hey guys this is what is happening to me:
i turn on the universal, the boot screen shows, and before getting to desktop a blank screen is showing and stuck there, but u can still see the flashing green light of the GSM is working, i tried everything, i did hardrest and nothing happens, i changed the rom version and the radio version, still nothing happens too, same problem, please help
Related
hello. i have an o2 i-mate jasjar phone. i updated my rom and since then my phone wont start up.
i tried going into bootloader mode and re-installing any rom that i could find with that mtty program, even with the original rom, the
the rom installs just fine, but when i do the hard reset the phone goes up to the start up screen showing
the rom info and just stays there.
i also updated the bootloader from v1.00 to v1.01 to see if that fixes anything but no luck.
does anyone have a clue of what is going on?
p.s when i connect the phone with ac power the led that shows if the phone is charging wont light up. dunno why! :S
PLEASE HELP ME!!!
does anyone has a clue of whats going on???
i really need some help here please!!
there are some progs on wiki. Instructions for those stuck on bootscreen.
i am not stuck on boot screen. i am stuck on the screen that shows the ram info, i think its called splash screen....
can somebody help me?
need help please ,,when trying to reformat my phone with a new rom i get error messages all the time.i tried with active sync 4.5i really would like some help..to get around this porblem as iwant to change the rom on my phone..cheers
[email protected]
are you sure the problem from active sync?
did you flash HARD SPL ever?
what's error messages, details, please.
hi
hi there i might of done once how do i correct that if i have ...
hi again
error 246 device not responding
and it goes to red green blue white menu
and then does nothing
iv tried various roms
thanx
thanx anyways for your help iv fixed the problem... which is to take the cable out of pda when in red green blue screen and restart rom again then it will flash the phone.
ok i have a issue with my fone my phone is stuck on the tri-colored screen which says:
TITA100
SPL-1.20.01ipro
well i am as u can see im not good with tech. stuff like this but i would like sum advice or ideas on how to fix my problem. well here is how it all happened. my fone started off fine, out of the blue it started turning off by itself, then coming back on. it will reboot fine then as soon as i touch the screen or try to text or call it shut off on me. first i thought my battery was dying. that didnt work kept it on the charger switched out the battery, still nothing ended up doing the same. so a fren told me to hard reset or press the ok button pwr n the reset button at bottom using the stylst. now im stuck in bootloader mode after i ran a program:
HARD-SPL-MFG
and was told to flash the fone, which i had no idea what to do the person who was helping me i didnt hear frm again n i was stuck in this tricolored screen what should i do? i just want my phone up and running so i can use it once again...if thats possible..it be great i love the phone n dnt want the money i invested into it wasted
thank you soo much,
If I had to guess, it sounds like you have installed a SPL that is not compatible with your existing radio and rom.
First thing is I would try downloading the stock rom for your phone, I believe you can download this from HTC's website, I would download the newest and the one prior to it. Try installing the older of the 2 first since your SPL that you do have is older, and if it fails to install, then try the newer of the two.
If it still fails, come back here and I'm sure somebody else can give you more advice.
BTC
Hi all!
My Trinity does not always start up properly. I press the power button and the green light comes on but nothing else shows on the screen and it stops booting. This happens very ramdonly and mostly when it has been switched of for a while. It stops just before showing a screen with red lettering where you can read the ROM version & other stuff. Then I have to soft reset a few times and it will boot up ok.
Most of the time it starts up ok but this is really annoying, can you please help me!!!
Try a hard reset and install a stock/official ROM if the problem persists.
If it is still happenning with an official ROM, might as well send it for repair...
Thanks for your answer. I will try an official ROM and will see what happens.
Power Problem
When i am doing new rom.Somehow my boot gone.Now doesn`t work my power. Can anyone say me how i do that? or back my previous version...
I am using xda atom exec
Hi to all ,
I have the msn account:[email protected] .Once again,just to make the resume of the whole story if I remember well:The trinity was with the initial sfr 300+ software(wm5);I installed the oli1.20 flashed it with some other ROM software,did not like it and returned to the original one.Then I tried to flash it with the ROM software where all went wrong...After 1 % the screen went blank and all I can do with the device is to put it into the boot-loader mode where it says:
TRIN100
IPL-0.50
TRIN100
SPL-1.07.0000
When I extracted the file,I discovered that it has 2 nbh-files.I think that is the reason of my defete.Afterwords I have tried all sorts of the first aid solutions : splxploit-windows cannot connect to the device;it says that there is no WCEUS-file and therefore it cannot continue.I have tried to re-flash it through the sd-card:I re-formatted the card on fat32,without any name,put the original ROM and tried to let it boot that way.No success,it marks:loading ... and after 3-4 secs it returns into the boot-loader mode with the same message mentioned above ...
Salutations frm Luxembourg , Goran Stevanovic.
Thx all of ya , problem solved.
sir me too have same probelems, but ma 2 htc trinity dnt stuck at bootloaders, its to to operator logo and stuck there, i have 2 phones with this probelem.
please help me to solve this probelem sir.
gurnek said:
sir me too have same probelems, but ma 2 htc trinity dnt stuck at bootloaders, its to to operator logo and stuck there, i have 2 phones with this probelem.
please help me to solve this probelem sir.
Click to expand...
Click to collapse
1: Boot into BL (camera + power + reset hole)
2: Download the GPS enabled ROM from HTC Support, NOT from a rapidshare/megaupload/4shared etc.. mirror.
3. Flash the ROM, but use the hardspl flasher.(For some reason, it doesn't go error 270 if I use this flasher).
4. Hard Reset again.
Hello,
I have a HTC P3600 and after i make a hard reset the screen goes all black, i already try flash the phone but don't result.
If i try to make a hard reset again the screen shows "press ok to make hard reset" after that goes black again.and its completing %100 but when i want restart its still doesnt work just black screen. just working light =(
So i think not display problem.
Any solution? help me plss
Any chance of sharing the solution, guys, my SPV M700 has similar problems. I tried to flash it with the TRIN-SSPL rom, but it kept saying I need a newer version of the update software.
Now all I have is it gets stuck on the green Windows load up screen and when I reset (Camera-PWR Button-Reset) it goes onto the bootloader tri-color screen, similar to what Goranchen had on his. What do I do now, I would really like to use the phone on another network, and I have looked after it really well, I think, so would be a shame to throw it away. Please help!!