hello i'm unable connect my Htc touch p3450 to active sync,
its only loading 3 colors screen, and also not loading the wm 6.5
i wanna install official windows 6.1
my current spl and ipl
IPL 2.20.0002
SPL 2.26.0000
Hi syknev
Please use the "search this forum" with these keywords "stuck in bootloader" and read all the results, you might find your answer
Good luck!
Related
My problem is, my htc touch elfin? (mda touch elf0300) stuck in bootloader-mode. Is there any Solution to get it working ?.
IPL : 2.26.0002
SPL: 2.26.0000
ELF0300
After 2 % crashed the rom update. I can´t the uspl until again because, the device wont connects to active sync.
Need Help
Thank you
.
i have same problem too, but
IPL 1.16.0002 and SPL 1.16.0000
I also have this problem
IPL 1.16.0002
SPL 1.16.0000
Stuck on bootloader screen none of the usual reset options seem to work and doesn't show up when plugged in to usb port
Help
Thanks Si
i have htc 8125 wm 5.1
i was upgrading it to wm 6.every thing was fine.but then i try to upgrade it to 6.1
and active sync disconected at 60%
now when i turn on the phone i get cingular screen and
IPl 2.25.0001
SPL 2.25.0001
GSM 02.25.11
and no OS version is loading.please help my to fix it
someoneee said:
i have htc 8125 wm 5.1
i was upgrading it to wm 6.every thing was fine.but then i try to upgrade it to 6.1
and active sync disconected at 60%
now when i turn on the phone i get cingular screen and
IPl 2.25.0001
SPL 2.25.0001
GSM 02.25.11
and no OS version is loading.please help my to fix it
Click to expand...
Click to collapse
Your problem is NOT fatal. If you were able to start the flashing, you have enough to search and read through the forums on flashing. I have had the "RGB" screen problem happen to me. I read through the forums carefully and found the answers. Give it a shot.
Plug your phone in and flash "This ROM"
thanx for the link.But i can't install any os because i can't connect to activesync.I tried in boatloader but still can't connect.Can you help my?
ow right.i did it.I search this forum and found some usb sync drivers.then connected the phone and setup works.thanx for your help!
hi
I have a dead htc hera100 after flash now just enter in boot mode (tricolore)
IPL: 1.08.0001
SPL: 1.08.0001
I don't make a hardspl for it
now it doesn't accept any firmware
any idea
Thanks
maverick_lp28 said:
hi
I have a dead htc hera100 after flash now just enter in boot mode (tricolore)
IPL: 1.08.0001
SPL: 1.08.0001
I don't make a hardspl for it
now it doesn't accept any firmware
any idea
Thanks
Click to expand...
Click to collapse
Your SPL is below 4, so you cannot flash the phone. Your only option might be searching for and doing a "Goldcard".
Hi I have a P4350 but would not connect with my PC
before i flahst my mobile it only want to connect with my pc now it don`t want to connect with my pc and stil giving a wit screen
i flasht my mobile with :
RUU_Herald_HTC_WWE_1.8.405.1_02.71.90_Ship_2
if someone has a solution please mail me [email protected]
By mistakely Orefkov hspl and run rom update utility of this folder my old Gene show black screen.when press power key call/reject led blink one more time but screen is going black.the gene goes in bootloader tri screen mode.
IPL 1.02.0000
SPL 1.07 orefkov..
before hspl my old gene information is
Rom version 1.2.707.1 WWE
Rom dt. 11/30/06
Radio 02.71.90
Protocol 4.1.13.31
ONBL 1.02.0000
SPL 1.02.0000
GSM 02.74.90
OS 1.2.00
please help
thanks
saurabh_1999 said:
By mistakely Orefkov hspl and run rom update utility of this folder my old Gene show black screen.when press power key call/reject led blink one more time but screen is going black.the gene goes in bootloader tri screen mode.
IPL 1.02.0000
SPL 1.07 orefkov..
before hspl my old gene information is
Rom version 1.2.707.1 WWE
Rom dt. 11/30/06
Radio 02.71.90
Protocol 4.1.13.31
ONBL 1.02.0000
SPL 1.02.0000
GSM 02.74.90
OS 1.2.00
please help
thanks
Click to expand...
Click to collapse
hi
1. if u have done the wrong HSPL for ur phone then i think u need to take it to service or do that jtag(i dont know how to do this )
2. u can try this if u can get into ur try color
connect the USB cable if u get the USB symbol on the phone then try flashing the right ROM for ur phone
ask this question in the gene Question and answers thread in the development section im sure some one will help u
Thanks
hari
have a HTC Athena x7500.
Im stuck in bootloader.
Wend I power on the device it goes directly to bootloader and
the screen say :
ET \ Njq
IPL - v1.00
ET \ Njq
SPL- v1.20. Olipro
USB( wend is connect )
serial ( wend is unconnect )
I dont remember what it was befor I try to flash a WM 6.5 rom on it.
It as a WM 6.1 in Portuguese Rom befor my attent.
I cannot power off the device by pressing the button but have to take
the battery.
I already try to change the rom, the SPl and put everything inside just
to try to move from were I am but no results.
Began to update but ends or in 1% or in 7% and loose the connection.
The device connects to the PC but in PC in WM device center nothing happens.
I try Win7 and also XP.
I went to HTC site to download the official portuguese ROM but there are no
ROM to download.
So I´m dead on the water.
I will apreciate very much any kind of input that take me out
of were I´m now.
I´m not a expert as you already notice.Please keep it simple.
Thank you
stuck in bootloader. Help needed.
stuck in bootloader. Help needed.
have a HTC Athena x7500.
Wend I turn on the device, it goes directly to bootloader and
the screen is:
ATHE 100
IPL - v1.00
ATHE 100
SPL-v3.05.0000 OR my old spl spstuck in bootloader. Help needed.l is 1.10
I have tried to change the language of my athena and then he died :spanish > fransh
USB (wend is to connect)
series (wend is unconnectable).
I can not turn the unit off by pressing the button, but must take
the battery.
I have tried with hardspl its not working
I want a solution in the forum xda-develop it says my q must upgrade to the rom of espana oficial
After downloading the rom:Advantage_HTC_SPA_2.21.412.1_1.50.00.00_Ship
I tried to upgrade to this rom May j has a mesage on my athena screen:
found spl v1.10
dowload Spl before v3.05 is not allowed!
I tried to update it with the sd card i have the same mesage
upgrade with athenaUnlucker not work
upgrade with hardspl v7 not work
upgrade with CheetahUnlocker not work
upgrade with athena wraper not work
J have explored ruu_signeg.nbh with notepad jai entered the signer spl 1.10 I know if c is vrait or name
I believe there is a problem in the image rom saved in my athena rom
what I see on the screen of my athena is the spl 3.05.0000
The real spl is 1.10.0000 there is confusion in my spl
is what I can fix this problem with mtty
so if possible please guide me
sorry for my bad Englis
thank you in advance
My email: [email protected]