Database Users

Dopod M700 did not work with SE HBH-DS970???

I use Dopod M700 and Handfree bluetooth Sony ericsson HBH-DS-970, I have problem about handfree.
After I compaired such devices, I could listen MP3 by DS-970 through WMP. It's worked and give qaulity sound! But, when I used DS970 as handfree/small talk, It's not worked. I could not answer/call by using DS-970. When incoming call while I listen MP3, WMP stopped but I could not recieved call through DS-970, I must recieved call by M700 only.
How should I do? Help me pleaseeeeeeeeeeeeeeee.
PS : I used official rom and did not install any program.

Go in Comm Mgr BT settings and refresh your DS970 services and ck: handsfree and wireless stereo, save. See if the phone part works.
And if that doesn't work, maybe since the DS970 can only be paired with one phone, it needs to be re-set - then re-paired. I think the instructions are on page 10...yep, found my book: Turn off headset, then press and hold the on/off for 5 secs - you will hear a long beep. Now it is ready to be paired. Next: press & hold the on/off and call handling button simultaneously for 5 secs. The headset will turn off.
When I turn on BT, I find it best just to go into BT devices and refresh the services on the DS970. It seems to behave better...

Thank you very much. I made follow your advise. It's almost ok, but when incoming call, no ringtone in both M700 and DS-970 but it show number and contact. In M700 vibrated only and no ringtone in both M700 and DS-970.
May M700 did not work with DS-970???
Any suggestion. Thank you.

Hello
I've similar problem, i can hear songs etc... i even hear the ring when somebody calls on my DS-970, but when i try to accept the call using DS-970, it is not being accepted, and if press the answer button again, the bluetooth gets disconnected and the phone starts ringing.
Not sure what's causing it.
I'm using O2 Exec with the latest rom.
Please guide
Greets

Hello
No problem i just found the solution to it:
Here's what I did:
* I deleted the HBH-DS970 from the list of BlueTooth devices
* Then I bonded them again (by setting the the little switch on the headset to the left and pressing the power button for about 5 seconds after it had powered on
* Now I move the switch over to the right
Now I can listen to music and when I have an incomming call, I get a short "beep", and I just press the mic button to answer. Then the music pauses, and resumes when I hang up.
Greets

funtoosh said:
Hello
I've similar problem, i can hear songs etc... i even hear the ring when somebody calls on my DS-970, but when i try to accept the call using DS-970, it is not being accepted, and if press the answer button again, the bluetooth gets disconnected and the phone starts ringing.
Click to expand...
Click to collapse
It happened to me when I tried DS970 at the SE shop today. Saddly that I was going to buy it
I am using Atom Life

Calling problems on Xperia

Hello XDA crew,
I have some problems and I hope you can help me with that. Xperia phone is really cool but one thing for me is really annoying. And that is the calling performance of Xperia.
These are the main problems:
1. When I plug in the headset, the ringtone plays both on the headset speakers and the phone speaker. Is there a way to let the ringtone play only on the headset speakers?
2. When I plug in the headset, the microphone of the headset isnt active. Only the microphone of the phone is active. So, people can not understand me when I speak to the headset microphone. But they can hear me when I talk to the microphone of Xperia.
These are some other problems but not so important for me:
3. The volume of the call is too high. Even when I set the volume low, people can hear the person who I am talking with.
4. Microfone of Xperia get active after for about two seconds when I answer the phone. So, I have to wait for about 2 seconds to say 'hi'.
5. The answer button of the headset doesn't work.
Can someone help me with this problems or just one of these problems?
Note: I have hardreset my phone two times and reinstalled the ROM software one time via SEUS. I didnt get any result. I have the original Vodafone R2 software.

I have the 2 second delay too. Using gtrab wm6.5 custom rom

M.Ozturk said:
Hello XDA crew,
5. The answer button of the headset doesn't work.
Click to expand...
Click to collapse
Unplug the headphone jack during a call and plug again (during the same call) and press the answer button. It will terminate the call and start working (until your next xperia soft reset). Double-press the answer button when idle, and it will repeat the last call. If that doesn't work, try it again and again after the first trick of plugging/unplugging and it will work on your 4th/5th try. From then on, all answer/hangup/'repeat last call' functions will work. Until you soft reset of course.
I'm calling a toll free (service center) number to do the trick whenever I have to use the handsfree.

VanAuberjim said:
Unplug the headphone jack during a call and plug again (during the same call) and press the answer button. It will terminate the call and start working (until your next xperia soft reset). Double-press the answer button when idle, and it will repeat the last call. If that doesn't work, try it again and again after the first trick of plugging/unplugging and it will work on your 4th/5th try. From then on, all answer/hangup/'repeat last call' functions will work. Until you soft reset of course.
I'm calling a toll free (service center) number to do the trick whenever I have to use the handsfree.
Click to expand...
Click to collapse
It works (on a WM6.5 rom also)
Nice little trick there, thanks

Tnx for the trick vanauberjim. So it seems more like a hardware problem. Anyway, I will try it tomorrow. Hope that the main problems also be solved like this.

