SPV M3100 Freezed at Windows Mobile logo - 8525, TyTN, MDA Vario II, JasJam General

Hello All
I have One SPV M3100 Here When power up it just Stays at Windows Mobile Screen cannot go further....Person says he tried to unlock at home using the Unlocked Radio (HTC HERMES RADIO FOR SIMLOCK V1.16.00.69)....
What to do now to repair it back ..???
Kindly reply Urgent help needed....
I tried to flash that unlocked radio again it stops at 39% all the time.....i tried 3 times but same.....

Not sure if it would work but have you tried a hard reset?

If that doesn't help see the Wiki it will tell you how to repair this type of brick. If it is in fact a brick

Related

My SVP M600 phone got stuck at Starting screen

Hi Friends,
My new mobile phone SPV M600 got stuck whil starting showing four lines of messages as shown below.
IPL 2.10.0001
SPL 2.10.0001
GSM 02.07.20
OS 2.10.1.22
Can any one please help me in geting my phone to today's screen.
I also attached the screen shot for reference.
did you try a hard reset ?
Ya I tried both hard as well as soft reset but same screen is stuck again and agian.Can any one please help me in this regard as I am very new to PDA family.
Ok, first things first:
Since you are new to this, are you sure you preformed a hard reset?
It is done by holding power + camera + comm manager buttons (one on the right, two on the left) and pressing with stylus in the reset hole at the same time.
A message should appear asking you to press 'send' (green phone button) to confirm reset.
If this does not help, you may have a serious problem.
Please answer the following:
Is the device fully charged?
Phone will fail to boot if the battery is too low.
Did you install any software right before this happened?
This should have been resolved by hard reset, but just in case I am asking.
Did you change the ROM, attempted CID / SIM unlock?
This could require more serious measures than I can advise on.
I did exactly the same thing which you mentioned.But even then it is stuck at the same screen.
Ya u r right I unlocked my mobile using a software from eBay.The unlock was successfull and I tried to insert T-Mobile sim, it also captured the signal and I was able to make and recieve calls then after that I wantedly switched off the phone and then tried to start it, there got the problem.
Can any one help me in this regard please.
I am having the same problem, but my phone is not sim-locked.
I've got the same problem after attempting smart1_wm6_pp8mb.exe
I'm having the same problem with my G4 QTEK S200:
Attempted to upgrade to WM6 Rom using smart1_wm6_pp8mb.exe
After reboot the phone got stuck at the QTEK Screen
Tried Hard Reset (Camera+Power+Comm+Reset) followed the steps with the same results (bricked)
I also tried re-flashing the rom back to the factory one using RUU_Prophet_220734_2207114_024721_QtekWWE_Ship and ROMUpdateUtility-NoVendorID.exe in Windows Vista with WMDC (Windows Mobile Device Center v. 6.0.6873) and the phone in boot loader mode (tri color screen) with working USB cable, with windows firewall disabled and symantec AV disabled as well, RUU keeps saying error 260 "the update utilitiy cannot connect to your pda phone..." .
Do you think I should try this process using XP instead? No matter what i try i keep getting the error 260
Any help would be greatly appreciated
Got it fixed!
it was definately a Vista issue. once i tried it in XP with ActiveSync it worked like a charm and i got my phone back up and running. also used spb backup and restored all my settings.
ipl/spl screen
i got the same problem with new rom wm6, and the 260 eror, my problem is that i have xp and the activesync does`t connect ...
... means i cant redo the original rom ????
PLEAAASEEE HELPPPP !!
Again My phone SPV M600 got stuck at IPL/SPL screen
Please Can some one advice me how to get my phone back.
I raised the same issue 7 months back after that my phone got recovered automatically and there were no issues till last month. Last month onwards it is again got the same problem and now it is permenantly stuck at that screen what ever you do.
yekanth said:
Please Can some one advice me how to get my phone back.
I raised the same issue 7 months back after that my phone got recovered automatically and there were no issues till last month. Last month onwards it is again got the same problem and now it is permenantly stuck at that screen what ever you do.
Click to expand...
Click to collapse
A rom reinstall on xp solved my problems on that one. retry a couple of times! It may not work the first time! hard reset as well...
Try an official wm5 rom just in case
good luck
Can you please gimme step by step procedure
HI Phil,
I am new to these kind of installations . CAn you please Gimme step by step procedure for ROM installation.
mine is now also stuck, after trying to install new rom. wont connect to active sync either, have i fooked it? tried hard reset etc.
thanks
(with a turned off phone, press and hold camera button then insert USB cable)
then flash provider ROM
RECOVERING FROM ERROR IN STEP 8 WM5->WM6
1. Don't panic
2. Don't panic
3. Unplug the phone
4. Reset with stylus,and keep the Camera Button pressed.
5. A 3 color screen will appear(Bootloader Screen)
6. Connect your device with your PC,and run the NVID(no vendor) WM5 rom.
7. The device will be resetted after RUU(rom update utility)finishes
8. Repeat the WM6 upgrade,from STEP 5..
Click to expand...
Click to collapse
from here http://forum.xda-developers.com/showthread.php?t=310452
hi jay
i seen your post in n00b guys one, i fixed it!!!!, thank you so much, i couldnt remember how to get it to those 3 colours.
thanks again
Colin
Hi Iam unable to get the NVID ROM
Hi,
I am unable to get the NVID ROM. The Rapidshare link that has been provided in the other thread is not working. Can some one tell where can i get the ROM.
collywog19 said:
i seen your post ...
Click to expand...
Click to collapse
no problem mate.
..and yekanth i see what u mean about the dead links. i have the files on my computer at home but i'm posting from my prophet right now, so i can't upload. Try using the "pdaviet temp" from one of the wm6 threads?
(http://rapidshare.com/files/54265407/Prophet_PV_Temp.zip)
Hi Iam able to update the Rom but no use
Hi,
To mention my phone is from orange-UK. I got the orange rom from our FTP site and did the flashing/update what ever you say.But still it is getting stuck at the same IPL/SPL screen. Iam very much worried that I will not get a proper solution for my problem.It will be very grate full if some one resolve my problem.
just seems strange...how did you fix it last time? did it just start working again? A random guess would be that the camera button got liquid spilled on it or is stuck in.
If the camera button is pressed in the phone will go to 3 colour screen every time it is turned on.
It won't do any harm if you try to press/move that button to see if u can "unstick" it, not likely I think but u never know...

