need help please ,,when trying to reformat my phone with a new rom i get error messages all the time.i tried with active sync 4.5i really would like some help..to get around this porblem as iwant to change the rom on my phone..cheers
[email protected]
are you sure the problem from active sync?
did you flash HARD SPL ever?
what's error messages, details, please.
hi
hi there i might of done once how do i correct that if i have ...
hi again
error 246 device not responding
and it goes to red green blue white menu
and then does nothing
iv tried various roms
thanx
thanx anyways for your help iv fixed the problem... which is to take the cable out of pda when in red green blue screen and restart rom again then it will flash the phone.
Related
Hi Friends,
My new mobile phone SPV M600 got stuck whil starting showing four lines of messages as shown below.
IPL 2.10.0001
SPL 2.10.0001
GSM 02.07.20
OS 2.10.1.22
Can any one please help me in geting my phone to today's screen.
I also attached the screen shot for reference.
did you try a hard reset ?
Ya I tried both hard as well as soft reset but same screen is stuck again and agian.Can any one please help me in this regard as I am very new to PDA family.
Ok, first things first:
Since you are new to this, are you sure you preformed a hard reset?
It is done by holding power + camera + comm manager buttons (one on the right, two on the left) and pressing with stylus in the reset hole at the same time.
A message should appear asking you to press 'send' (green phone button) to confirm reset.
If this does not help, you may have a serious problem.
Please answer the following:
Is the device fully charged?
Phone will fail to boot if the battery is too low.
Did you install any software right before this happened?
This should have been resolved by hard reset, but just in case I am asking.
Did you change the ROM, attempted CID / SIM unlock?
This could require more serious measures than I can advise on.
I did exactly the same thing which you mentioned.But even then it is stuck at the same screen.
Ya u r right I unlocked my mobile using a software from eBay.The unlock was successfull and I tried to insert T-Mobile sim, it also captured the signal and I was able to make and recieve calls then after that I wantedly switched off the phone and then tried to start it, there got the problem.
Can any one help me in this regard please.
I am having the same problem, but my phone is not sim-locked.
I've got the same problem after attempting smart1_wm6_pp8mb.exe
I'm having the same problem with my G4 QTEK S200:
Attempted to upgrade to WM6 Rom using smart1_wm6_pp8mb.exe
After reboot the phone got stuck at the QTEK Screen
Tried Hard Reset (Camera+Power+Comm+Reset) followed the steps with the same results (bricked)
I also tried re-flashing the rom back to the factory one using RUU_Prophet_220734_2207114_024721_QtekWWE_Ship and ROMUpdateUtility-NoVendorID.exe in Windows Vista with WMDC (Windows Mobile Device Center v. 6.0.6873) and the phone in boot loader mode (tri color screen) with working USB cable, with windows firewall disabled and symantec AV disabled as well, RUU keeps saying error 260 "the update utilitiy cannot connect to your pda phone..." .
Do you think I should try this process using XP instead? No matter what i try i keep getting the error 260
Any help would be greatly appreciated
Got it fixed!
it was definately a Vista issue. once i tried it in XP with ActiveSync it worked like a charm and i got my phone back up and running. also used spb backup and restored all my settings.
ipl/spl screen
i got the same problem with new rom wm6, and the 260 eror, my problem is that i have xp and the activesync does`t connect ...
... means i cant redo the original rom ????
PLEAAASEEE HELPPPP !!
Again My phone SPV M600 got stuck at IPL/SPL screen
Please Can some one advice me how to get my phone back.
I raised the same issue 7 months back after that my phone got recovered automatically and there were no issues till last month. Last month onwards it is again got the same problem and now it is permenantly stuck at that screen what ever you do.
yekanth said:
Please Can some one advice me how to get my phone back.
I raised the same issue 7 months back after that my phone got recovered automatically and there were no issues till last month. Last month onwards it is again got the same problem and now it is permenantly stuck at that screen what ever you do.
Click to expand...
Click to collapse
A rom reinstall on xp solved my problems on that one. retry a couple of times! It may not work the first time! hard reset as well...