Both 2. and 5. get fixed with the trick, but I just hope SE will find a permanent fix. It's not a solution to unplug and replug the headphones during calls.
My question is: are we the only 3 persons that have this problem? Is this problem originally caused by the headset hardware? Is it caused because the plug is so tight that it severely scratched the middle ring in the headphone jack and it can't always make a connection with the middle ring (the microphone one)? How many people have this problem?

Have the same problem
I do have the same problem and workaround works for mee to but it is annoying!

@vanauberjim, I can ensure you that we are definitely not the only one with these problems. I saw on a popular dutch forum that a lot of people have exactly the same problem.

M.Ozturk said:
@vanauberjim, I can ensure you that we are definitely not the only one with these problems. I saw on a popular dutch forum that a lot of people have exactly the same problem.
Click to expand...
Click to collapse
Have you tested with another hands-free set ? is it the phone or the hands-free causing the problem?
I have send my hands-free to SE yesterday so they will check it and if it was ok I will send the phone back.
About 3 seconds of delay when I answer , I haven't done anything yet , is it a bug , I mean do we have this problem or every X1 out there.

Ok, post back soon because if it's faulty hands free we only have 6 months warranty on handsfree (and battery) and time's running out. The phone has 2 years warranty so we have plenty of time for its handset's faults.

I got the same problems, is annoying BTW ... and about the trick mmm quiet annoying as well, but if is the only way to make it work, no more than just do it.

shwan_3 said:
Have you tested with another hands-free set ? is it the phone or the hands-free causing the problem?
I have send my hands-free to SE yesterday so they will check it and if it was ok I will send the phone back.
About 3 seconds of delay when I answer , I haven't done anything yet , is it a bug , I mean do we have this problem or every X1 out there.
Click to expand...
Click to collapse
I think it's a phone problem. I use the original headset and sometimes when I plugin the headset the phone calles the person who I have called earlier. Now I have another stupid problem. When I plugout the headset, the phone still thinks that the headset is plugged in on the phone. I see the headset icon on the phone and when I call someone, I cant hear and speak with the person. Only way I can do this is to plugin the headset again and speak that way. When I plugin and plugout for several times, the headset icon dissapears and I can make my call again without a headset. I think that alle these problems are because the jack plug doesn't function good.
Another issue. I call it issue because it's not a problem, but just a stupid choise of sonyericsson:
- Some soundnotifications during calling like 'busy tone' or 'waiting tone' plays from the main speaker of the phone in instead of the calling/ear speaker. This way, all the people who are sitting next to you hears that the person who you are calling is busy
It will be for the 4th time that I go to the shop with a problem. So I will ask to the shopper if I can choose another phone. I'm thinking about the Touch Pro 2. I'm sick of the problems of Xperia. Don't think that HTC will have the same problems.

Incoming call signal in the phone w/ headset connected?!?!

I really NEED my Touch HD to let the incoming call (Incomming SMS/Email too if possible) to sound through the phone speaker when I have headset connected through the 3,5mm jack.
I'm geting too crazy now, if I put the headset in the 3,5mm jack and have the headphones (w/ mic) haning around my neck with the HD in the pocket I miss every call, becouse the phone decide to send all incoming sound ONLY to the headset. Why???
I there some seting I missed? (please god let it be that way)
or
Is there some application/software I can install to get the function I want?
or
Do I need to get back to Sony Ericsson phones that do understand that they should let incoming call/sms/email notifcation alert sound trough the phone when headset is connected and musicplayer/radio is not activated.
ANY help very much appricated!
Thanks!

No one? No one have any comment?
Any one haveing the same issues with this "problem"? Is it solvable?
Or is it only me wanting to have this feature?

.
..
...
....
.....
..
..
..
..
..
Up!

For what it's worth - you could just have the phone vibrate for those alerts in addition to making the sound?

Bluetooth Handsfree problem

I have a Jawbone which was paired to my HD2. When I make a phone call it works, but when I receive a call it doesn't work. Has anyone experienced this problem? Has anyone solved it?
Also, when I place the set face down it doesn't automatically switch to speaker. Is there a setting?

1 - Answer the call on the handsfree and not on the phone.
2 - It has to be on perfect horizontal position to work (if not calibrate the g-sensor)

1- I always answer the call through the hands free but the call goes on the phone. Maybe a reset would do it.
2- Thanks didn't know that. It actually works

[Q] speaker problem

sir, my phone speaker is automatically switching on for incoming and outgoing calls,but not showing speaker symbol, and ear phones also not working .i tried hard resetbut nothing change. please anyone give suggestion

I too get this problem
Not really sure about the solution, but i have a simple work around that works on my p3400 WM6.5
1. Mute the phone (system as well as ring)
2. Restart