[Q] HTC 8525 HERM 100 cingular 8525 No GSM and unlock Needed - 8525, TyTN, MDA Vario II, JasJam General

sorry to send you PM sir
it was
ipl-1.01
Herm100
spl-1.40 olipro
came fro unlock
I tried
HTC_Hermes_SIM_CID_Unlock_v3a
then it goes to boo mode only
--Now I tried to recover by
Schaps_WM6Pro_Hermes_4.30_WWE_Full
choose spl 1.11/1.13/1.30/1.35/1.40 bootloader
no no IMEI and NO GSM opn device
what to do for IMEI and no GSM error sir?

Related

3300 dont start anymore

ive got a htp 3300 from movistar spain and i allready got it unlocked, yesterday i put the wm6 english on it and today y tried to put
PDAMobiz_Dopod_P800W_AKU301_v1.1.2_PowerMap, now
i can see only the white htc screen
IPL 3.007.001
SPL 3.07.0000
GSM 02.69.90
OS 1.28.0.0
the phone dont start anymore
y need helpe please
Can you get in to the bootloader?
If you do then you can put an original rom back. If you don't then send it to the service.
An unlocked device is out of warranty so be prepared to pay for the service.
Go to wiki of Artemis there you can find the method to get in to the bootloader.
Goof luck! << you need that.
you meen push the record button and reset in the same time???
i tried this befor but never go in bootloader modus maybe i make something wrong pleas help me
As of this http://forum.xda-developers.com/showthread.php?t=308242#1 threath of meschle states your device is a brik.
I'm sorry to tell you that.
meschle said:
Do Not flash your Artemis with a different carrier/cooked Rom without cid unlocking
--------------------------------------------------------------------------------
Noobs beware!
As a number have been flashing their devices with various roms not from their own carrier or country or cooked roms and bricking their device - I put up this sticky. Your device must be cid unlocked first before you do this. This applies to the coming wm6 roms to - if the rom is not specific to your device - i.e. if you try to flash the upcoming htc 3300 wm6 rom on O2 orbit - you must cid unlock first - with imei check or you will end up with a BRICK!
This does not apply if you are only updating the os http://forum.xda-developers.com/showthread.php?t=299154 or radio.
cid = country id i.e. locked to that country/language/vendor
cid unlock for the artemis is here with USPL http://forum.xda-developers.com/showthread.php?t=311403 (thanks pof)
or here http://www.imei-check.com/c3unlock.php (costs though)
Bricked devices
If you have flashed your device and not cid unlocked it, your device maybe salvagable if you can get it into bootloader mode.
Hold down the voice speed dial button and soft reset - you should then enter bootloader mode 'multicolored' screen'
If you do, attach device to pc via usb cable (a small usb will appear bottom left of screen) and flash factory rom. (run rom executable or RUU updater from pc) You do not need to be activesynced to do this.
HTC P3300 WWE factory rom downloadable here http://rapidshare.com/files/19322112...0_WWE_SHIP.rar
Dopod P800 WWE factory rom downloadable here http://rapidshare.com/files/21058219...0_WWE_SHIP.rar
O2 Orbit WM5 WWE factory rom downloadable here http://rapidshare.com/files/41574866/Arteimg.nbh
O2 Orbit WM6 WWE factory rom downloadable here http://rapidshare.com/files/46377862....90_Shi p.exe
Before you flash again with a non-factory rom, your device MUST be cid unlocked.
If you cannot enter bootloader mode your bootloader has been damaged and your device will need to be sent away for repair.
Click to expand...
Click to collapse
movilstore said:
ive got a htp 3300 from movistar spain and i allready got it unlocked, yesterday i put the wm6 english on it and today y tried to put
PDAMobiz_Dopod_P800W_AKU301_v1.1.2_PowerMap, now
i can see only the white htc screen
IPL 3.007.001
SPL 3.07.0000
GSM 02.69.90
OS 1.28.0.0
the phone dont start anymore
y need helpe please
Click to expand...
Click to collapse
i had the same problem and took me 3 days to fix it. so maybe this will work for you too !
first take out the battery for 30 min then push the reset button and put the battery back and turn on the device. if this not working. try to start bootloader by pressing and holding the record button and on/off button and push the reset butoon in the same time but keep pressing the record button and on/off button till a colored screen shows up??? sometimes it doesn't appear at the first time so just keep trying .
if you have bootloader you can reflash a rom. but you need to format your memorystick first to fat on your pc then put the image rom (nbh file) and rename it to Arteimg.nbh !! i used OrbitO2UK image.

