Hello,
i have a cigarette dropped on my touch screen and want a replacement screen for it. Where can i buy one ?
i have bought this: http://mobile.brando.com/htc-touch-diamond-2-replacement-lcd-display_p04369c0696d088.html
but this is the lcd, not the touch screen ???
you have to buy digitizer something like that
prdic said:
you have to buy digitizer something like that
Click to expand...
Click to collapse
Exactly....But the touch screen digitizer is very hard to replace. I have taken mine apart only to find it near impossible to replace without damaging the rest of the phone. I only wanted to replace the housing, but you must replace the housing and digitizer together.
NOTE: If you attempt this, remember to remove the stickers over the little ribbon cables before sliding them out. Found that one out the hard way.
Your best bet would be to send it to hTc for a repair. I really wouldn't risk it if I were you... I only did because I have trianing in electronics.
oh ok, any ideas of the costs when sending it to a repair center ?
The repair cost me 157 euros for replacing the housing and touchscreen sensor.
And if you want to prevent further costs with such issues .... uh ... quit smoking
Related
used windex on my screen and the digitizer went bad.
any recommendations on where to purchase a new one?
thanks pogo
on eBay! ...
cnn.cn 7.99$ I have to order one this week, just have to get around to it.
cnn.cn BINGO !
:d :d :d :d :d :d :d :d :d :d
8525 Digitizer Installation...
Hello,
I have an 8525 with a broken digitizer (LCD OK). I replaced the whole unit with a new combined LCD/Digitizer. It is a pretty straightforward repair. It took me all of about 15 minutes (you just need a #6 torx and a jeweler's phillips).
Just in case this happens again, I purchased a new digitizer (only). I want to remove the old digitizer from the LCD screen and replace it with the new one. The problem is: the digitizer ribbon cable is attached to the LCD screen, possibly soldered but I can't tell. Are there any instructions anywhere regarding the digitizer removal and installation?
Thanks
Im new to all this whats the digitizer exactly?
The digitizer is the top portion of the screen. It's what registers your stylus' contact on the screen. It lays on top of the LCD and it looks like 1 piece, but its actually two. And for those wanting to know if the digitizer is soldered, the answer is no. It's held in place with tape, but it is easier to just replace the combo instead of just the digitizer. Most often then not, when removing the damaged digitizer, it will crack and may possibly damage the lcd, or so I've read. I just recently cracked my lcd, so i got a combo and switched it out, just to have a scratch on the digitizer the following day. That's life. Waiting for my next new combo to come in the mail.
You'd be better replacing both the lcd and digitzer as 1 unit than try to unglue and reglue the digitizer onto your screen. A lot of hair pulling and screaming involved and no guarantees it'll work. For the $100Aud I'd just replace the lot in one hit. As markus1959 said its a 15 minute job but stuffing around with just the digitizer is a major hassle. Even Mike Channon (he's the hermes hardware guru) advises against that unless you're really into pain and frustration....
Cheers...
Hi,
from where do you all get a new LCD (+ digitizer).
My LCD is cracked (digitizer OK) so I need replacement.
I live in Switzerland and I can not find a shop with a reasonable price.
hi all,
today i suddenly dropped my hd2 during my daily commuting out of my shirt pocket when i bent doen to pick sumthing up...even thgh it was in the pouch,,,the inside lcd screen developed a long crack across the upper face ..thgh it is visble only on dark screen prominently..
worse is the touch functions have suddenly stopped responding..i can not access my phien features by touch as nothing happens..
screen is stuck in unlock screen..cannot slide across to unock
tried soft/hard reset, practically everthing
its just 20 days old for gods sake,,wh culd be the matter
I feel for you ... is it insured?
no..will warranty cover that,,the i can recive phone calls fine....thru buttons only...is there any way to remove that lock screen so at least i can access function thru keys
Even so, you can't do much with those buttons alone. But sounds like you only broke the digitizer. It costs much lesser than the LCD. You may want to try fix it yourself.