Try an official wm5 rom just in case
good luck
Can you please gimme step by step procedure
HI Phil,
I am new to these kind of installations . CAn you please Gimme step by step procedure for ROM installation.
mine is now also stuck, after trying to install new rom. wont connect to active sync either, have i fooked it? tried hard reset etc.
thanks
(with a turned off phone, press and hold camera button then insert USB cable)
then flash provider ROM
RECOVERING FROM ERROR IN STEP 8 WM5->WM6
1. Don't panic
2. Don't panic
3. Unplug the phone
4. Reset with stylus,and keep the Camera Button pressed.
5. A 3 color screen will appear(Bootloader Screen)
6. Connect your device with your PC,and run the NVID(no vendor) WM5 rom.
7. The device will be resetted after RUU(rom update utility)finishes
8. Repeat the WM6 upgrade,from STEP 5..
Click to expand...
Click to collapse
from here http://forum.xda-developers.com/showthread.php?t=310452
hi jay
i seen your post in n00b guys one, i fixed it!!!!, thank you so much, i couldnt remember how to get it to those 3 colours.
thanks again
Colin
Hi Iam unable to get the NVID ROM
Hi,
I am unable to get the NVID ROM. The Rapidshare link that has been provided in the other thread is not working. Can some one tell where can i get the ROM.
collywog19 said:
i seen your post ...
Click to expand...
Click to collapse
no problem mate.
..and yekanth i see what u mean about the dead links. i have the files on my computer at home but i'm posting from my prophet right now, so i can't upload. Try using the "pdaviet temp" from one of the wm6 threads?
(http://rapidshare.com/files/54265407/Prophet_PV_Temp.zip)
Hi Iam able to update the Rom but no use
Hi,
To mention my phone is from orange-UK. I got the orange rom from our FTP site and did the flashing/update what ever you say.But still it is getting stuck at the same IPL/SPL screen. Iam very much worried that I will not get a proper solution for my problem.It will be very grate full if some one resolve my problem.
just seems strange...how did you fix it last time? did it just start working again? A random guess would be that the camera button got liquid spilled on it or is stuck in.
If the camera button is pressed in the phone will go to 3 colour screen every time it is turned on.
It won't do any harm if you try to press/move that button to see if u can "unstick" it, not likely I think but u never know...
Hello guys, I hope you can help me.... In the middle of a ROM update my (!#@#[email protected]#) PC rebooted.... (while in the white screen on my Qtek 9100) Now the only thing it will come up with is the colored screen saying: IPL 2.21.0001,SPL 2.21.0lip and the USB is on. Active sync isn't able to connect to my device so now what?? Is it bricked?
Hope sombody can help me.... the colored screen means something's still working isn't it?
thanx in advange,
NEVSKI
what update were you trying to install? WM5? WM6? Official or cooked?
What windows xp/Vista are you using?
How far had the update gone
Have you tried running the update again,just tick the i have an active sync connection ,even though you dont and see if it will update? While in the bootloader screen the coloured screen. Hopefully it will do it for you
NEVSKI said:
Hello guys, I hope you can help me.... In the middle of a ROM update my (!#@#[email protected]#) PC rebooted.... (while in the white screen on my Qtek 9100) Now the only thing it will come up with is the colored screen saying: IPL 2.21.0001,SPL 2.21.0lip and the USB is on. Active sync isn't able to connect to my device so now what?? Is it bricked?
Hope sombody can help me.... the colored screen means something's still working isn't it?
thanx in advange,
NEVSKI
Click to expand...
Click to collapse
Its a bad flash as your PC crashed,the update did not finish and you don't have a working OS on your device.As long as you are getting into Bootloaders (multicolored screen) the phone is working,it's definitely not 'Bricked'.,but bad flash might have corrupted the bootloaders (IPL/SPL) on your phone.
Therefore to recover it back to it's default status,download the official carrier's Rom from it's website and flash it in bootloader mode(multicolored).You don't need to establish Activesync connection as Activesync will not work in bootloaders.Just get the phone in bootloaders ,connect your phone with the pc via usb cable,check usb appear at the bottom of the bootloader screen in the phone and run the Ruu in the rom,let it finish and reboot,hope it'll recover to it's default working status and than do what ever you want to do.
Good luck
still a No Go......
well, I still got the 3 (with the white 4) colored screen saying: RUU, IPL 2.21.0001, SPL 2.21.0lip and USB in the white...... I tried a RUU but that didn't work. I had this phone flashed with WM 6 DUTCH and it worked like a baby untill I tried to SIM unlock it... doing that the PC crashed.... Explain please how to get the right ROM and maybe some more info on how to do it after I got the ROM downloaded.... I want my Qtek so bad....