I have One SPV M3100 Here When power up it just Stays at Windows Mobile Screen

I have One SPV M3100 Here When power up it just Stays at Windows Mobile Screen .i dont know what i do?what is the hard reset.i dont know.how to do?i am new.
You should flash yr device wth official rom or send it back to the service center can you enter the bootloader 3color screen power+ok+reset? if yes is good you can flash yr device.

Spv M700 Help Please

hello .my SPV M700 is frozen on Orange startup..i tried to unlock the my M700 spv with HTC_Trinity_SIM_CID_Unlock_v1
but when i tried to romupgrade it went to 7%...
i tried several times but sometimes goes to 1% or 7% then the programme turns off saying you have corrupt file...but i downloaded several other files still the same thing.
my SPV M700 turns on to orange statup then it freezes there until i take the battery off.
now is there someone who can help me please ??
zakovb said:
hello .my SPV M700 is frozen on Orange startup..i tried to unlock the my M700 spv with HTC_Trinity_SIM_CID_Unlock_v1
but when i tried to romupgrade it went to 7%...
i tried several times but sometimes goes to 1% or 7% then the programme turns off saying you have corrupt file...but i downloaded several other files still the same thing.
my SPV M700 turns on to orange statup then it freezes there until i take the battery off.
now is there someone who can help me please ??
Click to expand...
Click to collapse
I have a orange spv m700 and the same thing happened to me.
I installed olipo's 1.20 hardspl and then the wm6 rom.
After a few days the phone crashed and hanged on the first splash screen(mine is htc) until I hard reset it.
This happened again after a few days so I changed back to olipro's 1.30 spl and so far so good.
Hope this helps you!
please
thank you for sharing your knowledge..i would be grateful if you could give me a link for the olips hardspl and wm6..
i wounder if you could some notepad for intructions ..i would be so grateful thanks
zakovb said:
thank you for sharing your knowledge..i would be grateful if you could give me a link for the olips hardspl and wm6..
i wounder if you could some notepad for intructions ..i would be so grateful thanks
Click to expand...
Click to collapse
quoting an answer by a fellow on the trinity upgrading forum:
Here, http://www.trinityguides.info/ and here: http://www.trinityguides.info/, and here http://forum.xda-developers.com/forumdisplay.php?f=359
many thanks
i like to say to you many thanks buddy ..i really do appreaciate it...thanks on you your a great forum member
thanks...but it did not work for me...still the same..stuck on orange start up...tired everything...did hard spl wheen i did that it took 7 seconds to flash/programme...then wm6 this went to 1% then the fone switched off and restarted and update said error 270 yes sure.
i had to manually put it tri colour mode....everytime
i repeated the process 20 times still the same result..maybe i have damaged the radio or done something wrong while flashing fone.........
the fone was working until i tried to unlock it with htc trinity unlock...thats when the problem started...
it wont update ...if i flash hardspl any version...it runs and completed in 7 seconds..i don't think that is right.
if there is anyone who can tell me where i am going wrong ...it would be appreciatative..thank you
come on guys ...is theres anyone who can help..
problem solved ...binned the spv m700 ...many thanks to all the forums members

Orange SPV M700 Stuck at boot loader

i have orange SPV M700 pocket pc mobile. i upgrated my mobile to windows 6.1. after that i upgrated my mobile to Windows mobile version 6.1 elegand edition but upgradtion, it stuck at bootloader mode. now i can not upgrate my rom. it stuck at windows mobile 6.1 logo. when i go to hard reset it come to bootloader mode shows " Trin 100
IPL -0.50
Trin 100
SPL-1.07.0000
this is the message i m getting from last two days. i tried to make every step to lad a rom but cant upgrade my mobile. plz help me to make my mobile alive.
there have been may posts similiar to your problem ...
generally speaking the answer seems to be to flash your Rom,
and then when it gets stuck again at bootloader, just check that 'usb' appears at bottom of bootloader screen
then just run the reflash again (without switching off, or unplugging phone)
this usually does work. even if it takes you 2/3 attempts

:( [help] mda vario bootloader keeps shutting down

Hi,
I have a problem with my vario, that i bought this week. It came with Tmobile CZ ROM With IPL SPL 2.21. I followed the tutorial and downgraded by flashing Button ROM. This flashing failed on 99%, so i downloaded XDA Mini S ROM which also failed on 85%... several times.
I think the problem is in bootloader, becouse when i turn Wizard on, Bootloader came on but after a 5 seconds in shuts down I thought that it is a battery problem, so i charged wizard over teh night(it was still in bootloader mode, i cant boot to Win CE :-( )
Today i tryed to flash wizard_love_ROM, I connected wizard to pc via usb, flashing started but after 3 minutes wizard shuted down and repeately rebooted. Flashing ended with error 302... Now I have IPL 1.05 and SPL 2.21
Can any1 help me to get my vario back to business? pls
thx for help,

Categories

Resources