Sorry to hear this chap. If it's not insured (I don't understand why if it's not) then your best bet is to send it back to HTC to get it repaired.
You must be gutted.
WB
ya,,,,gave back to the dealer for repairing...how do i know whter its digitiser or inner lcd broken..i mean he might repair digitizer and charge me for lcd screen..unfortunately here in india no insurance facilty for mobiles...no idea how long it will take to get repaired
how can it get cracked..i was sitting when it fell from my lap ,was in the pouch..surpisgly outer glass did not break and inner lcd broke
shuld serve as warning to all here on forum to take care and opt for sum hard case
Can you share a pic of how ur hd2 looks now?
Good luck!
dheerpat said:
ya,,,,gave back to the dealer for repairing...how do i know whter its digitiser or inner lcd broken..i mean he might repair digitizer and charge me for lcd screen..unfortunately here in india no insurance facilty for mobiles...no idea how long it will take to get repaired
how can it get cracked..i was sitting when it fell from my lap ,was in the pouch..surpisgly outer glass did not break and inner lcd broke
shuld serve as warning to all here on forum to take care and opt for sum hard case
Click to expand...
Click to collapse
You can Insure your phone my friend.. check this
http://newindia.co.in/per-mobile.asp
From what I know..
National Insurance Company, Oriental Insurance Company, New India Assurance Company and United India Insurance Company cover mobile phone insurance. They fix compensation equivalent to cost of replacement by new mobile of same specifications and capacity, including all taxes and duties.
Hope this helps..
From a fellow Indian
hi all..my dealer says he had forwarded hd2 to htc service center and since its a new model the screen replacement is not avalible..he said they quoted estimated price of 20 thousand for the screen.obnoxious..thts 400 dollars!!!
i searched ebay and found digisters selling for about 60 dollars..
my question is shuld i go ahead and buy .what is exctly a digitiser ,,
i dont want to find out after spending the money that its not a digitser problem,,is there nyway to acertain its digitser proble..i no more trust my dealer
400 dollars? that is half a hd2.
the upper layer of the screen is afaik the digitizer.
touchscreen is built of two elements. the lcd and the digitizer.
the digitizer is for handling touch. that may be the part which cracked and is not responding now.
however I am not sure if it's easy to replace the digitizer since you must seperate the lcd and digitizer which are tied closely together. maybe someone experienced here on xda knows how.
ummmm..so u mean basicslly there are 3 components
1..outer most glass which we touch pysically
2..digitser which is embeded on
3 lcd screen
is the digitiser made up of plastic material which is crackable or in my case lcd whihc is 3rd layer has cracked while digitser is intact
unfortunatly cannt post snaps as the instrument is with dealer..
Does anyone know a site where to buy that? I have the white version but black is fine also. I would like a full replacement, digitizer included.
Will it avoid my warranty if I replace it? And do I have to open the whole thing to replace the digitizer only?
thanks in advance
I can't find housings anywhere. And beware, I replaced the digitizer, and when I put it back together, the lcd was cracked in the corner; it's glued on with damn gorilla glue I swear, you will not be able to replace the digitizer without hurting the lcd unless you can somehow get the glue to unbond. Also, yes, you have to take the phone completely apart (like, the last step of disassembly in the service manual) to get at the digitizer.
You can find service manuals in pdf on google
Good luck if you attempt anything, but I wouldn't reccommend it!
*EDIT - Yes you will well and truly void the warranty
try this
http://mobile.brando.com/samsung-gt...eplacement-housing-white_p05872c0670d088.html
Hello guys,
today my hd2 fell on the floor and the display cracked. the lcd and touchscreen are still working fine, even in the area where its cracked.
Is there a chance just to replace only the plastic case on the lcd? Or do i have to completly renew it?
Thanks!
Nope, sorry.
