Hi, I have the following problem: when I connect the PDA to the computer via USB the device gets very slow and freezes sometimes and also is unable to sync with WMDC. The other problem I have is: the Wifi can't connect to any network and it barely finds any networks. I've tried to fix it with MTTY but whitout any luck. I'm starting to think that it's a hardware problem, although the bluetooth and phone are working. What do you suggest? Thanks!
Anyone????
Related
I have a problem with ActiveSync (or with my Qtek 9000, who knows): when I connect the PDA to the PC through USB, the PC detects the PDA, ActiveSync goes into "Connecting" mode, and then.. nothing. It says that it can not connect.
I followed several troubleshooters on the Internet, but the symptoms still remain.
Perhaps it's a software problem on the PDA. I'd love to perform a hard reset, but I must synchronize first (it's been 2 months since I can't synchronize, and I have done quite a bit of appointment and document entry on the PDA).
So.. what should I do?
I can connect the PDA to the Internet through WiFi and GSM 3G. Should I run a backup program, transfer everything to a FTP site, and then hard reset?
If so, which backup program should I use?
Is there anything I can fix on my PC to make it connect to the PDA?
What is your advice?
THANK YOU!
I have exactly the same problem when connecting via a USB cable to my home PC. Connecting to my home pc via bluetooth works fine and connecting to my work pc with a cradle works fine.
I've tried using different USB cables, different USB ports and have two Qtek 9000's with exactly the same problem on the same PC. I've tried re-installing AS 4.1 and 4.2 and both fail to sync with the cable.
Any ideas or advice would be greatly appreciated.
My Qtek 9000 used to connect and sync on this computer. In the last 2 or so months, this hasn't worked. No idea why!
Are any of you using the app "USBSwitch"??
For some reason, ActiveSync is using settings for a serial connection to connect to your PDA. USBSwitch will allow you to set the connection as RNDIS, which will allow you to connect and sync.
You can download it here -- http://forum.parallels.com/thread2743.html
I had the same problem with my Cingular 8125, and then found out that HTC included the USBSwitch app into the latest ROM upgrade. Has been working fine ever since I found it to switch over.
I had similar problems with my Qtek 9100
My problem was my firewall (Sygate personal firewall (SPF)) which did not allow me to connect via USB.
If I turned SPF of it worked.
My current firewall, NVIDIA Firewall, asked me if I wanted to allow the USB connection to my device. When allowed everything works fine.
/joel
I upgraded my rom with shaps's 3.54b. I can connect to internet with phone, but it is impossible with usb cable to use it as modem.
When I try to use internet sharing it disconnect active sync and try to connect to 3g network. Sometime it can connect, but the pc cannot recognized the connection working. Any other times it cannot connect at all.
Looking for in system option on my pc i saw my phone as network device (windows mobile based device) and not like usb modem. Is it normal? Reading in other forum someone suggest me to install usb modem driver... where can i download the right driver?
Thanks
try resetting your phone before you connect it. Sometimes like you it'll connect but sometimes for me my phone says check usb connection. But i reset the phone and it works fine.
Hello.
I have a question if anybody can help me.
I have a laptop connected to the internet. This laptop has built-in Bluetooth device. I also have a HTC touch dual phone.
I'd like to know, is there any possibility as the phone to use the laptop's internet connection via Bluetooth? (I mean, the phone to be connected to the computer via Bluetooth and using the computer's internet connection)
Thank you and any help is appreciated.
You could use a bluetooth activsync connection. (while connected via Activesync you should beable to access the internet.)
Could you please explain how to do it? I tried several times but did not work at all...
check this guide here - worked for me
http://www.geekzone.co.nz/content.asp?contentid=3163
Thank you. I will try today an seeif it is working for metoo... would be wonderful while Niki doesn't have WiFi...
I have a bluetooth activsync connection..when I use internet via bluetooth on my Touch Dual it works well, but after 10 minutes internet explorer says the connection is shut down, and i can't load web pages anymore.
But the connection with active sync is still up
It only works again if disconnect and connect again. Is this a Internet timeout or some..? Does someone know what to do about it.
Excuse me for my english
My problem is I dont even have internet connection when the device is connected to the PC via USB :-( Is there an option in activesync that you need to check to be able to do this?
i have an issue that has only appeared in the last couple of weeks, and is very frustrating!
whenever i connect my HD to the pc via USB, then the PC's wireless connection is lost, and it will not reconnect.
if i disable/re-enable the wireless adapter, it still cannot connect. i have to restart the pc to get the wireless back on the PC. it is very annoying, as it means everytime i want to connect my HD, i will have to restart my PC afterwards!
disconecting the HD from USB also does not allow wifi to re-connect, i always have to restart
any tips to help?
Thanks
..
ther is something wroong in your pc. thats for sure.
I don't think that you will find the answer.
the best thing you can do is by reinstalling your beautiful win XP machine
hi guys,
i have a big big problem - i cant sync normally my prophet. As I sync it via bluetooth oftenly it connects to the PC but there is no internet and browsing the phone options. The other and most bad problem is that the same is with the usb cable. even when I disconnect it it crashes the internet connection of the PC and I have to reset the network adapter everytime I disconect my phone. Oftenly I have to plug and unplug the cable to establish normal connection. I have the problem with different roms, using Vista 32x.. Please help .. I cant use my prohpet as it is supposed to
That's not really a problem its natural I have that same problem the PC is just trying to use your phone as a modem for internet access that's all. When connected to PC with your USB cable do you get internet access on your phone? if not you should configure manualy the phones network adapter when connected to active sync. It could work and we both got Vista 32 bit edition on Xp I don't get this disconnecting problem but if u wana sync only then uncheck the option in active sync Alow Data communications I think uncheck that option and your problem will go away ok but doing that ur PC won't share internet access with your Device ok hope you understand