NEVSKI
Yeeeeeeehaaaaaaa!!!!!!! I got it 'up 'n running'....
NEVSKI
igot the same problem
it comes up with the 3 colourd screen usb at the bottem in the white when i put usb cable in but wont connect to active sync i dont no whare to get the 02 rom from can any on help please
hey guys this is what is happening to me:
i turn on the universal, the boot screen shows, and before getting to desktop a blank screen is showing and stuck there, but u can still see the flashing green light of the GSM is working, i tried everything, i did hardrest and nothing happens, i changed the rom version and the radio version, still nothing happens too, same problem, please help
Hi to all ,
I have the msn account:[email protected] .Once again,just to make the resume of the whole story if I remember well:The trinity was with the initial sfr 300+ software(wm5);I installed the oli1.20 flashed it with some other ROM software,did not like it and returned to the original one.Then I tried to flash it with the ROM software where all went wrong...After 1 % the screen went blank and all I can do with the device is to put it into the boot-loader mode where it says:
TRIN100
IPL-0.50
TRIN100
SPL-1.07.0000
When I extracted the file,I discovered that it has 2 nbh-files.I think that is the reason of my defete.Afterwords I have tried all sorts of the first aid solutions : splxploit-windows cannot connect to the device;it says that there is no WCEUS-file and therefore it cannot continue.I have tried to re-flash it through the sd-card:I re-formatted the card on fat32,without any name,put the original ROM and tried to let it boot that way.No success,it marks:loading ... and after 3-4 secs it returns into the boot-loader mode with the same message mentioned above ...
Salutations frm Luxembourg , Goran Stevanovic.
Thx all of ya , problem solved.
sir me too have same probelems, but ma 2 htc trinity dnt stuck at bootloaders, its to to operator logo and stuck there, i have 2 phones with this probelem.
please help me to solve this probelem sir.
gurnek said:
sir me too have same probelems, but ma 2 htc trinity dnt stuck at bootloaders, its to to operator logo and stuck there, i have 2 phones with this probelem.
please help me to solve this probelem sir.
Click to expand...
Click to collapse
1: Boot into BL (camera + power + reset hole)
2: Download the GPS enabled ROM from HTC Support, NOT from a rapidshare/megaupload/4shared etc.. mirror.
3. Flash the ROM, but use the hardspl flasher.(For some reason, it doesn't go error 270 if I use this flasher).
4. Hard Reset again.
Hello,
I have a HTC P3600 and after i make a hard reset the screen goes all black, i already try flash the phone but don't result.
If i try to make a hard reset again the screen shows "press ok to make hard reset" after that goes black again.and its completing %100 but when i want restart its still doesnt work just black screen. just working light =(
So i think not display problem.
Any solution? help me plss
Any chance of sharing the solution, guys, my SPV M700 has similar problems. I tried to flash it with the TRIN-SSPL rom, but it kept saying I need a newer version of the update software.
Now all I have is it gets stuck on the green Windows load up screen and when I reset (Camera-PWR Button-Reset) it goes onto the bootloader tri-color screen, similar to what Goranchen had on his. What do I do now, I would really like to use the phone on another network, and I have looked after it really well, I think, so would be a shame to throw it away. Please help!!
Im new in this i never Upgrade My Pocket pc yet first time i gonna do
I downloaded this RUU_Pharos_DOPODASIA_WWE_1.11.707.1_4.1.13.59_03.15.90_BLUE_Ship.exe
connect my phone with Active Sync Open RUU click next>Next>next then its start Loading my phone screen bcom color like Red blue write something IPL at the top RUU and at Bottom USB ok now when the loading start suddenly Active sync Disconect and exits automaticly then after few second RUU setup stop and say Cant find Device i tried many time still this Happen what should i do???
i have the same proplem mine stand at RGB and desconnect any one have a solution for this problem thanks in advance
salahe said:
i have the same proplem mine stand at RGB and desconnect any one have a solution for this problem thanks in advance
Click to expand...
Click to collapse
try to reconnect to the computer and reinstal with appropriate ROM for the device ! The official ROM for the HTC Prophet can you find at http://www.shipped-roms.com/index.php?category=windows%20mobile&model=Prophet