There's no plastic display on the HTC, nor anything plastic. The LCD is soldered to the digitizer and normally both should be replaced. They cost around 100$, and the replacement is about 200$ in the HTC center. You do the math, it's the price for a sec hand HD2. Otherwise, you can buy and change the digitizer (costs around 50$). But this is a very delicate operation to do by our own -you have to cut the LCD from the cracked digitizer and do many other things. As someone have said for some other reason "it is an easy operation, but if you have no experience in soldering, do not try to learn it on your laptop motherboard". So, your choice is between repairing it in HTC for 200$ and "repairing" it some other service for 100$, with questionable quality and voiding your warranty.
As you may guess, I have walked that road already. My HD2 was 1 week old. After some sleepless nights (as I was wondering what to do AND because the "perfectly working cracked screen" had cut my fingers) I sold it 100-120€ under the second hand market price and found a new one. That's also my advice to you. I.e. the first one. The second one is to buy a silicon cover for your next HD2.
ingrdgrbl said:
Hello guys,
today my hd2 fell on the floor and the display cracked. the lcd and touchscreen are still working fine, even in the area where its cracked.
Is there a chance just to replace only the plastic case on the lcd? Or do i have to completly renew it?
Thanks!
Click to expand...
Click to collapse
GUYS I need to know if its possible to replace the TMOUS HD2's LCD only as its cracked .. the digitizer is perfect
mally
YES, it possible. I did it on my phone and firend bought one broken too on which i replaced lcd (not digitizer).
You have two ways. First is easy way.
Buy complected digitizer with lcd and you have done on hour.
Second way is buy only lcd and replace it. But there you must very very gently remove digitizer at lcd. This is littlebit tricky. You must use oven. Place oven to 50 °C and place your, attached digitizer and lcd, to oven. 10 minutes is enought. Now you can more easly detach old lcd at digitizer. Be very very careful and gently. You can scratch paint on digitizer on lcd side and also lcd itself. Attaching lcd to digitizer are used sticker adeshive tape. You need buy it too. I dont want advertize one ebay seller but you can use same dealer if you want. I had with that dealer many actions and all time all is correct. And he have most items OEM. Ebay seller name is kr-net.
I recommend first way if you do it first time or not opened any phone before.
Bestest way is give your phone to repair.
datas0ft said:
YES, it possible. I did it on my phone and firend bought one broken too on which i replaced lcd (not digitizer).
You have two ways. First is easy way.
Buy complected digitizer with lcd and you have done on hour.
Second way is buy only lcd and replace it. But there you must very very gently remove digitizer at lcd. This is littlebit tricky. You must use oven. Place oven to 50 °C and place your, attached digitizer and lcd, to oven. 10 minutes is enought. Now you can more easly detach old lcd at digitizer. Be very very careful and gently. You can scratch paint on digitizer on lcd side and also lcd itself. Attaching lcd to digitizer are used sticker adeshive tape. You need buy it too. I dont want advertize one ebay seller but you can use same dealer if you want. I had with that dealer many actions and all time all is correct. And he have most items OEM. Ebay seller name is kr-net.
I recommend first way if you do it first time or not opened any phone before.
Bestest way is give your phone to repair.
Click to expand...
Click to collapse
Thanks a lot for your inputs mate, the phone's DIGITIZER is perfect , the LCD is cracked, should i still be gentle , since LCD is already broke,,,,
As i writed before:
Be very very careful and gently. You can scratch paint on digitizer on lcd side
Click to expand...
Click to collapse
Your digitizer is painted on bottom side on edges. If you scratch this paint you get scratched look later.
If you go change it itself, i anyway reccomend buy mounted lcd with digitizer. This work not easy deal.
And more. I readed over forum that someone have later digitizer sensity problems with no compatibility different lcd and digitizer. I cant confirm it. This what i changed works perfectly.
One hint is that HD2 and HD2 T-mobile have different lcd and digitizers. HD2 have soldered version and T-mobile not. You can see it on this ebay seller page, if you get one or another item detail look on seller shop page.
You can always contact www.ppctechs.com to fix it also.
addicus said:
You can always contact www.ppctechs.com to fix it also.
Click to expand...
Click to collapse
Thanks a lot for your inputs guys,
By the way its not MY HD2 thats damaged, its a friend of mine, so this was all very helpul,
Best regds