be helped by opening it up and re-seating the case? Has anybody tried this?
Does anyone have a really sensitive touchscreen?
Sometimes if even a droplet of water falls on or a smear/fingerprint smudge gets on mine, the flipside acts as if it is still being held at that point for me..
Sometimes it's caused hangups in a call, or zooms in indefinitely on some webpage, gets annoying sometimes.
Anyone experienced this or have a fix? I have a hard case, but that's not really helping.
just a thought
I noticed my screen is also very touch sensitive. I prefer it that way verse other android phones I've owned. Maybe a screen protector will give you the effect you are looking for.
Screen protector did the trick for me.