I have a 2GB SD card with lots of free space so I was surprised when WM5 said that all my space was in use.
Inserted card into PC to investigate further & Windows said that I had 733MB free, but Windows ignored my request to eject card.
Put card back into my Jasjar & it now shows 733MB free.
Does anyone know where the space went to, if so should I be worried.
Mike
Hi All,
Just wondering if anyone else is getting intermittent issues w/ their mini-SD card.
I've lost essentially all my data on my 2GB Sandisk on three separate occasions. I have formatted different ways (once w/ RescoExp, and then FAT32 on 2 computers), been v. careful closing my apps and minimizing the amount of writing to the card.
Does anyone have any suggestions?
Sandisk's comments are as follows:
"This is a known issue with the devices when they work this way with 2GB and up memory cards. Usually in this cases you just need to contact the manufacturer of the device that you having issues with the reading on, to find out about compatability and what kind of firmware update do you need."
Thanks!
I haven't had any issues with my SanDisk 2gb card using my K-JAM.
Now on other pdas and with other cards, I have had the "lose everything" problem. Two reasons I had...storing email attachments on the and having the unit crash while accessing the card.
My onyl problem with the larger card is my laptop doesn't recognize it
I lost all of my data just last week off of my card, I went ahead ahd reformatted it again, not sure whats wrong with the 2gb cards
m2nal said:
I lost all of my data just last week off of my card, I went ahead ahd reformatted it again, not sure whats wrong with the 2gb cards
Click to expand...
Click to collapse
I haven't had a single issue with my 2GB TOPRAM card. I have had a few issues where the device doesn't see it (I assume) and renames the folder to Storage Card 2 and creates a new folder "STorage Card" with nothing there. It happens rarely and when it does, I just take the card out, rename the bad folder to StorageCardOld then insert the card again. This corrects the issue. I use the card very heavily and have had it since around the end of January.
I too have had this problem. I hope my suggestion helps.
I've had issues in the past with Sandisk flash cards. My problems were the same as yours until some helpful spark suggested I do a disk error check using windows (right click on drive in explorer>properties>Tools>Error Checking). Format the card and then run the disk check, apparently some Sandisk flash cards exhibit not so rare sector problems. His explanation (the science bit of which I have long since forgotten) was that that by running the disk check, the utility automatically marks the error causing sectors as unusable. The disk can then be used as normal after that, but any reformatting should have the disk check run again to mark the sectors once more.
This has helped me in 2 out of three occasions and so may or may not work for you. Still, I hope this solves your problem.
BS answer from Sandisk
Leighj, that's a BS answer from Sandisk. I guess it would never occur to them that your SD card is defective. Try another card in your machine or that card in another PDA phone if you have either of those options, but if not contact Sandisk and get a replacement. It should have a lifetime warranty, or at least several years.
Have to agree with iclick. My Sandisk cards were basically defective and how I got them running was a workaround and not a solution.
Yes - I wasn't too happy with their response either. Anyway, I just ran through error checking before & after reformatting. Hopefully that works - if not I'm off to shop for a new card. Either way, it's probably the last Sandisk mem card I purchase.
Thanks for your comments!
I have a Sandisk 2Gb Mini-SD as well and I've not had any issues with it so far. If it helps, I've left the card in the factory default format of FAT only - not FAT32. Try putting yours back to FAT and see if you still get any issues. Depending on what program you use the option you want might be labelled as FAT16 instead of just FAT.
I have Sandisk Ultra 2G miniSD, I don't have any problems untill recently. Whenever I try to add my storage capacity to more than 60%, 1GB or more, it gave me an error because the file is write protected and then not responding file transfer.
First, I taught my file is broken, but when I removed other files from the mini SD card and then add it ..... it's work. I used a factory Format type. Do anyone have this problems :?:
Well after contacted Sandisk customer services regarding my memory. They asked me to reformat my card and I did that. through my laptop, but it said that windows cannot complete the format. Now the card is dead. :twisted:
Do the mini sd cards have a lock?
Do these cards have a lock on them? My old SD cards had a slider but I don't see one on the sandisk card.
The miniSD doesn't have a lock, but the miniSD-to-SD adapter does have a slider just like a real SD.
if i take my sd out for any reason it will often take a few goes to get it recognised by the mini s again. I have to remove/insert it as many as 10 times.
Ok, so i bought a miniSD card for my Cingular 8125. Its a 2gb card. At first it was having problems reading things from it via the phone so i used the WM5torage application to format it and now its only reading as a 1gb card. WTH? what can i do to format this card again and get my lost gig back?
it just splits it to two cards (i.e c: and d: on the pc). you can switch them with the wm5torage...
I have been reading the forums about the memory card needing to be class 6 if you wish to do apps2sd.
How can I check what the actual class mine is.
The standard 2gb that came with phone just says, MicroSD
But T-Mobile also gave me a free 8gb card, this has a 2 after the word sandisk and then near bottom edge says SDHC.
On testing transfering a file from vista 64 pc to phone, it transferred at around 3.80mb ps, which would suggest class 4, but as everyone knows transfering files via vista is slow anyway.
So should I treat this as a class 4 card?
thanks
Try reading this.
thanks but browsing an onliner retailer gave me the answer
the card is class 2
i am now on my fourth 8Gig micro card this on is trancend and the other three are sandisk i was using the phone this morning fine i have just gone to use it again less than an hour later and it wants me to format i have checkd the card in the phone settings and it says no sd card installed any ideas as i am getting narked off with paying out for new cards every few months
I am having a similar problem. I am on my second card and I have had random photo's corrupt then disappear. ??? I don't know why. Any Ideas?
I use a Duracell card and have never had any problems, did you format the cards before first use ? ... have you tried to format the cards that are not reading.
I work with sd cards all day loading o/s and apps to industrial tocuhscreens and it's very rare to get a totally trashed card.
snarf1974 said:
I use a Duracell card and have never had any problems, did you format the cards before first use ? ... have you tried to format the cards that are not reading.
I work with sd cards all day loading o/s and apps to industrial tocuhscreens and it's very rare to get a totally trashed card.
Click to expand...
Click to collapse
i did format the card first time and it showed 8 gig now when i format i ge 36 meg
pooloop said:
i did format the card first time and it showed 8 gig now when i format i ge 36 meg
Click to expand...
Click to collapse
did you format them in the hd2 or using a pc/card reader ?
snarf1974 said:
did you format them in the hd2 or using a pc/card reader ?
Click to expand...
Click to collapse
i formatted it on the hd2 and it still shows no sd card when i put it in a card reader it shows 36meg
have you tried to format it using the card reader in your pc ?
if that works then you could insert it back into the hd2 and try to use the htc format software again.