CID Unlock Problem with MDA Compact II

hi guys!
i tried once lokiwiz03a and it unlocked the simlock. very fine. i got a tmobile card and tried a A1 simcard. worked!
now, i got drei simcard. i swapped the cards, turned on my charmer but the display tells me "simcard missing".
ok so i try lokiwiz03a again. and i see now there is still Lock Status: 0100000000000000
all right, i tried the wizard service tool, read the cid info and get this output:
Reading CID block...
Calculating CID block sum...
CID checksum: 446B90C3
Decrypted stored sum: 1FAFAC2328E0332F
Decrypted calcd sum: 1FAFAC2328E0332F
Key index : 3 - Block index: 158
CIDkey: 63400132
CID IMEI: 357037007738520
CID: CHRTMO12
Phone is CID LOCKED!
all right, i go to UNBLOCK CID(SuperCID) and i got this message:
SPL version is 2.06.0001
DOC chip is write-protected!!
Downgrade SPL to no higher than 1.06 and
repeat procedure.
the wizard service tool also tells me this info:
=> Bootloaders:
IPL: 2.06.0001 (G4 device)
SPL: 2.06.0001 (G4 device)
SPL date unknown
so i know its a g4 dev.
after searching the forum i could not figure out if i can or cant downgrad to a spl like this.
anyone got an idea how to unlock this device properly? or is my only change to go and pay some money to get it done?
thanks for you help
ok i think i found the answer myself.
the charmer does not support umts and my new simcard is from a umts provider. therefore the card can probably not be read...
thanks anyway.
if someone still has an idea please keep posting.
thnkx
HELP
wat answer u found? can u help me as i hav the same prob and unable to resolve??

8525 suddenly NO GSM

I have Cingular 8525, today suddenly when soft reset, show NO GSM. try to fix it by following the guide from wiki, after erase with mtty and flash with CID and Sim unlocking tool, 8525 now stuck in bootloader screen with 1.04 SPL olipro.
Anyone have any idea ? Please, appreciate any replies.
Forgot the last OS information, so I cannot provide last os version
Thank you

SPV M3100 please help step by step!!!!!!!!!!

i have SPV M3100 with
when enter boot HERM100
IPL-1.01
HERM100
SPL-2.03
when power M05
S04 NO gsm
B06 D3.60
after powered with splash imaging Orange phone hang on white screen
i tryed with some rom from forum failed error with INVALID VENDER ID or UPDATE error
(alway error at 1 or 7%)
i think my phone is locked SuperCID
anyone can help me???
thank in advance
Hard-SPL
mrphuc said:
i have SPV M3100 with
when enter boot HERM100
IPL-1.01
HERM100
SPL-2.03
when power M05
S04 NO gsm
B06 D3.60
after powered with splash imaging Orange phone hang on white screen
i tryed with some rom from forum failed error with INVALID VENDER ID or UPDATE error
(alway error at 1 or 7%)
i think my phone is locked SuperCID
anyone can help me???
thank in advance
Click to expand...
Click to collapse
http://forum.xda-developers.com/showthread.php?t=296722
To try and recover - RE-INSTALL THE STOCK, CARRIER ROM. Then HARD SPL YOUR PHONE!!!!!
Your phone ISN'T supercid by default. Hard SPL is the best way of doing this. I can't guarantee you will fix this problem as there are a hell of a lot of others with this problem. Do a search with the words "SPL 2.03 brick flashing" and you'll see, might be able to help too.
Good Luck...
I Had Found Provider
This Is From Orange Romania
I Tryed With Spl Not Done
How To Find Original Rom From Orange Romania????
See if they have a website. It may be WM05 though. Thats OK because you can then install Hard SPl and reflash afterwards. If you can't find........
nothing found!!!!!!!!!!!!!
ultramag69 said:
See if they have a website. It may be WM05 though. Thats OK because you can then install Hard SPl and reflash afterwards. If you can't find........
Click to expand...
Click to collapse
nothing in they's site
what i must to do?????

[q] htc elf or elfin doesnt start blocked in operator logo

HI EVERYBODY
i am wwriting you from algeria no htc help here
ive installed a french rom for my phone , i thought that it was a elf, it was running for 2 days without problem
yesterday i switched off my phone , and then it doesnt start again
all what i have is an logo operator from telefonica then black out
i tried again to reflash it without succes
when i boot the boot loader
ive the following message
ipl 2.20.0002
SPL 1.11.0000
NEED HELP TO KNOW WHET TO DO
AND WHICH KIND OF ELF IS IT ?
HOW TO DO IT JUST BY SERIAL OR PART NUMBER
THANKSSSSSSSSSSS
Do you know your original rom and details? Does it sya RUU in the top right in bootloader mode, and also USB in bottom left?
(I think they are the positions, I may be wrong)

Categories

Resources