My computer crashed while the updater was updating my ROM. Now my phone freezes on boot and won't get past the splash screen. Is there any way of physically getting into the bootloader??
yes, just hit power, camera and the reset button at the same time and you'll get to the 3 color bootloader screen where you can retry the update.
Good luck!
Related
My HTC was flashed with TNT. It has 2.21.0001 and 2.21.Olip. I can boot it to boot loader. I can reset it, with switch or pulling the battery. Every time it boots showing the versions, then comes to a WM6 boot screen. This is normal. However it never comes out of this screen. The LEDs flash as if it were working, but the phone is unresponsive.
Is there any way to fix this?
Do I need to reset it in some way? If so, how?
i had a same problem with TNE. after it worked fine for a year.
then i changed the rom to a new 1 and fixed all my problems . just upgraded it in bootloader mode.
Same problem. I installed BlackDiamond2.0. At the begginning everything was ok, then Send button wouldn't work till I press the Start button on the querty keyboard.
Just playing, I tried to overlook with an application that came on the package and then it didn't work any longer. It stays at the BlackDiamond picture.
And I cannot make a hard reset since Send button don't work and cannot connect with Active Sync to flash the rom.
Any idieas?
also could be a bad battery. happened with my brothers phone. acted the same way.
our phones are old now. get a replacement 10 bucks.
used gingerbreak on g2. Got superuser and everything was great. Now (don't know why) no splash screen, no recovery even holding down volume and power on boot, random screen blackout. tried to re-gingerbreak with no effect. tried hard reset with no effect. stuck in hell please help. phone is stock rom and has no modifications even has all bloat-ware.
p.s. initial problem upon booting screen black but have lights at bottom after stock boot sound hit power twice and phone is active like normal. now stuck like this after each boot and couldn't find anything about the problem after searching. I hope this hasn't been covered before. Any thoughts? I am at my wits end about to get out the light saber and take out my frustrations on the mutt
If your phone is this: http://www.htc.com/us/products/t-mobile-g2/ then you're in the wrong place.
guys yesterday i started to flash the smartphone because i was fed up with the stock rom, after a bit of advice i opted for the clougy g3! starting by rootting the phone and install a recovery (which, however, could start only by phone on) I installed this rom which at first look is great for customization and style and also for speed.
today after making a backup of data of the phone whit titan backup fails to come into the gallery and do not make me choose the settings how to change the soft keys of the home, in both cases, says it has stopped working or something like that so I decided to do a soft reset by wipe date cache and devil in recovery and reboot the phone that it stops on the lg logo and does not go forward! Now I no longer get into recovery because I cant do that by turned off phone and then I'm stuck at the lg logo and I do not know what to do!
looking on the internet I read that to get into recovery I have to hold the power button + down button longer until you will see lg logo and then release them and push again, but doing so takes me to a wild white screen "hard factory reset" plz help fast
The hard reset screen is correct, it won't actually reset the phone but it will send you into recovery. Get to that screen and press the power button a few times to go through it and it should take you into TWRP
Sent from my LG-VS980 using Tapatalk
hello xda community
i've installed g3 cloudyflex on my g2.. and after wiping cache the device was basically soft bricked (lg logo loop)
now i've tried to get to back original kitkat rom.. everything went fine but then the device got errors "Unfortunately com.android.phone has stopped" and some other gui errors.. the screen is black but you use power/vol buttons for reboot etc
i couldnt get in my device so i tought of a hard reset...
but the psyhical button one doesnt seem to be working for me.. what to do??... not possible to get into rec. mode from pc?
after some time it manages to get to usb screen but it crashes completely and the device shuts down
also i cant get into safe mode as it keeps rebooting until i release power button
---
tldr: How can i fix my g2 if software and back button recovery method isnt working?
So, I unlocked my bootloader, flashed a revolution recovery then I got my phone stuck on that screen. After a lot of tries and countless volume up and down random pressing I got the phone into e-recovery and I got it to work. The phone experienced
a lot of lag issues since then; so I tried a factory reset. The phone after reset had no keyboard but the google voice activated one.
So I relocked my bootloader and decied to try it again .... I unlocked the bootloader, flashed a TWERP recovery, and the phone got stuck again but this time for the life of me I can't get it to open.
It shows Huawei logo for 1 second then the screen that says:
"Your device has been unlocked and can't be trusted.
To learn more, visit:......
Your device is booting now..."
What to do?!
Romio20010 said:
So, I unlocked my bootloader, flashed a revolution recovery then I got my phone stuck on that screen. After a lot of tries and countless volume up and down random pressing I got the phone into e-recovery and I got it to work. The phone experienced
a lot of lag issues since then; so I tried a factory reset. The phone after reset had no keyboard but the google voice activated one.
So I relocked my bootloader and decied to try it again .... I unlocked the bootloader, flashed a TWERP recovery, and the phone got stuck again but this time for the life of me I can't get it to open.
It shows Huawei logo for 1 second then the screen that says:
"Your device has been unlocked and can't be trusted.
To learn more, visit:......
Your device is booting now..."
What to do?!
Click to expand...
Click to collapse
How? Can u fix it?